Effect of near-fault earthquake on bridges: lessons learned from Chi-Chi earthquake

The objective of this paper is to describe the lessons learned and actions that have been taken related to the seismic design of bridge structures after the Chi-Chi, Taiwan earthquake. Much variable near-fault ground motion data was collected from the rupture of Chelungpu fault during the Chi-Chi earthquake, allowing the seismic response of bridge structures subjected to these near-fault ground motions to be carefully examined. To study the near-fault ground motion effect on bridge seismic design codes, a two-level seismic design of bridge structures was developed and implemented. This design code reflects the near-fault factors in the seismic design forces. Finally, a risk assessment methodology, based on bridge vulnerability, is also developed to assist in decisions for reducing seismic risk due to failure of bridges. Director of Center for Research on Earthquake Engineering. Supported by: the Science Council, Chinese Taipei, under grant no. SC 90-2211-E-002-028.     

桥梁隔震体系振动台试验研究(IV)——隔震桥梁的设计方法探讨

在前文模型试验的基础上 ,本文总结归纳了隔震桥梁的设计方法与设计流程 ,着重论述探讨了隔震桥梁的概念设计与细部构造设计应注意的问题     

基于纤维梁柱单元的桥梁墩柱地震反应模拟方法研究

为讨论利用纤维梁柱单元进行钢筋混凝土桥墩地震反应分析的建模方法,分别以4个悬臂式单柱墩和1个双柱墩拟静力加载试验,以及1个悬臂式单柱墩的振动台试验结果为依据,基于OpenSees数值分析平台建立了桥墩的地震反应分析模型。通过改变单元数量,分析了基于力的纤维梁柱单元和基于位移的纤维梁柱单元对桥墩地震反应的模拟精度。结果表明:对悬臂式单柱墩的拟静力和振动台试验,可沿墩高仅建立1个基于力的纤维梁柱单元,并在墩底串联1个考虑纵筋塑性渗透和粘结滑移的转动弹簧单元,即可获得很好的模拟结果。当采用基于位移的纤维梁柱单元时,应沿墩高至少建立2个单元,且塑性铰区至少有1个,才能保证获得较高的模拟精度。对双柱墩拟静力试验,采用基于力的纤维梁柱单元建模,沿每个墩高建立2个单元即可;以基于位移的纤维梁柱单元建模,建议沿每个墩高建立3个单元,且其中2个单元布置在塑性铰区。当数值模型可对静力滞回曲线取得很好的模拟结果后,该模型一般可对动力作用下墩顶最大位移和墩底最大剪力进行较为准确的模拟,但对墩顶残余位移的模拟精度无法保证。     

多维多点激励下考虑支座摩擦滑移及结构碰撞的非规则桥梁抗震性能研究

以一座典型山区非规则梁桥为研究对象,建立了该桥梁多维多点激励下的多自由度动力计算模型,研究了该桥梁在多维多点激励下考虑支座摩擦滑移及结构碰撞等非线性因素时的抗震性能。研究结果表明:相比一维地震输入,多维地震可使结构的动力响应增加,桥墩底部弯矩需求增大;相比一致激励,多点激励可使得支座的位移需求增大,且地震波最后到达的桥墩上方支座位移最大;同时考虑多点激励和碰撞效应可使桥墩的弯矩需求增加;水平地震作用下,矮墩上部的支座容易滑动,且双向地震较单向地震更明显,三向地震输入较双向有所增强。因此,对山区非规则梁桥进行抗震设计时应有针对性地进行多维多点地震输入计算,找出结构的最大地震需求,以期指导设计。     

海底地震动作用下近海桥梁地震响应研究

以某近海大桥引桥段连续梁桥为工程背景,建立考虑海底地震动特性和腐蚀效应的近海桥梁地震反应分析模型。采用增量动力分析方法分析腐蚀效应以及海底地震动作用对近海桥梁地震响应的影响。研究结果表明:腐蚀效应与海底地震动作用都会不同程度影响近海桥梁结构的抗震性能。其中:腐蚀效应会增大近海桥梁的破坏指标,降低最大墩底剪力和弯矩值,从而降低桥梁的抗震性能;海底地震动作用会增大近海桥梁的破坏指标及最大墩底剪力、弯矩值;在2种因素耦合作用下,桥梁的抗震性能将会进一步降低。     

