Orbital control on cyclical organic matter accumulation in Early Silurian Longmaxi Formation shales

High resolution(939 samples)total organic carbon content(TOC)analyses were conducted on the Shuanghe Section of^152.6 m in the Changning area,Sichuan Basin.The sampling section was divided into two units considering the distinct-different deposit environment and sediments accumulation rate.The lower part(Unit 1)and the peer part(Unit 2)with high resolution sample spacing(0.08–0.4 m)enables the identification of the precession cycle in two sedimentary sequences with distinct different sedimentary accumulation rate.MTM Power spectral analyses on untuned TOC series reveals significant peaks exceeding above the 95%confidence level and shows that both Unit 1 and Unit 2 have recorded Milankovitch cycles of 405 kyr long eccentricity,short eccentricity,obliquity and precession.The floating astronomical time scale(ATS)was constructed on the Shuanghe Section in the Early Silurian(~439.673–444.681 Ma),and which was calibrated by 405 kyr long eccentricity cycles.The total duration of the Wufeng and Longmaxi shales is 5.01 Myr.The floating ATS used for estimating the duration of the graptolite zones and each stage in the study interval.Finally,we postulated two models that could verify the linkage between orbital cycle and organic accumulation.To make sure whether productivity or preservation is the main factor that under long eccentricity control,the phase correlation between the obtained filtered signal and the theoretical orbital solution should be made clear in the further research.     

Application of open tools and datasets to probabilistic modeling of road traffic disruptions due to earthquake damage

The disruption of a transportation network can have a high social and economic impact on the welfare of a society, as it can significantly affect the daily routines of a community. Although many studies have focused on the estimation of physical risk in the components that compose these networks, only a limited number have analyzed their interconnections and impact in the traffic flow. The present study analyzes how earthquake damage can disrupt the road network in an urban environment, and how this will influence the ability of the population to travel. Traffic due to daily commutes is modeled for different layouts of the network, corresponding to possible disruptions caused by earthquake damage. The duration and length of each trip were calculated both for the undamaged network conditions and for the disrupted network. The increase in the median duration and length of each trip allows estimating the economic loss for each event due to drivers' delay. By combining the probability of a specific road being blocked with its number of users, the average number of affected vehicles was estimated, and the most critical segments identified. The methodology was applied to a case study concerning the road network of the area around the Italian city of Messina in Sicily. The results were calculated for both a repetition of the well-known historical event of 1908 and a set of simulated earthquakes consistent with the national probabilistic seismic hazard model of Italy.     

Quick Phase Identification for Dense Seismic Array with Aid from Long Term Phase Records of Co-located Sparse Permanent Stations

The phase identification and travel time picking are critical for seismic tomography, yet it will be challenging when the numbers of stations and earthquakes are huge. We here present a method to quickly obtain P and S travel times of pre-determined earthquakes from mobile dense array with the aid from long term phase records from co-located permanent stations. The records for 1 768 M ≥ 2.0 events from 2011 to 2013 recorded by 350 ChinArray stations deployed in Yunnan Province are processed with an improved AR-AIC method utilizing cumulative envelope and rectilinearity. The reference arrivals are predicted based on phase records from 88 permanent stations with similar spatial coverage, which are further refined with AR-AIC. Totally, 718 573 P picks and 512 035 S picks are obtained from mobile stations, which are 28 and 22 times of those from permanent stations, respectively. By comparing the automatic picks with manual picks from 88 permanent stations, for M ≥ 3.0 events, 81.5% of the P-pick errors are smaller than 0.5 second and 70.5% of S-pick errors are smaller than 1 second. For events with a lower magnitude, 76.5% P-pick errors fall into 0.5 second and 69.5% S-pick errors are smaller than 1 second. Moreover, the Pn and Sn phases are easily discriminated from directly P/S, indicating the necessity of combining traditional auto picking and integrating machine learning method.     

Water transport and tracer mixing in volcanic ash soils at a tropical hillslope: A wet layered sloping sponge

Andosol soils formed in volcanic ash provide key hydrological services in montane environments. To unravel the subsurface water transport and tracer mixing in these soils we conducted a detailed characterization of soil properties and analyzed a 3-year data set of sub-hourly hydrometric and weekly stable isotope data collected at three locations along a steep hillslope. A weakly developed (52–61 cm depth), highly organic andic (Ah) horizon overlaying a mineral (C) horizon was identified, both showing relatively similar properties and subsurface flow dynamics along the hillslope. Soil moisture observations in the Ah horizon showed a fast responding (few hours) “rooted” layer to a depth of 15 cm, overlying a “perched” layer that remained near saturated year-round. The formation of the latter results from the high organic matter (33–42%) and clay (29–31%) content of the Ah horizon and an abrupt hydraulic conductivity reduction in this layer with respect to the rooted layer above. Isotopic signatures revealed that water resides within this soil horizon for short periods, both at the rooted (2 weeks) and perched (4 weeks) layer. A fast soil moisture reaction during rainfall events was also observed in the C horizon, with response times similar to those in the rooted layer. These results indicate that despite the perched layer, which helps sustain the water storage of the soil, a fast vertical mobilization of water through the entire soil profile occurs during rainfall events. The latter being the result of the fast transmissivity of hydraulic potentials through the porous matrix of the Andosols, as evidenced by the exponential shape of the water retention curves of the subsequent horizons. These findings demonstrate that the hydrological behavior of volcanic ash soils resembles that of a “layered sponge,” in which vertical flow paths dominate.     

