剪切屈服型可更换耗能梁的抗震性能研究

针对传统结构震后修复能力不足,带可更换构件的混合框架结构体系在地震作用下,可更换耗能构件集中损伤和耗散地震能量,保护其他构件不损伤或轻微损伤,更换损伤的耗能构件,即可实现结构预定功能震后可恢复。通过3个可更换耗能梁试件,研究其抗震性能。在此基础上,通过SAP2000有限元建模,对带可更换构件的混合框架结构进行非线性分析,研究整体结构体系的屈服机制、承载力和可更换耗能构件的可更换性能。结果表明:试件均发生剪切屈服型破坏,破坏特征包括腹板－加劲肋焊缝撕裂、腹板屈曲和腹板撕裂。各试件的滞回曲线非常饱满,具有优异的承载能力、变形能力和耗能能力;在地震作用下,带可更换构件的混合框架结构体系中各构件能够实现良好的有序屈服机制,可更换耗能构件具有较好的可更换性。     

江苏地质灾害危险性区域评估与应用

为探究长江漫滩相软土的抗剪强度特征,采用静三轴仪对南京长江漫滩相原状软土进行一系列试验,探讨不同固结条件下漫滩相软土抗剪强度的变化规律。结果表明：当固结度在60%～100%时,增大初始有效围压可在一定程度上提高抗剪强度;在相同围压下,抗剪强度随固结度的增加均规律性增大。以完全固结时的抗剪强度值τf,100%为参考,给出不同固结度下τf对应的折减系数,同时分别给出内摩擦角和黏聚力随固结度的变化关系,为长江漫滩区建设工程地基设计与施工提供参考依据。     

干湿循环效应下玄武岩纤维加筋黄土三轴剪切力学行为研究

通过干湿循环效应下的数字图像三轴剪切试验、CT扫描试验及扫描电镜SEM(scanning electron microscopy)试验,研究了玄武岩纤维加筋黄土干湿循环过程的三轴剪切力学行为及微细观结构演化机制。结果表明:随干湿循环次数增加,纤维含量较高试样的三轴剪切鼓胀破坏形态转变为剪切带破坏;干湿循环早期阶段,剪切破坏形态随纤维含量增加,由剪切带破坏转变为鼓胀破坏。干湿循环作用和纤维含量对应力-应变曲线的类型及特征无明显影响,均表现为应变硬化型。破坏偏应力随干湿循环次数增加而逐渐减小,但衰减速率逐渐减小;破坏偏应力随纤维含量增大先增加而后减小,呈抛物线变化特征,存在一个最佳纤维含量为0.6%。CT数均值ME值呈现与破坏偏应力相似的变化规律。干湿循环作用下筋-土界面产生一定的开裂和松弛现象,弱化了纤维的加筋效应,但与素黄土相比,纤维加筋黄土的微观结构表现出显著的整体稳定性。构建了干湿循环效应下玄武岩纤维加筋黄土的宏细观损伤变量,其表现出一致的变化规律。     

类砂质泥岩常规三轴浆压致裂起裂压力试验研究

为深入探究两淮矿区典型砂质泥岩劈裂注浆起裂机制,研制了常规三轴劈裂注浆试验装置,开展了类砂质泥岩浆压致裂起裂压力模型试验,基于试验结果分析了岩石强度与应力状态对注浆起裂压力、裂缝扩展形态影响规律,揭示了砂质泥岩劈裂注浆起裂机制。研究表明：起裂压力与岩石抗压强度呈正相关,且岩石抗压强度越高,劈裂路径越复杂;起裂压力对围压的敏感程度远高于轴压,且应力差 Δσ =σ_V −σ_H越大,裂缝形态越规整;孔压三轴条件下,封闭裸孔段浆压致裂法确定的岩石抗拉强度值约为单轴抗拉强度的 2.5倍。该研究结果可为今后类似岩层劈裂注浆参数设计与施工提供参考。     

基于单三轴试验与直剪试验的层状软岩模拟

为探究模型试验中层状软岩模拟方法,依托九绵高速层状软岩隧道现场取样的室内试验结果,多次试验确定重晶石粉、石英砂、石膏粉、滑石粉和水的最优配比以模拟软岩基体,采用带孔薄膜模拟层理弱面的黏结作用,并通过直剪试验确定孔隙率,最后对不同层理角度与层理厚度的试样开展直剪与单、三轴试验以反映各向异性情况。结果表明：软岩基体模拟最优配比为0.55:0.15:0.07:0.06:0.17,重晶石粉对强度及破坏变形起决定作用,含量过低易压溃,含量过高产生上下贯通裂缝;采用30%孔洞率的薄膜模拟层理效果最佳;土样强度随层角呈U形变化,层厚减小（不小于2 cm）,强度减小。直剪试验中,45º层理剪切面朝层理方向倾斜,90º层理导致剪切面上下产生裂缝与碎裂,单三轴结果中,0º层理会产生小角度倾斜裂缝,45º层理产生垂直层理面的斜裂缝及二次破裂,90º层理产生顺层理的竖向劈裂;与现场结果对照后确定最优层厚为 3 cm,对层角与层厚的直剪与单三轴试验结果整体一致,揭示土样孔隙压密闭合−弹性−塑性胀裂破坏−徐变的过程。     

