APPLICATION OF A GROUPED RESPONSE UNIT HYDROLOGICAL MODEL TO A NORTHERN WETLAND REGION

Applications of hydrological models to northern wetland-dominated regions have been limited in the past to a few case studies on small basins employing ‘lumped’ models. Only recently have there been attempts to apply the grouped response unit (GRU) distributed modelling approach using terrain classifications to these same basins. This study summarizes recent efforts in applying such a model. For the purposes of implementing the GRU approach, terrain types that are hydrologically significant and characteristic to the wetland-dominated regime were successfully discriminated using a principal component analysis and a hybrid unsupervised/supervised classification technique on Landsat–Thematic Mapper imagery. The terrain classifications were then used as input into a distributed hydrological model for calibration and validation using recorded spring runoff events. Preliminary model applications and results are described. Calibration to a historic spring runoff event yielded an r² value of 0.86. Model validation, however, yielded much poorer results. The problems of model applicability to this region and limitations of sparse data networks are highlighted. The need for more field research in this type of hydrological regime, and associated improvements to the model parameter set are also identified.     

FLOOD MODELLING WITH GIS-DERIVED DISTRIBUTED UNIT HYDROGRAPHS

The concept of a spatially distributed unit hydrograph is based on the fact that the unit hydrograph can be derived from the time–area curve of a watershed by the S-curve method. The time–area diagram is a graph of cumulative drainage area contributing to discharge at the watershed outlet within a specified time of travel. Accurate determination of the time–area diagram is made possible by using a GIS. The GIS is used to describe the connectivity of the links in the watershed flow network and to calculate distances and travel times to the watershed outlet for various points within the watershed. Overland flow travel times are calculated by the kinematic wave equation for time to equilibrium; channel flow times are based on the Manning and continuity equations. To account for channel storage, travel times for channel reaches are increased by a percentage depending on the channel reach length and geometry. With GIS capability for rainfall mapping, the assumption of a uniform spatial rainfall distribution is no longer necessary; hence the term, spatially distributed unit hydrograph. An example of the application for the Waiparous Creek in the Alberta Foothills is given. IDRISI is used to develop a simple digital elevation model of the 229 km² watershed, using 1 km × 1 km grid cells. A grid of flow directions is developed and used to create an equivalent channel network. Excess rainfall for each 1 km × 1 km cell is individually computed by the Soil Conservation Service (SCS) runoff curve method and routed through the equivalent channel network to obtain the time–area curve. The derived unit hydrograph gave excellent results in simulating an observed flood hydrograph. The distributed unit hydrograph is no longer a lumped model, since it accounts for internal distribution of rainfall and runoff. It is derived for a watershed without the need for observed rainfall and discharge data, because it is essentially a geomorphoclimatic approach. As such, it allows the derivation of watershed responses (hydrographs) to inputs of various magnitudes, thus eliminating the assumption of proportionality of input and output if needed. The superposition of outputs is retained in simulating flood hydrographs by convolution, since it has been shown that some non-linear systems satisfy the principle of superposition. The distributed unit hydrograph appears to be a very promising rainfall runoff model based on GIS technology.     

分布式计算环境下网络GIS实现技术探讨

介绍了分布式计算环境和网络地理信息系统的概念,探讨了分布式计算环境下网络地理信息系统的几种实现方法,最后对未来的分布式网络地理信息系统发展进行了展望。     

面向问题的空间应用表达与实现

讨论空间应用的一种面向问题的表达方法与实现机制。为解决空间应用的描述问题,在建立时空一体化空间数据模型基础上,定义了对SQL进行扩展的时空复合查询语言,实现了对空间应用问题的非过程化描述;研究复杂空间应用的表达问题,讨论时空复合查询语言的限制,并在语言中引入流机制,通过空间应用问题的组合实现更为复杂的空间应用,并支持空间数据分布式计算;最后给出若干空间应用实例及其面向问题的表达。     

基于P2P的空间数据操作分布技术研究

分布在不同节点的空间数据库通过P2P协作共同完成复杂的空间应用任务。提出一种基于P2P的空间数据操作分布的引擎设计:引擎根据空间应用任务的解析,在P2P网络中动态地选择最佳的执行引擎,通过P2P的消息和通信机制进行协作,共同完成复杂的空间计算和空间查询任务。P2P的执行机制避免了集中式执行引擎带来的网络拥塞和单点失效问题,提高了空间数据资源和计算资源协作的可靠性和可用性。     

基于Mycat的分布式技术在收集与分发系统中的应用

基于Mycat的分布式数据库集群,采用了 Mycat+Mysql+Haproxy+Keepalived的技术架构,实现了一个高可用、高性能和高扩展的分布式数据库集群系统,并对单机版Mysql数据库和基于Mycat分布式数据库集群进行性能比较.结果表明,基于Mycat的分布式技术研发数据库集群系统具有高效性和可行性,可以...     

