复杂地质条件和敏感环境中基坑设计实践及关键技术

上海某国际金融大厦深大基坑项目北侧紧邻运营轨道交通8号线区间隧道,最近处仅7.87 m,南侧与现有世博共同管沟净距2.0~3.0 m,基坑变形控制要求高,周边环境敏感。同时,本项目位于黄浦江畔,场地浅层为典型的淤泥质软土地层,下部为富含承压水粉（砂）土层,且微承压水层与第一、第二承压水层互为连通,止水帷幕无法隔断承压水层,地质条件复杂。设计采用分坑施工、被动区加固、预应力伺服钢支撑系统、抽灌一体化降水方案、超深地下连续墙、跟踪注浆、型钢垫层等技术方案。实测结果表明,区间隧道的最大变形6.52 mm,共同管沟的最大变形15.3 mm,其最大变形均满足变形控制要求,确保了运营区间隧道和共同管沟的安全。     

带压开采煤层底板突水安全可靠性分析

为合理评价孙疃煤矿10煤层带压开采的安全可靠性,建立了10煤层隔水底板稳定性可靠度分析模型。考虑底板隔水层厚度、底板岩石容重、抗拉强度等参数为随机变量,采用斯列萨列夫安全隔水层厚度计算公式建立极限状态方程。在研究随机变量概型的基础上,采用JC法、最优化法以及基于最优化的蒙特卡罗法计算隔水底板的可靠度以及失效概率,并探讨了该矿10煤层安全开采的可靠指标,避免了单纯依据定值作为突水判据的某些不合理性。     

苏州城市规划区Ⅱ承压水开采与地面沉降预防控制研究

在孔隙承压水开采与地面沉降的关系上存在2种观点。水、土应力平衡理论认为：只要开采承压水，就会引发应力失衡并导致地面沉降；而水、土动态平衡理论则认为：除非开采水压力至水、土应力平衡面以下，否则不会引发地面沉降。苏州城市规划区第Ⅱ承压水开采水位与地面沉降动态观测表明，在-33m处存在一个天然动态水、土应力平衡面。第Ⅱ承压含水层形成后，经上覆堆积物自重压力长期压缩作用，其水压力具较高的压强．这种天然状态下产生的弹性释放储存量可开采利用多少，取决于开采状态下水、土应力平衡时可消耗压力水柱高度中的水头值。因而地面沉降的根本原因是开采水位超过了-33m，突破了天然状态水、土应力平衡面水位。Ⅱ承压含水层在天然状态受上覆堆积物重力产生的高压强弹性释放储存量现象，可以帮助我们确立该地区孔隙Ⅱ承压水开采不产生地面沉降的临界水位(水、土应力平衡面)。这一点对承压水开采条件、可开采资源性质具有重大实际意义。同样可以应用于饱受地面沉降困扰的无锡、常州及周边地区，为地下水开发利用政策由单一的封井停采转为目标水位控制开采提供了科学依据。同时也为此政策在承压水动力学机制上找到了内在原因。     

承压含水层井流-盖层弯曲效应的解析理论

指出承压含水层盖层的弯曲变形与开采井周围的径向地下水运动存在相互作用, 而这一效应在传统的井流理论中没有被认识到.通过引入弹性薄板理论, 建立了无越流的承压含水层井流-顶板弯曲效应的解析模型, 同时考虑了含水层和水的压缩性, 结果表明Theis井流方程给出的抽水降深偏小.在此基础上推导了有越流承压含水层井流-盖层弯曲效应的偏微分方程, 求出了解析解, 并与传统理论的结果进行了对比, 表明Hantush-Jacob公式计算的降深也是偏小的.在抽水井附近和抽水初期, 传统理论可能导致显著的相对误差.      

高温高压岩石流变仪的围压标定方法

高温高压岩石流变仪围压标定的主要方法为氯化盐类的部分熔融法和矿物相变法。利用氯化盐类进行压力标定时,不仅可以利用单一盐类,也可以使用多种盐类的混合物;常用的压力标定矿物相变及其适用温压范围如下:石英-柯石英,500~1200℃、2.5~3.2GPa;钠长石-硬玉+石英,600~1200℃、1.6~3.2GPa;铁橄榄石+石英-铁辉石,600~1200℃、1~1.7GPa;磷镁石-Mg3(PO4)2-Ⅱ,565~825℃、0.6~0.9GPa;方解石-文石,600~1200℃、0.5~2.5GPa。不同的标定方法具有不同的特征,文中将进行详细介绍。     

