地脉动测试技术若干问题的讨论

讨论了地脉动的测试技术以及测试工作中应该重视而且容易被忽视的问题 ,并就地脉动幅值域和频率域特性参数提出不同的看法     

塔里木盆地北缘库车盆地白垩系风成砂岩研究--以库车河剖面为例

库车盆地的早白垩世地层为一套干旱气候条件下的红层沉积，包括洪积扇砾岩、间歇性河流砂砾岩、风成细砂岩和粉砂岩、沙漠湖相紫红色泥岩等类型的沉积，组成一个较为典型的沙漠沉积体系。在库车河剖面，下白垩统红层中发育一些厚层至块状的“高能细砂岩和高能粉砂岩”，多为岩屑长石石英砂岩和长石岩屑石英砂岩。它们以良好的分选性和较高的结构成熟度、较细的粒度、较低的成分成熟度和大型交错层理的发育为特征，显示出较为明显的风成沉积特点。     

A comparative study on the illite crystallinity and the clay mineral reflectance spectral index for subdividing the very low-grade metamorphic belt along the Lizhou-Hekou geological section in the Youjiang sedimentary basin, Guangxi, China

To examine the application potential of hyperspectral remote sensing techniques in classifying very low-grade metamorphic belts, the composition of clay minerals and the cyrstallinity of illite from mudstones were measured using XRD and VIS-SWIR (400-2500 nm) reflectance spectroscopy. Based on the illite cyrstallinity, Kubler Index (KI), the Early Triassic LuoLou Group and the Middle Triassic lower Baifeng Formation were classified as the lower Epizone with KI△2θ° ranging from 0.22 to 0.25, the upper Baifeng Formation as upper anchizone with KI△2θ°ranging from 0.26 to 0.33, and the Hekou Formation as lower anchizone with KI△2θ° ranging from 0.38 to 0.40. According to a KI△2θ° value of 0.43, it is possible that there may exist a local diagenetic zone in the upper strata. The illite cyrstallinity Kubler index and the metamorphic grade increase from the bottom to the top of the stratigraphic sequence. The metamorphic grade boundaries nearly match the stratigraphic boundaries, indicating a burial metamorphism nature for the stratigraphic sequence. From the bottom to the top of the sequence, the spectral absorption band center of clay minerals from fresh rocks is around 2200 nm. The absorption band centers change towards shorter wavelengths: the Luolou Group being at 2220 nm, the Baifeng Formation at 2217-2213 nm, the lower member of the Hekou Formation at 2214-2206 nm, and the upper member of the Hekou Formation at 2205-2197 nm. The spectral absorption band center of illite shows the same change pattern. These results indicate that very low-grade metamorphic belts can be subdivided using spectral indices of clay minerals, which are measured by using field portable spectroradiometers. However, it may not work well with satellite and airborne sensors.     

龙首二级面板堆石坝三维真非线性地震反应分析和评价

基于土石料三维粘弹塑性动力本构模型,并采用新型三维各向异性有厚度薄单元来模拟面板和堆石的接触面特性,建立了高面板堆石坝地震反应分析的三维真非线性动力分析方法.利用坝料动力特性的大型三轴试验成果,分析计算了龙首二级(西流水)面板堆石坝的地震反应,主要包括加速度反应、堆石体应力反应及坝体单元抗震安全系数、面板应力反应和变形及接缝位移、高趾墙动力反应等.为大坝的抗震设计提供了有力的技术依据.     

某滑坡软弱夹层抗剪强度取值方法的研究

文章主要针对软弱夹层抗剪强度取值所存在的争议，通过对贵州新街子滑坡的软弱夹层分别选择比例极限、屈服极限及峰值作为剪应力值，采用最小二乘法获得比例抗剪强度、屈服抗剪强度和峰值抗剪强度。以参数选取中应用较为成熟的反分析方法推求力学性质参数c、φ值作为判据对以上3种参数进行比较。计算结果表明：本滑坡软弱夹层中由于含泥量较大，而且粘塑性较强，屈服抗剪强度和反分析得到的抗剪强度偏差最小，比例抗剪强度偏差最大，峰值抗剪强度居中。并以此3种抗剪强度进行天然状态下滑坡稳定性验算，结果表明选用比例极限抗剪强度与当前滑坡的地质现象不符，选用峰值极限抗剪强度安全储备较低，而选取屈服极限抗剪强度最为合理。用此参数进行设计，滑坡已经得到了良好的治理。在取值研究中认为采用试验与反分析相结合的方法确定滑坡稳定性计算参数是比较合理的。以上结论为滑坡中软弱夹层抗剪强度取值的选择提供了重要的依据。     