基于车桥耦合振动的常用简支空心板梁桥冲击系数分析

通过Universal Mechanism和ANSYS软件相结合建立了车桥耦合振动模型,考虑车型、行车速度、车重和桥梁频率等因素,对工程常用的4种标准跨径装配式混凝土空心板梁桥进行了车桥耦合振动模拟。研究表明:冲击系数随车速增加而上升;随车重增加而增大;随桥梁频率的增加而降低。在多种因素中,车速对冲击系数影响最为明显。     

System identification of the Vincent Thomas suspension bridge using earthquake records

The Vincent Thomas Bridge in the Los Angeles metropolitan area, is a critical artery for commercial traffic flow in and out of the Los Angeles Harbor, and is at risk in the seismically active Southern California region, particularly because it straddles the Palos Verdes fault zone. A combination of linear and non‐linear system identification techniques is employed to obtain a complete reduced‐order, multi‐input–multi‐output (MIMO) dynamic model of the Vincent Thomas Bridge based on the dynamic response of the structure to the 1987 Whittier and 1994 Northridge earthquakes. Starting with the available acceleration measurements (which consists of 15 accelerometers on the bridge structure and 10 accelerometers at various locations on its base), an efficient least‐squares‐based time‐domain identification procedure is applied to the data set to develop a reduced‐order, equivalent linear, multi‐degree‐of‐freedom model. Although not the main focus of this study, the linear system identification method is also combined with a non‐parametric identification technique, to generate a reduced‐order non‐linear mathematical model suitable for use in subsequent studies to predict, with good fidelity, the total response of the bridge under arbitrary dynamic environments. Results of this study yield measurements of the equivalent linear modal properties (frequencies, mode shapes and non‐proportional damping) as well as quantitative measures of the extent and nature of non‐linear interaction forces arising from strong ground shaking. It is shown that, for the particular subset of observations used in the identification procedure, the apparent non‐linearities in the system restoring forces are quite significant, and they contribute substantially to the improved fidelity of the model. Also shown is the potential of the identification technique under discussion to detect slight changes in the structure's influence coefficients, which may be indicators of damage and degradation in the structure being monitored. Difficulties associated with accurately estimating damping for lightly damped long‐span structures from their earthquake response are discussed. The technical issues raised in this paper indicate the need for added spatial resolution in sensor instrumentation to obtain identified mathematical models of structural systems with the broadest range of validity. Copyright © 2003 John Wiley & Sons, Ltd.     

Application of extended distinct element method with lattice model to collapse analysis of RC bridges

This paper proposes a simple lattice model for collapse analysis of RC bridges subjected to earthquakes by using the extended distinct element method (EDEM). In the model, a concrete element consists of lumped masses connected to one another by springs, and a reinforcement bar is represented by a discrete model or an integrated model. The proposed lattice model is simple but its parameters are reasonably defined. It has fewer element nodes and connecting springs, which will be of benefit by shortening the CPU time. The processes to determine the initial stiffness of concrete and steel springs, the parameters of the constitutive model and the fracture criteria for springs are described. A re‐contact spring model is also proposed to simulate the re‐contact of the concrete after fracture of springs; and a general grid searching method is used to decrease the CPU time for judging re‐contact after fracture. The lattice model is assessed by numerical simulations and experiments. As an application, a damaged single‐column pier subjected to the Kobe Earthquake in 1995 is analysed by EDEM with the proposed model. The simulation results indicate that the proposed model predicts well qualitatively the collapse process of RC bridges. Copyright © 2003 John Wiley & Sons, Ltd.     

基于应变模态法识别刚架桥梁的损伤

基于应变模态方法，对刚架桥的损伤识别进行了研究。通过对某刚架桥在不同损伤工况下的数值仿真计算，探讨了应变模态方法用于刚架桥损伤识别的能力。计算结果表明：利用应变模态差曲线能比较准确地识别出刚架桥的损伤位置；应变模态差曲线在刚架桥损伤单元处的跳跃幅值随单元损伤程度的增加而增大，依此可定性地识别出刚架桥的损伤程度。     

Cyclic tests on large‐scale models of existing bridge piers with rectangular hollow cross‐section

Cyclic tests on two large‐scale models of existing bridge piers with rectangular hollow cross‐section were performed in the ELSA laboratory. The prototype structure is an existing reinforced concrete highway bridge constructed in Austria in 1975. The piers presented several seismic deficiencies and consequently they showed poor hysteretic behaviour and limited deformation capacity as well as undesirable failure modes that do not comply with the requirements of modern codes for seismic‐resistant structures. Experimental data are compared to numerical and empirical predictions. Copyright © 2003 John Wiley & Sons, Ltd.