超高强混凝土短柱抗震性能的试验研究

通过对12根剪跨比λ=2．0的超高强混凝土短柱在低周反复荷载下抗震性能的试验研究,分析了其破坏形态,并研究了轴压比和配箍率对试件滞回特性和抗震延性的影响,提出了满足一定延性要求（μ△≥3．0）超高强混凝土短柱的轴压比限值和箍筋加密区的最小配箍特征值的建议值。该值可为现行规范的修订提供参考。     

An evaluation of force-based design vs. direct displacement-based design of jointed precast post-tensioned wall systems

The unique features of jointed post-tensioned wall systems, which include minimum structural damage and re-centering capability when subjected to earthquake lateral loads, are the result of using unbonded post-tensioning to attach the walls to the foundation, along with employing energy dissipating shear connectors between the walls. Using acceptance criteria defined in terms of inter-story drift, residual drift, and floor acceleration, this study presents a multiplelevel performance-based seismic evaluation of two five-story unbonded post-tensioned jointed precast wall systems. The design and analysis of these two wall systems, established as the direct displacement-based and force-based solutions for a prototype building used in the PREcast Seismic Structural Systems （PRESSS） program, were performed at 60% scale so that the analysis model could be validated using the PRESSS test data. Both buildings satisfied the performance criteria at four levels of earthquake motions although the design base shear of the direct displacement-based jointed wall system was 50% of that demanded by the force-based design method. The study also investigated the feasibility of controlling the maximum transient inter-story drift in a jointed wall system by increasing the number of energy dissipating shear connectors between the walls but without significantly affecting its re-centering capability.     

Mechanical compression release device in steel bracing system for retrofitting RC frames

1 Introduction Braced steel frames are commonly used to resist seismic loads. Their seismic behavior was extensively studied during the past decades (Bertero et al.., 1989; Roeder, 1989; Jain, 1978). Their design is governed by the buckling behavior of the bracing members (ASCE, 1994,2002; CSA, 1994). To prevent or delay the seismic buckling of compressive members in concentrically braced frames in steel structures, a great number of methods have been proposed. These include the use of sp…     

复杂城区车载激光扫描点云分层路段定位与数据纠正实验研究

高精度的车载点云数据是实现各种城市地物要素提取的前提,但在复杂城市环境下车载作业时信号遮挡、衰减和多径效应频繁发生,进而造成点云数据精度严重降低,如何对复杂环境下的点云数据进行分析和纠正就显得至关重要.现有的质量分析方法多从测距误差、仪器安装误差和数据处理误差方面出发,虽然可以在一定程度上改化数据,但在如何快速定位出分...     

精密单点定位结合EGM2008模型在新疆某河地质断面测量中的应用

针对新疆某河地质断面测量范围大、测区通行困难、测量部位分散、传统控制测量方法工作量大且效率低的问题,在测区每条断面上布设断面基点作为控制点并用GNSS接收机静态观测(无需同步),选用武汉大学开发的Trip2.0软件加载事后精密星历和精密钟差等信息解算静态观测数据得到ITRF框架下的三维坐标,然后采用TBC软件加载EGM2008超高阶地球重力场模型点校正得到控制点的国家平面坐标和正常高。结果表明,Trip2.0软件计算的三维点位中误差最大为0.066 m,点校正坐标转换残差与已知点差值均满足限差要求;该方法平面控制测量工作量比传统方案减少46%,五等水准测量比传统方案减少98%,节约工期约56%。实践表明,采用该方法可快速地实现测区面积大、测点分散、控制点稀少区域的平面及高程控制测量。     