水布垭面板堆石坝的三维弹塑性数值分析研究

在建的清江水布垭面板堆石坝高达233 m,是目前同类坝型中最高的.采用MSC.Marc非线性有限元程序,发展了三维子模型法,对该坝进行了三维弹塑性有限元仿真分析,模拟了面板的分缝、坝体材料分区、填筑及蓄水过程,采用双屈服面弹塑性模型模拟堆石体的变形特征.根据数值分析的结果,对坝体和面板的应力变形分布规律进行了探讨.     

GPS广播星历参数拟合算法

介绍了GPS广播星历参数的最小二乘估计方法。推导了相应的计算公式。计算结果表明。文中给出的公式是正确的，其拟合精度以用户距离误差(URE)示时，对预报轨道的损失小于1cm。     

Pseudo‐dynamic seismic response of reinforced concrete frames infilled with non‐structural brick masonry

This paper presents pseudo‐dynamic test results on the in‐plane seismic behaviour of infilled frames. Thirteen single‐storey, single‐bay, half‐size‐scale, reinforced concrete‐frame specimens, most of which infilled with non‐structural masonry made of perforated bricks and cement mortar are tested. The infills are in contact with frames, without any connector; openings are not covered. The frames are different in their strength and details, reinforcement grade, and aspect ratio. Seismic input is the 1976 Tolmezzo (Friuli, Italy) ground acceleration, to which specimens are subjected two times: virgin and damaged by the previous test. The global seismic response of initially virgin infilled specimens considerably differs from that of bare specimens. This follows a dramatic change of properties: compared to a bare frame, the initial stiffness increases by one order of magnitude, and the peak strength more than doubles. The peak drift lessens; however, the displacement ductility demand does not. The energy demand is greater. Nevertheless, the influence of infill decreases as damage proceeds. Displacement time histories of damaged specimens are quite similar. At the local level, infill causes asymmetry and concentration of the frame deformation. Copyright © 2005 John Wiley & Sons, Ltd.     

Seismic response analysis of multidrum classical columns

This paper presents a numerical investigation on the seismic response of multidrum classical columns. The motivation for this study originates from the need to understand: (a) the level of ground shaking that classical multidrum columns can survive, and (b) the possible advantages or disadvantages of retrofitting multidrum columns with metallic shear links that replace the wooden poles that were installed in ancient times. The numerical study presented in this paper is conducted with the commercially available software Working Model 2D?, which can capture with fidelity the sliding, rocking, and slide‐rocking response of rigid‐body assemblies. This paper validates the software Working Model by comparing selected computed responses with scarce analytical solutions and the results from in‐house numerical codes initially developed at the University of California, Berkeley, to study the seismic response of electrical transformers and heavy laboratory equipment. The study reveals that relative sliding between drums happens even when the g‐value of the ground acceleration is less than the coefficient of friction, µ, of the sliding interfaces and concludes that: (a) typical multidrum classical columns can survive the ground shaking from strong ground motions recorded near the causative faults of earthquakes with magnitudes M_w=6.0–7.4; (b) in most cases multidrum classical columns free to dislocate at the drum interfaces exhibit more controlled seismic response than the monolithic columns with same size and slenderness; (c) the shear strength of the wooden poles has a marginal effect on the sliding response of the drums; and (d) stiff metallic shear links in‐between column drums may have an undesirable role on the seismic stability of classical columns and should be avoided. Copyright © 2005 John Wiley & Sons, Ltd.     

西藏直孔水电站大坝混凝土防渗墙超前支护成槽试验研究及施工

在西藏直孔水电站松散砂卵石地层混凝土防渗墙成槽施工中，结合坝基水文地质及工程地质特点，创造性地提出了超前支护成槽方案，通过三维应力模拟和渗透试验，结合现场生产试验，对原方案更进一步完善，在施工中加以应用获得了成功。