Numerical modeling for analyzing thermal surface anomalies induced by underground coal fires

Coal seams burning underneath the surface are recognized all over the world and have drawn increasing public attention in the past years. Frequently, such fires are analyzed by detecting anomalies like increased exhaust gas concentrations and soil temperatures at the surface. A proper analysis presumes the understanding of involved processes, which determine the spatial distribution and dynamic behavior of the anomalies.In this paper, we explain the relevance of mechanical and energy transport processes with respect to the occurrence of temperature anomalies at the surface. Two approaches are presented, aiming to obtain insight into the underground coal fire situation: In-situ temperature mapping and numerical simulation. In 2000 to 2005, annual temperature mapping in the Wuda (Inner Mongolia, PR China) coal fire area showed that most thermal anomalies on the surface are closely related to fractures, where hot exhaust gases from the coal fire are released. Those fractures develop due to rock mechanical failure after volume reduction in the seams. The measured signals at the surface are therefore strongly affected by mechanical processes.More insight into causes and effects of involved energy transport processes is obtained by numerical simulation of the dynamic behavior of coal fires. Simulations show the inter-relation between release and transport of thermal energy in and around underground coal fires. Our simulation results show a time delay between the coal fire propagation and the observed appearance of the surface temperature signal. Additionally, the overall energy flux away from the burning coal seam into the surrounding bedrock is about 30-times higher than the flux through the surface. This is of particular importance for an estimation of the energy released based on surface temperature measurements. Finally, the simulation results also prove that a fire propagation rate estimated from the interpretation of surface anomalies can differ from the actual rate in the seam.     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Efficiency analysis of open trench for impact pile driving through a single-variable method

Abstract

The ground vibrations during pile driving operation have a drastic potential to undermine the surrounding structures both in land and reclaimed land. Particularly, reclaimed land necessitates ample application of pile driving due to the weak land condition. To prevent the structural damage, attenuation of the ground vibrations to an allowable level through active isolation of circular open trench is the scope of this study. In this research, finite element simulations of continuous impact pile driving process from the ground surface was executed with particular attention to the pile-soil interaction, and thereby, the efficiency of open trench application in attenuation of the unsafe distance of different structures was surveyed using the vibration sensitivity degree. Regarding the crucial parameters of an open trench (depth, width, and location), it was concluded that a sufficient high depth can attenuate the unsafe distance up to 68%, the trench width variations are less effective, and an average pile-trench distance is the most efficient option. The excavation volume was also concluded as another crucial parameter in open trench design which takes all three parameters into account. The trench depth equal to the pile’s maximum critical depth of vibration was inferred for an optimum design.     

辽宁省海洋环境保护与海岸带可持续开发利用

在分析综合辽宁省海岸带调查和沿海经济贝类污染监测资料基础上，根据辽宁海岸带水质，沉积物和生物污染现状及发展趋势。针对所存在的问题，讨论了辽宁省海洋污染特别是赤潮对海洋资源的破坏，并在组织机构，地方立法，海岸带环境保护规划，污染源控制与整体环境改进，监测方案等方面提出了建设海上辽宁、加强辽宁省海洋环境保护与海岸可持续开发利用的建议。     

Environmental control of growth and BChl a expression in an aerobic anoxygenic phototrophic bacterium, Erythrobacter longus (DSMZ6997)

1Introduction Aerobic anoxygenic phototrophic bacteria(AAPB) are facultative heterotrophs that can utilizelight for photosynthesis. These unique-functioningbacteria are widely distributed in marine environ-ments, such as coastal waters (Shiba et al., 1991…     

Instability analysis of three-dimensional ocean shear waves

Ｉｎｓｔａｂｉｌｉｔｙａｎａｌｙｓｉｓｏｆｔｈｒｅｅ－ｄｉｍｅｎｓｉｏｎａｌｏｃｅａｎｓｈｅａｒｗａｖｅｓ￥ＱｉａｏＦａｎｇｌｉ（ＲｅｃｅｉｖｅｄＮｏｖｅｍｂｅｒ６，１９９５，ａｃｃｅｐｔｅｄＮｏｖｅｍｂｅｒ３０．１９９５）Ａｂｓｔｒａｃｔ：Ｂａｓｅ...     

Artificial Upwelling of Deep Seawater Using the Perpetual Salt Fountain for Cultivation of Ocean Desert

Deep seawater in the ocean contains a great deal of nutrients. Stommel et al. have proposed the notion of a “perpetual salt fountain” (Stommel et al., 1956). They noted the possibility of a permanent upwelling of deep seawater with no additional external energy source. If we can cause deep seawater to upwell extensively, we can achieve an ocean farm. We have succeeded in measuring the upwelling velocity by an experiment in the Mariana Trench area using a special measurement system. A 0.3 m diameter, 280 m long soft pipe made of PVC sheet was used in the experiment. The measured data, a verification experiment, and numerical simulation results, gave an estimate of upwelling velocity of 212 m/day. This revised version was published online in July 2006 with corrections to the Cover Date.     

基于规则波波形的超声波非接触测量有关问题探讨

波浪波形的非接触测量近年来获得广泛的应用。本文以规则波为讨论对象，针对介质为空气的超声波测量方式进行波形测量误差分析，并结合实验室和实船试验进行对比分析。理论分析表明：在规则波取为坦谷波和ＳＴＯＫＥＳ波的前提下，超声波技术几乎产生相同的最大误差。定量分析表明，在对测量精度限制的条件下，对文中提及的各项参数应作有效的控制     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

动态基准实时测量系统的开发与应用

介绍了动态基准实时测量系统的硬件组成、站点上全站仪棱镜组合安装与检测方法、系统软件的开发及特点，最后对系统在广州地铁某地铁站结构变形自动监测中的应用情况进行了阐述。通过实际应用表明该系统能应用在自动化、高精度的变形监测领域。