Analysis of Anomalous Characteristics of Regional Crustal Deformation before the September 16th, 2019 Zhangye MS5.0 Earthquake, Gansu, China

To study the crustal movement in the vicinity of the epicenter before the Zhangye M_S5.0 earthquake in 2019, the characteristics of crustal deformation before the earthquake are discussed through the GPS velocity field analysis based on the CMONOC data observed from GPS. The baseline time series between two continuous GPS stations and the strain time series of an area among several stations are analyzed in the epicenter area. The resulting time series of baseline azimuth around the epicenter reflects that the energy of the fault in the northern margin of Qilian Mountain is accumulated continuously before 2017. Besides, the movement trend of azimuth slows down after 2017, indicating the stress accumulation on both sides of the seismogenic fault zone has reached a certain degree. The first shear strain and EW-direction linear strain in the epicentral area of the Zhangye M_S5.0 earthquake remain steady after 2017, and the surface strain rate decreases gradually after 2016. It is illustrated that there is an obvious deformation loss at the epicentral region three years before the earthquake, indicating that a certain degree of strain energy is accumulated in this area before the earthquake.     

Coherence algorithm with a high-resolution time–time transform and feature matrix for seismic data

Traditional coherence algorithms are often based on the assumption that seismic traces are stationary and Gaussian. However, seismic traces are actually non-stationary and non-Gaussian. A constant time window and the canonical correlation analysis in traditional coherence algorithms are not optimal for non-stationary seismic traces and cannot describe the similarity between adjacent seismic traces in detail. To overcome this problem, a new coherence algorithm using the high-resolution time–time transform and the feature matrix is designed. The high-resolution time–time transform used to replace the constant time window can produce a frequency-dependent time local series to analyse non-stationary seismic traces. The feature matrix, constructed by the frequency-dependent time local series and the related local gradients, defines a new correlation metric that enhances more details of the geological discontinuities in seismic images than does the canonical correlation analysis. Additionally, the Riemannian metric is introduced for related calculations because the feature matrices are not defined in a Euclidean space but rather in a manifold space. Application to field data illustrates that the proposed method reveals more details of structural and stratigraphic features.     

Application of a cascading filter implemented using morphological filtering and time–frequency peak filtering for seismic signal enhancement

Inspired by the idea of the iterative time–frequency peak filtering, which applies time–frequency peak filtering several times to improve the ability of random noise reduction, this article proposes a new cascading filter implemented using mathematic morphological filtering and the time–frequency peak filtering, which we call here morphological time–frequency peak filtering for convenience. This new method will be used mainly for seismic signal enhancement and random noise reduction in which the advantages of the morphological algorithm in processing nonlinear signals and the time–frequency peak filtering in processing nonstationary signals are utilized. Structurally, the scheme of the proposed method adopts mathematic morphological operation to first preprocess the signal and then applies the time–frequency peak filtering method to ultimately extract the valid signal. Through experiments on synthetic seismic signals and field seismic data, this paper demonstrates that the morphological time–frequency peak filtering method is superior to the time–frequency peak filtering method and its iterative form in terms of valid signal enhancement and random noise reduction.     

Using visibility analysis to improve point density and processing time of SfM-MVS techniques for 3D reconstruction of landforms

Image network geometry, including the number and orientation of images, impacts the error, coverage, and processing time of 3D terrain mapping performed using structure-from-motion and multiview-stereo (SfM-MVS). Few studies have quantified trade-offs in error and processing time or ways to optimize image acquisition in diverse topographic conditions. Here, we determine suitable camera locations for image acquisition by minimizing the occlusion produced by topography. Viewshed analysis is used to select the suitable images, which requires a preliminary digital elevation model (DEM), potential camera locations, and sensor parameters. One aerial and two ground-based image collections were used to analyse differences between SfM-MVS models produced using: (1) all available images (ALL); (2) images selected using conventional methods (CON); and (3) images selected using the viewshed analysis (VIEW). The resulting models were compared with benchmark point clouds acquired by a terrestrial laser scanner (TLS) and TLS-derived DEMs. The VIEW datasets produced denser point clouds (28–32% more points) and DEMs with up to 66% reduction in error compared with CON datasets due to reduction of gaps in the DEM. VIEW datasets reduced processing time by 37–76% compared with ALL, with no reduction in coverage or increase in error. DEMs produced with ALL and VIEW datasets had similar slope and roughness, while slight differences that may be locally important were observed for the CON dataset. The new method helps optimize SfM-MVS image collection strategies that significantly reduce the number of images required with minimal loss in coverage or accuracy over complex surfaces. © 2020 John Wiley & Sons, Ltd.     

Efficient strong motion duration of pulse-like records for nonlinear structural analyses

The special interest produced by near-field directivity records and their effect on structural response has given a new significance in the velocity time history, its pulse-like content, and relevant parameters and indices. Recent research has shown that directivity pulses inherent in these records govern the linear and the nonlinear response of a wide range of structures. Based on this observation, it is suggested in this paper that a truncated ground motion, limited to the duration of the predominant velocity pulse, can be efficiently used to predict the structural response, instead of the base motion with the total duration, reducing significantly the required runtimes. The proposed methodology is verified for a series of medium to high rise reinforced concrete buildings, for which nonlinear time-history analyses are performed for a vast suite of pulse-like near-field records applied as base excitations with their total duration and the proposed truncated one. Comparison of the results for the response displacements and forces shows very good agreement, permitting the acceptance of the pulse duration as the efficient strong motion time interval of the original record, which determines the response and, thus, it can be used for nonlinear structural analyses.