关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

常压法合成Methomyl的研究

提出一种合成Methomyl的改良法。该方法的特点是反应可在常压下进行。对常压反应的优宜条件作了系统研究,并讨论了反应机理。     

辽东湾S2冰侧限剪切强度的试验研究

利用试验方法系统地研究了辽东湾S2型海冰侧限剪切强度随剪切应变速率、加载方向、法向应力、温度和冰内孔隙率的变化规律。介绍了S2型海冰各向异性特点及剪切应变速率对剪切破坏方式的效应和韧脆破坏转变的条件。分析了不同加载方向海冰峰值剪切强度的差异 ,获得 - 6 2℃温度下S2冰内摩擦角和内聚力分别为 42°和 70 0kPa。利用统计分析给出峰值剪切强度与冰温和孔隙率的试验关系     

Analytic Solution of Interaction Between Surface Waves and Floating Elastic Plates with Elastic End-Restraints

Based on the dynamic theories of water waves and Mindlin plates,the analytic solution of interaction between surface waves and two-dimensional floating elastic plates with edge-restraint is constructed by use of the Wiener-Hopf technique.Firstly,without regard for elastic edge restraint,the wave-induced responses of elastic floating plate analyzed by the present method are in good agreement with the results from literature and experimental results.Therefore,it can be shown that the present method is valid.Secondly,three end-restraint cases(i.e.,the left-end elastic restraints,the both-end elastic restraints,and the right-end elastic restraints)are proposed to reduce the vibration of floating plates,in which the spring is used to connect the sea bottom and the floating plate's left(or right)edge.The relations between the spring stiffness and the parameters of wave-induced responses of floating plates are discussed.Moreover,the effective method to reduce the vibration of floating elastic plates can be obtained through comparison.     

Tectonics of a fast spreading center: A Deep-Tow and sea beam survey on the East Pacific rise at 19°30′ S

Sea Beam and Deep-Tow were used in a tectonic investigation of the fast-spreading (151 mm yr^-1) East Pacific Rise (EPR) at 19°30 S. Detailed surveys were conducted at the EPR axis and at the Brunhes/Matuyama magnetic reversal boundary, while four long traverses (the longest 96 km) surveyed the rise flanks. Faulting accounts for the vast majority of the relief. Both inward and outward facing fault scarps appear in almost equal numbers, and they form the horsts and grabens which compose the abyssal hills. This mechanism for abyssal hill formation differs from that observed at slow and intermediate spreading rates where abyssal hills are formed by back-tilted inward facing normal faults or by volcanic bow-forms. At 19°30 S, systematic back tilting of fault blocks is not observed, and volcanic constructional relief is a short wavelength signal (less than a few hundred meters) superimposed upon the dominant faulted structure (wavelength 2–8 km). Active faulting is confined to within approximately 5–8 km of the rise axis. In terms of frequency, more faulting occurs at fast spreading rates than at slow. The half extension rate due to faulting is 4.1 mm yr^-1 at 19°30 S versus 1.6 mm yr^-1 in the FAMOUS area on the Mid-Atlantic Ridge (MAR). Both spreading and horizontal extension are asymmetric at 19°30 S, and both are greater on the east flank of the rise axis. The fault density observed at 19°30 S is not constant, and zones with very high fault density follow zones with very little faulting. Three mechanisms are proposed which might account for these observations. In the first, faults are buried episodically by massive eruptions which flow more than 5–8 km from the spreading axis, beyond the outer boundary of the active fault zone. This is the least favored mechanism as there is no evidence that lavas which flow that far off axis are sufficiently thick to bury 50–150 m high fault scarps. In the second mechanism, the rate of faulting is reduced during major episodes of volcanism due to changes in the near axis thermal structure associated with swelling of the axial magma chamber. Thus the variation in fault spacing is caused by alternate episodes of faulting and volcanism. In the third mechanism, the rate of faulting may be constant (down to a time scale of decades), but the locus of faulting shifts relative to the axis. A master fault forms near the axis and takes up most of the strain release until the fault or fault set is transported into lithosphere which is sufficiently thick so that the faults become locked. At this point, the locus of faulting shifts to the thinnest, weakest lithosphere near the axis, and the cycle repeats.     

Internal wave eigenmodes and their weak nonlinear resonant interaction in a nonlinearly stratified fluid—A preliminary theoretical and experimental study

A preliminary theoretical and experimental study was conducted on internal wave modes and their weak nonlinear resonant interaction in a nonlinearly stratified fluid. An asymptotical solution of the modes and a dispersion relation of internal waves in a stratified fluid with density profile similar to that in our experiment were obtained theoretically. The resonant-interaction mechanism to 2nd order approximation is also discussed. The resonant interaction of the 3rd and 4th mode internal waves excited by the unstable 1st mode wave is analyzed on the basis of data obtained by conductivity probes. The resonant-interaction condition, i.e., ,k ₁+k ₃+k ₄=0, is examined. It is shown that the resonant instability increases with pycnocline thickness and wave maker driving frequency. This work is supported by the National Natural Science Foundation of China.     

BP神经网络在局部似大地水准面精化的应用

针对高程拟合中的模型误差问题,采用BP神经网络方法进行拟合,可以减小模型误差,提高似大地水准面的精化精度。在焦作市局部似大地水准面精化算例中,BP神经网络高程拟合取得了良好的效果。     

Simulation experiment on hydrocarbon generating potential of various source rocks on the northern margin of the Qaidam Basin,Qinghai, China

The northern margin of the Qaidam Basin is one of the main oil-gas exploration areas in western China, where source rocks are composed mostly of Middle and Lower Jurassic dark mud shale, carbargillite and coal. A large number of subsurface and outcrop samples differing in lithology with different types of organic matter were selected for resource evaluation, research and calculation. And among them, 13 samples were used for simulation experiment on hydrocarbon generating potential of various source rocks. At first, two kinds of heating modes were compared through simulation experiment, including single temperature-step heating and continual heating. Perhaps, the process of hydrocarbon generation and expulsion occurred naturally between a close system and an open system. In addition, the first heating mode was convenient, and all its reaction products were involved in the whole thermal evolution, and the final simulation experimental results were basically in consistency with the natural evolution trend Therefore, the first heating mode was adopted and the hydrocarbon yield of every sample was worked out. According to the type and lithology of organic matter and the hydrocarbon yield of samples for simulation experiment, hydrocarbon generation and expulsion mode with three kinds of lithology and five types of source rock has been established to provide the basis for hydrocarbon generation evaluation, research and resource calculation.     

基于弹性薄板的地表沉陷预计模型

在分析地表沉陷基本规律的基础上,依据弹性薄板理论,建立非充分采动条件下岩层和地表沉陷预计的一类新模型,并推导出地表任意点倾斜、曲率、水平移动以及水平变形的计算公式。该模型充分考虑到地质采矿因素（煤层倾角）及煤层上方各岩层的影响,克服传统预测方法的缺陷,特别是概率积分法关于拐点反对称要求。最后,应用实例证明该方法的应用效果。