About the specification of erosion flux for soft stratified cohesive sediments

The present paper deals with the specification of bed erosion flux that accounts for the effects of sediment-induced stratification in the water column. Owing to difficulties in measuring the bed shear stress _b and the erosive shear strength _s, we suggest a series of methods that combine laboratory and numerical experiments. A simplified turbulent transport model that includes these effects helps to quantify _b and _s. Focusing on soft stratified beds, the present study considers erosion rate formulas of the form =_f exp {[T_b-T_s]} where is a model constant (=1 for Gularte's (1978) formula and =1/2 for Parchure's (1984) formula). First, the bed erosive strength profile _s(Z) is adjusted by forcing the turbulent transport model with measured erosion rates. Second, three procedures are suggested to determine the erosion rate formula coefficients _f and : a global procedure and two different layer-by-layer procedures. Each procedure is applied to an erosion experiment conducted in a rotating annular flume by Villaret and Paulic (1986). The use of the layer-by-layer procedure based on a least squares fitting technique provides a closer fit than the global procedure. The present study points out the complementarity of experimental and numerical approaches and also suggests possible improvements in laboratory test procedures.     

河北省唐山地区丰台—野鸡坨断裂第四纪活动性——来自14C和磁性地层年代学的证据

丰台—野鸡坨断裂为唐山地区主要断裂之一，西侧为鸦鸿桥凹陷，东侧为唐山凸起，断裂两侧第四系厚度之差巨大。本文依据该断层两侧钻孔对其第四纪以来活动性进行初步的探讨。通过对丰台—野鸡坨断裂上下两盘PZK14和PZK20孔磁性地层学研究，并结合钻孔岩石地层，及浅部光释光和¹⁴C测年结果，建立第四纪地层格架。结果表明：两孔底部“泥包砾”为新近纪沉积；PZK14孔下更新统底界埋深为387 m，中更新统底界埋深为114 m，上更新统底界埋深为71 m，全新统底界埋深为6 m；PZK20孔下更新统底界埋深为155 m，中更新统底界埋深为73 m，上更新统底界为36 m，无全新世地层。丰台—野鸡坨断裂活动在早更新世时表现为逐渐增强的特点，活动速率由早期的5.4 cm/ka增加到13.9 cm/ka。中更新世断裂活动基本处于停滞状态，活动速率为1.0 cm/ka。晚更新世以后，断裂重新活动，且更加剧烈，活动速率达到了54.5 cm/ka。     

钻孔灌注桩施工对邻近运营隧道变形影响研究

桩基施工将引起周边地层位移和邻近隧道结构变形,以南京龙津桥改建项目桩基工程为背景,通过现场实测,分析研究钻孔灌注桩施工全过程各工况条件对地层位移场和邻近既有隧道结构变形的影响规律。结果表明:由于钢套管的护壁作用,钻孔灌注桩施工过程中产生的最大地层位移和隧道结构变形较小,说明采用“钢套管边旋压边取土”、“群桩间跳施工”等工艺,对周围土体扰动影响程度较小,建议近隧桩基工程采用全套管灌注桩的施工方法,监测分析结果可为类似工程提供技术参考。     

Latitudinal variation of measured O3 photolysis frequencies J(O1D) and primary OH production rates over the Atlantic Ocean between 50° N and 30° S

