Rates of cave and landform development in the Yorkshire Dales from speleothem age data

Uranium-series ages have been obtained for 87 speleothems collected from nine major cave systems in the Craven district of northern England. Large systems such as Ease Gill Caverns, the West Kingsdale caves, and Gaping Gill-Ingleborough Cave, which contain relict high-level tunnels, are found to be older than 350,000 years (the limit of the ²³⁰Th/²³⁴U dating method). There is little evidence to indicate a significant enlargement of these passages since this time. Estimates of the age of Victoria Cave from ²³⁴U/²³⁸U isotopic ratios suggest that the cave has been fully relict for more than 500,000 years. Ages of in situ speleothems immediately adjacent to local base level cave streams show that mean maximum downcutting rates in limestone channels are about 2 to 5 cm 1000 yr. These rates are significantly lower than those obtained from direct measurements on limestone bedrock in stream channels but are comparable to areal denudation rates based on solute budgets. Using the present elevation of caves with respect to adjacent valley floor levels, mean maximum valley entrenchment rates are found to range between 5 cm/ky and < 20cm/ky, which corresponds to 6 m to < 24 m of lowering per glacial/interglacial cycle. These rates suggest that upper beds of the limestone were incised to form the Yorkshire Dales between 1 and 2 million years ago. The results indicate that the erosional effects of individual glaciations are not as severe as previously proposed in the literature.     

Inhibitability of soil loss and sediment concentration during consecutive rainfalls from experimental plots treated by endemic microorganisms

Consecutive rainfalls, due to changes in antecedent moisture, alter soil erosion processes, necessitating the implementation of suitable soil loss control methods. Biological soil microorganism approaches have been applied to control soil loss. However, information on the involvement of microorganisms in the soil loss and rill erosion processes has yet to be supplied. In this study, the individual and combined inoculation of cyanobacteria and bacteria was investigated during five consecutive rai...     

How to obtain alert velocity thresholds for large rockslides

A reliable forecast of the failure stage of large rockslides is difficult, because of non-linear time dependency of displacements and seasonal effects. Aim of this paper is to suggest a practical method to prepare alert thresholds for large rockslides, assessing critical values of velocity for carrying out civil protection actions using monitoring data. Adopted data concern the 20 Mm³ Ruinon rockslide (Valfurva, Central Alps, Italy), still evolving and suitable to originate a fast moving rock avalanche. Multitemporal analysis of aerial photos, LIDAR-ALTM laser topography, field survey and geomechanical analyses allowed to infer the rockslide kinematics and better understand data provided by a monitoring network including distometers, extensometers, GPS benchmarks and inclinometers. The analysis of displacement and rainfall data over five years (1997–2001) allowed to recognise three different evolutionary patterns of displacements, showing a continuously increasing rate since 1997. Data representing large-scale behaviour of the rock mass were fitted by power-law curves, according to the “accelerating creep” model by Voight, in order to evaluate a suitable failure time. This was hampered by the large seasonal deviations, which can significantly delay the occurrence of failure. Data were fitted using the Voight’s equation, expressed in terms of displacement, through non-linear estimation techniques, in order to find values of the controlling parameters (A, α and t_f) suitable to represent the mechanical behaviour of the rock mass approaching the failure. This allowed to compute velocity–time theoretical curves and to define different velocity threshold values (pre-alert, alert and emergency) to be used for emergency management.     

The importance of plant root characteristics in controlling concentrated flow erosion rates

While it has been demonstrated in numerous studies that the aboveground characteristics of the vegetation are of particular importance with respect to soil erosion control, this study argues the importance of separating the influence of vegetation on soil erosion rates into two parts: the impact of leaves and stems (aboveground biomass) and the influence of roots (belowground biomass). Although both plant parameters form inseparable constituents of the total plant organism, most studies attribute the impact of vegetation on soil erosion rates mainly to the characteristics of the aboveground biomass. This triggers the question whether the belowground biomass is of no or negligible importance with respect to soil erosion by concentrated flow. This study tried to answer this question by comparing cross‐sectional areas of concentrated flow channels (rills and ephemeral gullies) in the Belgian Loess Belt for different cereal and grass plant densities. The results of these measurements highlighted the fact that both an increase in shoot density as well as an increase in root density resulted in an exponential decrease of concentrated flow erosion rates. Since protection of the soil surface in the early plant growth stages is crucial with respect to the reduction of water erosion rates, increasing the plant root density in the topsoil could be a viable erosion control strategy. Copyright © 2003 John Wiley & Sons, Ltd.     