有载冻融作用对深部重塑黏土抗剪强度影响的试验研究北大核心CSCD

深厚表土层冻结法凿井工程中,深部土体由于经历了高压冻融作用,导致其工程性质变化,认识冻融作用对其强度与变形影响,对于冻融病害防治有一定意义。本文通过室内试验对深部重塑黏土进行了有载冻融,并对不同干密度、围压、冻结温度和融化温度条件下的深部冻融重塑黏土进行三轴剪切试验,探讨有载冻融作用下深土重塑土抗剪强度的变化规律。研究结果表明:冻融作用使深部重塑黏土的偏应力-应变关系由软化型转变成硬化型;同时,经冻融作用后其抗剪强度与割线模量都产生了一定的下降,在本试验条件下,抗剪强度最高下降了48.8%,割线模量E_()最大下降了72.0%。通过对各影响因素的显著性分析,发现初始干密度对抗剪强度和割线模量影响最为显著,围压对两者的影响最弱。     

Test on dynamic characteristics of subgrade of heavy-haul railway in cold regions

Dynamic characteristics of heavy-haul railway subgrade under vibratory loading in cold regions are investigated via low-temperature dynamic triaxial tests with multi-stage cyclic loading process. The relationship between dynamic shear stress and dynamic shear strain of frozen soil of subgrade under train loading and the influence of freezing temperatures on dynamic constitutive relation, dynamic shear modulus and damping ratio are observed in this study. Test results show that the dynamic constitutive relations of the frozen soils with different freezing temperatures comply with the hyperbolic model, in which model parameters a and b decrease with increasing freezing temperature. The dynamic shear modulus of the frozen soils decreases with increasing dynamic shear strains initially, followed by a relatively smooth attenuation tendency, whereas increases with decreasing freezing temperatures. The damping ratios decrease with decreasing freezing temperatures. Two linear functions are defined to express the linear relationships between dynamic shear modulus (damping ratio) and freezing temperature, respectively, in which corresponding linear coefficients are obtained through multiple regression analysis of test data.     

Spatial Structure of Regular and Chaotic Orbits in A Self-Consistent Triaxial Stellar System

We created a triaxial stellar system through the cold dissipationless collapse of 100,000 particles whose evolution was followed with a multipolar code. Once an equilibrium system had been obtained, the multipolar expansion was freezed and smoothed in order to get a stationary smooth potential. The resulting model was self-consistent and the orbits and Lyapunov exponents could then be computed for a randomly selected sample of 3472 of the bodies that make up the system. More than half of the orbits (52.7 % ) turned out to be chaotic. Regular orbits were then classified using the frequency analysis automatic code of Carpintero and Aguilar (1998, MNRAS 298(1), 1–21). We present plots of the distributions of the different kinds of orbits projected on the symmetry planes of the system. We distinguish chaotic orbits with only one non-zero Lyapunov exponent from those with two non-zero exponents and show that their spatial distributions differ, that of the former being more similar to the one of the regular orbits. Most of the regular orbits are boxes and boxlets, but the minor axis tubes play an important role filling in the wasp waists of the boxes and helping to give a lentil shape to the system. We see no problem in building stable triaxial models with substantial amounts of chaotic orbits; the difficulties found by other authors may be due not to a physical cause but to a limitation of Schwarzschild’s method.     

模拟堆载作用的黄土边坡土体变形机理试验

通过固结不排水剪试验,研究了堆载作用下不同深度、含水量和围压的原状黄土的变形和破坏特征,并从黄土的微观结构角度分析了产生这一现象的原因,结合黄土边坡特殊的工程地质条件,分析了堆载作用下黄土边坡土体的变形破坏过程。试验结果表明,不同深度、含水量和围压的原状黄土的应力应变曲线和抗剪强度具有不同的特征;特殊的工程地质条件,使黄土坡体的某些部位形成了堆载作用下不利于黄土材料强度保持的含水量和围压的组合,导致了这些部位黄土的变形破坏,进而诱发坡体的变形破坏。     

Effects of boundary conditions and partial drainage on cyclic simple shear test results—a numerical study

Owing to imperfect boundary conditions in laboratory soil tests and the possibility of water diffusion inside the soil specimen in undrained tests, the assumption of uniform stress/strain over the sample is not valid. This study presents a qualitative assessment of the effects of non‐uniformities in stresses and strains, as well as effects of water diffusion within the soil sample on the global results of undrained cyclic simple shear tests. The possible implications of those phenomena on the results of liquefaction strength assessment are also discussed. A state‐of‐the‐art finite element code for transient analysis of multi‐phase systems is used to compare results of the so‐called ‘element tests’ (numerical constitutive experiments assuming uniform stress/strain/pore pressure distribution throughout the sample) with results of actual simulations of undrained cyclic simple shear tests using a finite element mesh and realistic boundary conditions. The finite element simulations are performed under various conditions, covering the entire range of practical situations: (1) perfectly drained soil specimen with constant volume, (2) perfectly undrained specimen, and (3) undrained test with possibility of water diffusion within the sample. The results presented here are restricted to strain‐driven tests performed for a loose uniform fine sand with relative density D_r=40%. Effects of system compliance in undrained laboratory simple shear tests are not investigated here. Copyright © 2004 John Wiley & Sons, Ltd.