吉林省通榆、乾安县承压地下水氟污染的原因及其防治对策

本文针对吉林省通榆、乾安县潜水高区下部第四系承压地下水氟含量升高,引起氟地主病重新抬头的环境水千文地质问题,分析了氟升高的原因,主要是研发第四系承压地下水的过程中含水层顶板的大规模破坏,使高氟潜水下窜,污染了深层压水所致。对防治对策进行了探讨,提示人们在水资源开发过程中应保护开采层的地球化学环境,从违背自然的主观意识所造成的恶果中肖取教训。     

砖墙体抗震承载力仿真分析与试验对比

为研究竖向压应力和高宽比对砖墙体抗震性能的影响,以砖墙体抗震承载力典型试验试件为基础,利用有限元分析软件ANSYS建立适当的空间模型。根据砖墙体的破坏模式和材料性能把墙体划分成块体单元、灰缝单元以及接触单元,为各部分材料选用不同的本构关系模型与破坏准则。并将计算结果与试验结果进行对比,验证文中模型的可适用性。选用经验证后的模型,变换竖向压应力和高宽比,得出相应的结论:墙体的开裂荷载和抗侧承载力随着高宽比的增大明显呈降低的趋势;不同高宽比的墙体,竖向压应力的影响规律不尽相同。     

震后多层砌体结构的抗震鉴定与加固设计

本文以5·12汶川地震后绵竹市某砖混结构住宅为典型调查研究对象,介绍了震后多层砌体结构房屋的常见震害现象和一般震害规律,结合有关规范分析了一般受损建筑不同的抗震鉴定方法和手段,对比分析了各种抗震加固措施的加固效果与适用条件,较为全面地总结了一般多层砌体结构从震害调查到鉴定加固的方法和程序,为灾后砌体结构的抗震加固设计提...     

典型隔水边界非稳定流承压含水层抽水试验研究

隔水边界附近的承压含水层,即半无限区域的承压含水层参数的准确求取对于特定地段的地下水资源量计算具有重要意义。以高密市柴沟镇小于家庄抽水试验为例,详细阐述了隔水边界附近的承压含水层参数求取过程,并对结果进行较为详尽的讨论。     

Deep‐water foreland basin deposits of the Cerro Toro Formation,Magallanes basin,Chile: architectural elements of a sinuous basin axial channel belt

Coarse‐grained deep‐water strata of the Cerro Toro Formation in the Cordillera Manuel Señoret, southern Chile, represent the deposits of a major channel belt (4 to 8 km wide by >100 km long) that occupied the foredeep of the Magallanes basin during the Late Cretaceous. Channel belt deposits comprise a ca 400 m thick conglomeratic interval (informally named the ‘Lago Sofia Member’) encased in bathyal fine‐grained units. Facies of the Lago Sofia Member include sandy matrix conglomerate (that show evidence of traction‐dominated deposition and sedimentation from turbulent gravity flows), muddy matrix conglomerate (graded units interpreted as coarse‐grained slurry‐flow deposits) and massive sandstone beds (high‐density turbidity current deposits). Interbedded sandstone and mudstone intervals are present locally, interpreted as inner levée deposits. The channel belt was characterized by a low sinuousity planform architecture, as inferred from outcrop mapping and extensive palaeocurrent measurements. Laterally adjacent to the Lago Sofia Member are interbedded mudstone and sandstone facies derived from gravity flows that spilled over the channel belt margin. A levée interpretation for these fine‐grained units is based on several observations, which include: (i) palaeocurrent measurements that indicate flows diverged (50° to 100°) once they spilled over the confining channel margin; (ii) sandstone beds progressively thin, away from the channel belt margin; (iii) evidence that the eroded channel base was not very well indurated, including a stepped margin and injection of coarse‐grained channel material into surrounding fine‐grained units; and (iv) the presence of sedimentary features common to levées, including slumped units inferring depositional slopes dipping away from the channel margin, lenticular sandstone beds thinning distally from the channel margin, soft sediment deformation and climbing ripples. The tectonic setting and foredeep architecture influenced deposition in the axial channel belt. A significant downstream constriction of the channel belt is reflected by a transition from more tabular units to an internal architecture dominated by lenticular beds associated with a substantially increased degree of scour. Differential propagation of the fold‐thrust belt from the west is speculated to have had a major control on basin, and subsequently channel, width. The confining influence of the basin slopes that paralleled the channel belt, as well as the likelihood that numerous conduits fed into the basin along the length of the active fold‐thrust belt to the west, suggest that proximal–distal relationships observed from large channels in passive margin settings are not necessarily applicable to axial channels in elongate basins.