Estimating overland flow erosion capacity using unit stream power

Soil erosion caused by water flow is a complex problem. Both empirical and physically based approaches were used for the estimation of surface erosion rates. Their applications are mainly limited to experimental areas or laboratory studies. The maximum sediment concentration overland flow can carry is not considered in most of the existing surface erosion models. The lack of erosion capacity limitation may cause over estimations of sediment concentration. A correlation analysis is used in this study to determine significant factors that impact surface erosion capacity. The result shows that the unit stream power is the most dominant factor for overland flow erosion which is consistent with experimental data. A bounded regression formula is used to reflect the limits that sediment concentration cannot be less than zero nor greater than a maximum value. The coefficients used in the model are calibrated using published laboratory data. The computed results agree with laboratory data very well. A one dimensional overland flow diffusive wave model is used in conjunction with the developed soil erosion equation to simulate field experimental results. This study concludes that the non-linear regression method using unit stream power as the dominant factor performs well for estimating overland flow erosion capacity.     

A modified Raupach's model applicable for shear-stress partitioning on surfaces covered with dense and flat-shaped gravel roughness elements

A commonly used measure to prevent soil wind erosion is to cover the surface with gravel. Gravel can inhibit soil erosion by covering the surface directly, changing the airflow field near the surface and sharing the shear stress of wind. Similar to other roughness elements, the protective effect of gravel on soil is usually expressed in terms of the ratio of the shear stress on the exposed soil surface to the total shear stress on the rough surface due to wind, i.e. through a shear-stress partitioning model. However, the existing shear-stress partitioning models, represented by Raupach's model (RM93), are only applicable when the lateral coverage of the roughness elements, λ < 0.10, and the applicability of the models to flat-shaped roughness elements is unclear. The purpose of this study is to verify the applicability of RM93 for dense and flat-shaped gravel roughness elements by using shear-stress data from wind-tunnel measurements pertaining to roughness elements with different densities (0.013 ≤ λ ≤ 0.318) and flat shapes (height-to-width ratios in the range 0.20 ≤ H/W ≤ 0.63), and to modify RM93 to enhance its predictive ability. The results indicate that RM93 cannot accurately predict the shear-stress partitioning for surfaces covered by densely distributed and flat-shaped gravel roughness elements. This phenomenon occurs because, when roughness elements are distributed densely or are flat-shaped, the proportion of the shear stress on the top surface of the roughness elements (τ_c) to the total shear stress (τ) is large; in this case, τ_c plays a dominant role and serves as an essential component in the shear-stress partitioning model. Consequently, RM93 is modified by incorporating τ_c into the calculation of τ. Under conditions of λ < 0.32 and H/W > 0.2, the modified RM93 can yield satisfactory predictions regarding the shear-stress partitioning.     

Effect of subsurface water level on gully headcut retreat in tropical highlands of Ethiopia

Gully erosion is a major cause of soil loss and severe land degradation in sub-humid Ethiopia. The objective of this study was to investigate the role and the effect of subsurface water level change on gully headcut retreat, gully formation and expansion in high rainfall tropical regions in the Ethiopian highlands. During the rainy seasons of 2017–2019, the expansion rate of 16 fixed gullies was measured and subsurface water levels were measured by piezometers installed near gully heads. During the study period, headcut retreats ranged from 0.70 to 2.35 m, with a mean value of 1.49 ± 0.56 m year⁻¹, and average depth of the surface water level varied between 1.12 and 2.82 m, with a mean value of 2.62 m. Gully cross-section areas ranged from 2.90 to 20.90 m², with an average of 9.31 ± 4.80 m². Volumetric retreat of gully headcuts ranged from 4.49 to 40.55 m³ and averaged 13.34 ± 9.10 m³. Soil loss from individual gullies ranged from 5.79 to 52.31 t year⁻¹ and averaged 17.21 ± 11.74 t year⁻¹. The headcut retreat rate and sediment yield were closely related over the three study seasons. Elevated subsurface water levels facilitated the slumping of gully banks and heads, causing high sediment yield. When the soil was saturated, bank collapse and headcut retreat were favoured by the combination of elevated subsurface water and high rainfall. This study indicates that area exclosures are effective in controlling subsurface water level, thus reducing gully headcut retreat and associated soil loss.     