非线性最小二乘超宽带TOA法在室内定位测量中的研究与实现

在现今信息化社会中,人们对于建筑物等室内定位服务的需求日益强烈,超宽带(Ultra Wideband,UWB)定位技术由于其抗多径干扰能力强、系统容量大、传输速率高等特点使之在短距离无线通信以及室内定位等方面受到了广泛的关注。本文利用非线性最小二乘最优估计对超宽带TOA算法进行分析,并通过两组对比实验分别探讨了锚节点的布设形式和目标节点不同位置对定位精度的定量影响。实验表明:最小二乘法能够克服移动中突然的跳点和剧烈的抖动对定位精度的影响,在宽度ω与高度ξ一样的情况下,有一最优间距δ*使得TN定位精度最高;在间距δ与高度ξ一定的情况下,在较为狭窄的室内环境下,ω值越大定位精度越高。     

Flexural performances of prestressed high strength concrete piles reinforced with hybrid GFRP and steel bars

Abstract

This study developed prestressed high-strength concrete (PHC) piles reinforced with high-strength materials (glass fiber-reinforced polymer (GFRP) bars) for flexural performance enhancement. Flexural strengths and behaviors of PHC piles reinforced with hybrid GFRP and steel bars were experimentally investigated, respectively. Large-scale specimens with total lengths of 12,000?mm and diameters of 600?mm were constructed and tested under bending, accompanied by evaluation of effects of non-prestressed reinforcement type and longitudinal reinforcement ratio. J-factors were calculated to evaluate deformability of all the specimens. PHC piles reinforced with GFRP bars were demonstrated to have much higher flexural capacity than those reinforced with steel bars. Moreover, strains at the midspans of cross sections of all the specimens basically conformed to the assumption of plane section. Failure of PHC piles reinforced with GFRP bars was attributable to gradual concrete crushing, while that of PHC piles reinforced with steel bars resulted from steel yielding. Results of this study were expected to provide theoretical basis for wide engineering applications of PHC piles reinforced with hybrid GFRP bars and steel bars in marine structures.     

不同法截面子午线椭球衔接的研究及应用

为了满足高速铁路线路控制网的投影长度变形值不大于10 mm／km的要求,将长线工程线路分成多段并建立各自的法截面子午线椭球．针对相邻法截面子午线椭球的衔接问题,提出交点法线重合的方法,实现椭球变换之后交点位置的一致性,解决线路的衔接问题,从而大大加强法截面子午线椭球理论在工程线路弯曲性、复杂性及长度的适用性．      

雅鲁藏布江河谷加查-米林段沙丘成因

加查-米林段位于雅鲁藏布江河谷中游下段,分布沙丘89片。通过实地考察、遥感卫星影像解译、DEM分析、粒度分析等方法对加查-米林段沙丘成因进行分析。结果表明：依据沙丘沙物质来源可将加查-米林段沙丘划分为河漫滩型沙丘、阶地型沙丘和谷坡型沙丘。河漫滩型沙丘形成与雅鲁藏布江水位关系密切。丰水期洪水淹没河漫滩,泥沙沉积;枯水期水位降低,泥沙出露,经风的吹蚀、搬运、堆积形成河漫滩型沙丘。阶地型沙丘和谷坡型沙丘形成与表层覆盖的黄土层（粉质砂土）破坏有关。雅鲁藏布江不断下切,在阶地及谷坡不同高度残留古河流冲积沙,遭受风蚀后风蚀堆积物形成古沙丘。因环境演变,古沙丘表面沉积黄土,形成致密坚硬的黄土层,不易被风吹蚀,成为古沙丘的保护层。黄土层受风蚀、水蚀及人类活动破坏,导致下伏古沙丘裸露,形成现代流动沙丘。     

潮汐调和分析的一种算法

本文在常规潮汐调和分析方法的基础上，提出了一种由高低潮资料进行潮汐分析的算法。具体计算表明，该算法与现今通用的常规算法（即等间隔最小二乘法）相比，既可大大减少所需原始样本量，在相同记录长度内，是常规算法的三分之一还少，同时减少样本处理的前期工作量；又能保证潮位拟合的精度和预报的可信度，两者精度相当，结果一致。该算法原理简单、实用有效，对于局部样本缺损较易处理，具有实际应用价值。