The latitudinal variation of the photolysis frequency of ozone to O(¹D) atoms, J(O¹D), was measured using a filter radiometer during the cruise ANT VII/1 of the research vessel Polarstern in September/October 1988. The J(O¹D) noon values exhibited a maximum of 3.6×10^-5 s^-1 (2 sr) at the equator and decreased strongly towards higher latitudes. J(O¹D) reached highest values for clean marine background air with low aerosol load and almost cloudless sky. The J(O¹D) data, measured under these conditions and a temperature of 295 K, can be expressed by: % MathType!MTEF!2!1!+-% feaafiart1ev1aaatCvAUfeBSjuyZL2yd9gzLbvyNv2CaerbuLwBLn% hiov2DGi1BTfMBaeXatLxBI9gBaerbd9wDYLwzYbItLDharqqtubsr% 4rNCHbGeaGqiVu0Je9sqqrpepC0xbbL8F4rqqrFfpeea0xe9Lq-Jc9% vqaqpepm0xbba9pwe9Q8fs0-yqaqpepae9pg0FirpepeKkFr0xfr-x% fr-xb9adbaqaaeGaciGaaiaabeqaamaabaabaaGcbaGaamOsaiaacI% cacaqGpbWaaWbaaSqabeaaiiaacqWF8baFaaGccaqGebGaaeykaiaa% bccacqWF9aqpcaqGGaGaaeyzaiaabIhacaqGWbGaaeiiaiaabUhacq% GHsislcaaI4aGaaiOlaiaaicdacaaIYaGaeyOeI0IaaGioaiaac6ca% caaI4aGaaiiEaiaaigdacaaIWaWaaWbaaSqabeaacqGHsislcaaIZa% aaaOGaaeiiaiaabIhacaqGGaGaam4uaiabgUcaRiaaiodacaGGUaGa% aGinaiaacIhacaaIXaGaaGimamaaCaaaleqabaGaeyOeI0IaaGOnaa% aakiaadofadaahaaWcbeqaaiaaikdaaaGccaGG9bGaaeikaiaaboha% daahaaWcbeqaaiabgkHiTiaaigdaaaGccaGGPaaaaa!5EE9!\[J({\text{O}}^| {\text{D) }} = {\text{ exp \{ }} - 8.02 - 8.8x10^{ - 3} {\text{ x }}S + 3.4x10^{ - 6} S^2 \} {\text{(s}}^{ - 1} )\] where S represents the product of the overhead ozone column (DU) and the secant of the solar zenith angle. The meridional profile of the primary OH radical production rate P(OH) was calculated from the J(O¹D) measurements and simultaneously recorded O₃ and H₂O mixing ratios. While the latitudinal distribution of J(O¹D) and water vapour was nearly symmetric to the equator, high tropospheric ozone levels up to 40 ppb were observed in the Southern Hemisphere, SH, resulting in higher P(OH) in the SH.     

Field calibration and performance of sediment traps in a eutrophic holomictic lake

In wind-stressed and unstratified Lough Neagh low aspect ratio sediment traps, which allow for internal resuspension, collected sediment at a rate close to the natural sediment accumulation rate inferred from dated sediment cores. High aspect ratio traps grossly overestimated the natural rate of sediment accumulation as did, but to a lesser extent, burial rate measurements on an artificial stratigraphic marker. The former type of trap deployed over long exposure periods is therefore recommended as providing the best estimate of net downward particle flux in lakes such as Lough Neagh. However, it is emphasized that all sediment trap types, when operated in shallow turbulent lakes, will to a greater or lesser extent be contaminated by secondary or redeposited material and so will not provide a direct measure of primary sedimentation. Use of tube traps in lakes such as Lough Neagh should not, however, be discounted since they can provide a record of the quality of sedimenting material through time.     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

3-D seismic structure of the source area of the 1993 Latur, India, earthquake and its implications for rupture nucleations

The Latur earthquake (M_w 6.1) of 29 September 1993 is a rare stable continental region (SCR) earthquake that occurred on a previously unknown blind fault. In this study, we determined detailed three-dimensional (3-D) P- and S-wave velocity (V_p, V_s) and Poisson's ratio (σ) structures by inverting the first P- and S-wave high-quality arrival time data from 142 aftershocks that were recorded by a network of temporary seismic stations. The source zone of the Latur earthquake shows strong lateral heterogeneities in V_p, V_s and σ structures, extending in a volume of about 90 × 90 × 15 km³. The mainshock occurred within, but near the boundary, of a low-V_p, high-V_s and low-σ zone. This suggests that the structural asperities at the mainshock hypocenter are associated with a partially fluid-saturated fractured rock in a previously unknown source zone with intersecting fault surfaces. This might have triggered the 1993 Latur mainshock and its aftershock sequence. Our results are in good agreement with other geophysical studies that suggest high conductivity and high concentration of radiogenic helium gas beneath the source zone of the Latur earthquake. Our study provides an additional evidence for the presence of fluid related anomaly at the hidden source zone of the Latur earthquake in the SCR and helps us understand the genesis of damaging earthquakes in the SCR of the world.     

Continuous air rate measurement in flotation cells: Some fundamental considerations

A robust and reliable sensor to measure gas (air) superficial velocity (J_g) continuously in flotation systems is introduced. It is based on the sampling of bubbles by buoyancy with the accumulating air allowed to exit through an orifice. At steady state, pressure drop is measured and related to the J_g by prior calibration. The continuous device is readily automated and extended to a multi-unit set-up. The sensor and data collections are described. The governing gas flow equation and models of the dynamic response to air flow rate set point change and fluctuations in froth depth are derived. Model predictions are confirmed against plant data. By taking a moving average, the J_g remains valid in the face of typical plant disturbances.     

大变形有限元法分析边坡稳定性

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。