Model prediction capacity of ephemeral gully evolution in conservation tillage systems

Ephemeral gully (EG) erosion has an important impact on agricultural soil losses and increases field surface hydrology connectivity and transport of pollutants to nearby water bodies. Watershed models including an EG component are scarce and not yet properly evaluated. The objective of this study is to evaluate the capacity of one such tool, AnnAGNPS, to simulate the evolution of two EG formed in a conservation tillage system. The dataset for model testing included runoff measurements and EG morphological characteristics during 3 years. Model evaluation focused on EG evolution of volume, width, and length model outputs, and included calibration and testing phases and a global sensitivity analysis (GSA). While the model did not fully reproduce width and length, the model efficiency to simulate EG volume was satisfactory for both calibration and testing phases, supporting the watershed management objectives of the model. GSA revealed that the most sensitive factors were EG depth, critical shear stress, headcut detachment exponent coefficient b, and headcut detachment leading coefficient a. For EG outputs the model was additive, showing low sensitivity to interactions between the inputs. Prediction of EG spatial evolution on conservation tillage systems requires improved development of gully erosion components, since many of the processes were developed originally for traditional tillage practices or larger channel systems. Our results identify the need for future research when EG form within conservation tillage systems, in particular to study gully headcut, soil erodibility, and width functions specific to these practices.     

Influence of thawed soil depth on rainfall erosion of frozen bare meadow soil in the Qinghai–Tibet Plateau

The Qinghai–Tibet Plateau has a vast area of approximately 70×10⁴ km² of alpine meadow under the impacts of soil freezing and thawing, thereby inducing intensive water erosion. Quantifying the rainfall erosion process of partially thawed soil provides the basis for model simulation of soil erosion on cold-region hillslopes. In this study, we conducted a laboratory experiment on rainfall-induced erosion of partially thawed soil slope under four slope gradients (5, 10, 15, and 20°), three rainfall intensities (30, 60, and 90 mm h⁻¹), and three thawed soil depths (1, 2, and 10 cm). The results indicated that shallow thawed soil depth aggravated soil erosion of partially thawed soil slopes under low hydrodynamic conditions (rainfall intensity of 30 mm h⁻¹ and slope gradient ≤ 15°), whereas it inhibited erosion under high hydrodynamic conditions (rainfall intensity ≥ 60 mm h⁻¹ or slope gradient > 15°). Soil erosion was controlled by the thawed soil depth and runoff hydrodynamic conditions. When the sediment supply was sufficient, the shallow thawed soil depth had a higher erosion potential and a larger sediment concentration. On the contrary, when the sediment supply was insufficient, the shallow thawed soil depth resulted in lower sediment erosion and a smaller sediment concentration. The hydrodynamic runoff conditions determined whether the sediment supply was sufficient. We propose a model to predict sediment delivery under different slope gradients, rainfall intensities, and thawed soil depths. The model, with a Nash–Sutcliffe efficiency of 0.95, accurately predicted the sediment delivery under different conditions, which was helpful for quantification of the complex feedback of sediment delivery to the factors influencing rainfall erosion of partially thawed soil. This study provides valuable insights into the rainfall erosion mechanism of partially thawed soil slopes in the Qinghai–Tibet Plateau and provides a basis for further studies on soil erosion under different hydrodynamic conditions.     

Soil erosion and sediment transport in Tanzania: Part I – sediment source tracing in three neighbouring river catchments

Water bodies in Tanzania are experiencing increased siltation, which is threatening water quality, ecosystem health, and livelihood security in the region. This phenomenon is caused by increasing rates of upstream soil erosion and downstream sediment transport. However, a lack of knowledge on the contributions from different catchment zones, land-use types, and dominant erosion processes, to the transported sediment is undermining the mitigation of soil degradation at the source of the problem. In this context, complementary sediment source tracing techniques were applied in three Tanzanian river systems to further the understanding of the complex dynamics of soil erosion and sediment transport in the region. Analysis of the geochemical and biochemical fingerprints revealed a highly complex and variable soil system that could be grouped in distinct classes. These soil classes were unmixed against riverine sediment fingerprints using the Bayesian MixSIAR model, yielding proportionate source contributions for each catchment. This sediment source tracing indicated that hillslope erosion on the open rangelands and maize croplands in the mid-zone contributed over 75% of the transported sediment load in all three river systems during the sampling time-period. By integrating geochemical and biochemical fingerprints in sediment source tracing techniques, this study demonstrated links between land use, soil erosion and downstream sediment transport in Tanzania. This evidence can guide land managers in designing targeted interventions that safeguard both soil health and water quality.