Quantifying sand delivery to deep water during changing sea-level: Numerical models from the Quaternary Brazos Icehouse continental margin

Sequence stratigraphy for clastic continental margins predicts the development of sand-rich turbidite deposits during specific times in relation to base-level cycles. It is now widely understood that deltas can extend to the shelf-edge forced by high sediment flux and/or base level, providing a direct connection to transfer sediment and sand to the slope and basin floor even during high base level periods. Herein, we build a stratigraphic forward model for the last 120 kyr of the fluvio-deltaic to deep-water Brazos system (USA) where sediment partitioning along an Icehouse continental margin can be evaluated. The reduced-complexity stratigraphic forward model employs geologically constrained input parameters and mass balance. The modelled architecture is consistent with the location of depositional units previously mapped in the shelf. Sand bypasses the shelf and upper slope between 35 to 15 kyr before present and only about 20%–30% of all the sediment and sand supplied to the system is transferred to deep water. Several scenarios based on the initial Brazos model investigate the relationships between base level and deep-water sand ratio (DWSR). DWSR is defined as the relative amount of sand transferred to the deep-water portions of the system subdivided by the total sand input to the model. Linear correlations between DWSR and base level change rates or base level are very poor. Short-term variability due to local processes (for example avulsions) is superimposed to the long-term trends and mask the base level signal. DWSR for an entire base-level cycle is mainly controlled by the proportion of time the delta stays docked at the shelf-edge. Stratigraphic forward models are useful to complement field observations and quantify how different processes control stratigraphy, which is important for making predictions in areas with limited information.     

基于纵横波保幅分离的粘弹介质弹性波正演模拟

地下介质往往表现为粘弹特性,研究基于粘弹假设的数值模拟方法对于正确认识地震波的传播规律和提高地震勘探精度具有重要意义。波动方程正演过程中纵横波的保幅解耦是研究准确的粘弹介质中地震波传播机理的前提,基于散度和旋度算子的纵横波解耦方法会使波场的相位和振幅产生畸变,且解耦后的波场在极性反转位置上无法与分离前混合波场各分量对应。在散度和旋度算子上再做一次梯度和旋度运算的波场分离方法虽然能够克服上述缺陷,但存在保幅性差等问题。本文从粘弹介质中的一阶速度-应力方程出发,推导了矢量纵横波分离的波数域表达式,结合有限差分思路给出了其在空间域的求解方法。本文方法利用纵横波的传播速度对现有的矢量波场分离方法进行振幅校正,并将校正结果分别作为纵波与横波对时间的二阶偏导,实现了粘弹介质中的纵横波分离。模型试算结果表明,本文方法能够克服现有方法的缺陷,获得更具保幅性的波场分离结果。     

基于SWAT模型的森林分布不连续流域水源涵养量多时间尺度分析

为解决森林分布不连续流域森林水源涵养功能及其多时间尺度特征的定量评价问题,根据分布式水文模型（SWAT）的特点,提出了反映森林斑块空间分布的水文响应单元划分方法,以及基于水量平衡法的森林不连续分布流域森林水源涵养量计算公式。以东南沿海的晋江流域为例,构建了2006年土地利用条件下的日时间步长SWAT模型,统计分析了2002—2010年降水条件下森林水源涵养量的时空变化规律。结果表明：① 构建的晋江流域SWAT模型精度较高,面积阈值为零生成的水文响应单元比较准确地反映流域森林斑块分布,提出的森林水源涵养量计算公式适用于森林空间分布不连续流域森林水源涵养量的多时间尺度分析,为流域森林水源涵养功能评价提供了一个新的方法。② 晋江流域森林水源年涵养量271.41~565.25 mm;月涵养量-29.15~154.59 mm;日尺度的极端降水期皆为正值,极端枯水期都为负值。表明年际之间不存在森林水源涵养的蓄丰补枯调节作用,但在年内的部分月份得到体现,而日尺度的森林蓄丰补枯功能充分发挥。从而揭示了不同时间尺度森林水源涵养量及其蓄丰补枯功能的差异。     

Ephemeral rollover points and clinothem evolution in the modern Po Delta based on repeated bathymetric surveys

Reconstructions of ancient delta systems rely typically on a two-dimensional (2D) view of prograding clinothems but may miss their three-dimensional (3D) stratigraphic complexity which can, instead, be best documented on modern delta systems by integrating high-resolution geophysical data, historical cartography, core data and geomorphological reconstructions offshore. We quantitatively compare three precisely positioned, high-resolution multi-beam bathymetry maps in the delta front and pro delta sectors (0.3 to 10 m water depth) of Po di Pila, the most active of the modern Po Delta five branches. By investigating the detailed morphology of the prograding modern Po Delta, we shed new light on the mechanisms that control the topset to foreset transition in clinothems and show the temporal and spatial complexity of a delta and its pro delta slope, under the impact of oceanographic processes. This study documents the ephemeral nature of the rollover point at the transition between sandy topset (fluvial, delta plain to mouth-bar) and muddy seaward-dipping foreset deposits advancing, in this case, in >20 m of water depth. Three multibeam surveys, acquired between 2013 and 2016, document the complexity in space and time of the topset and foreset regions and their related morphology, a diagnostic feature that could not be appreciated using solely 2D, even very high-resolution, seismic profiles. In addition, the comparison of bathymetric surveys gathered with one-year lapses shows the migration of subaqueous sand dunes on the clinothem topset, the formation of ephemeral cut-and-fill features at the rollover point (few m below mean sea level), the presence of collapse depressions derived by sagging of sediments and fluid expulsion (possibly induced by storm waves) on the foreset, and splays of sand likely reflecting gravity flows on the lower foreset. Though the modern Po Delta is anthropogenic in many respects, its subaqueous clinothem can be studied as a scale model for ancient clinothems that are less resolved geometrically and far less constrained chronologically.