A laboratory study on capillary sealing efficiency of Iranian shale and anhydrite caprocks

Caprock has the most important role in the long term safety of formation gas storage. The caprocks trap fluid accumulated beneath, contribute to lateral migration of this fluid and impede its upward migration. The rapid upward passage of invasive plumes due to buoyancy pressure is prevented by capillary pressure within these seal rocks. In the present study, two main seal rocks, from the Zagros basin in the southwest of Iran, a shale core sample of Asmari formation and an anhydrite core sample of Gachsaran formation, were provided. Absolute permeabilities of shale and anhydrite cores, considering the Klinkenberg effect, were measured as 6.09 × 10⁻¹⁸ and 0.89 × 10⁻¹⁸ m², respectively. Capillary sealing efficiency of the cores was investigated using gas breakthrough experiments. To do so, two distinct techniques including step by step and residual capillary pressure approaches were performed, using carbon dioxide, nitrogen and methane gases at temperatures of 70 and 90 °C, under confining pressures in the range 24.13–37.92 MPa. In the first technique, it was found that capillary breakthrough pressure of the cores varies in the range from 2.76 to 34.34 MPa. Moreover, the measurements indicated that after capillary breakthrough, gas effective permeabilities lie in range 1.85 × 10⁻²¹ – 1.66 × 10⁻¹⁹ m². In the second technique, the minimum capillary displacement pressure of shale varied from 0.66 to 1.45 MPa with the maximum effective permeability around 7.76 × 10⁻²¹ – 6.69 × 10⁻²⁰ m². The results indicate that anhydrite caprock of the Gachsaran formation provides proper capillary sealing efficacy, suitable for long term storage of the injected CO₂ plumes, due to its higher capillary breakthrough pressure and lower gas effective permeability.     

象山港余流特征数值研究

基于Delft3D-Flow模块建立了象山港海域的三维斜压潮流数值模型,结合实测水文资料,研究了象山港的潮(余)流特征,对欧拉余流场的时空分布进行了定量的比较和分析,并与潮流测站计算分析得到的欧拉余流分布对比,很好的模拟了象山港的余流特征。结果表明:由湾外至湾顶,余流呈减小的趋势,湾外余流最大为33 cm/s,湾顶最小,余流平均仅5 cm/s。垂向上,表层余流大于底层余流,表层余流指向湾外,而底层余流则指向湾内。对比斜压、正压两种模式下的欧拉余流分布,可以看出湾顶附近主要受径流控制,两种模式得到的结果基本一致,口门至西沪港区域受径流和潮流的共同影响,斜压模式更准确地模拟出了水体层化和垂向余环流结构。     

点蚀损伤下桩基式平台腿柱轴压极限承载力研究

采用圆柱体点蚀损伤模型,建立含细观尺度点蚀损伤的桩基式平台腿柱多尺度精细化数值模型,研究壁厚损伤度、点蚀损伤强度以及点蚀体积损伤强度影响平台腿柱轴压极限承载力的规律。研究结果表明,壁厚损伤度及点蚀损伤强度明显削弱平台腿柱的极限强度,且随点蚀损伤强度增大壁厚损伤度的影响加剧;点蚀体积损伤强度由于综合考虑了壁厚损伤度和点蚀损伤强度的耦合因素,相比于独立考虑后两者,其更能合理地描述点蚀损伤对平台腿柱极限强度的影响,故点蚀体积损伤强度体现了点蚀损伤的关键特征。本方法不仅适用于研究点蚀损伤构件的极限承载力,其所提出的点蚀损伤模型的构建方法,可拓展于研究受点蚀损伤的整体平台结构的极限承载力,且确定点蚀体积损伤强度为描述点蚀损伤特征的关键参数后,有望将其用于修正点蚀损伤平台腿柱的承载力设计公式。     

�����������α�����������Ӱ���������������

?????????????α??????????????????????????????????????????????????????鷽??????????в????????????????????о?????????1)?????????????????α?(?????NS??)???????????????????????????????????????????2)?????????????????NS?????????????????????????????????????????????3)????????????????????????????4)?????NE??EW?????????3?????????????????5)?????NS??????????и?????????????????????????????6)??????NE?????????????????????????????????????????7) ??????????????????????????????????????????????????     

基于FLAC3D数值模拟的老采空区剩余沉降量分析计算—以山东枣庄安博化工项目为例

空区的剩余沉降值计算是采空区地质灾害危险程度一种定量分析的方法,利用FLAC3D直接模拟早期采煤形成的老采空区塌陷状态,计算出老采空区的剩余沉降量。以山东枣庄安博化工项目为例,首先采用物探、钻探手段探测老采空区深度、顶板塌落与破碎状况以及地质地层信息,其次结合岩心试验地质材料参数结果进行FLAC3D模拟,计算自重作用下采空区剩余沉降量,以及加载建筑后老采空区剩余沉降值,对比了传统概率积分法计算沉降值,结果基本一致,说明计算方法是可靠的。最后分析加载应力与破碎带剩余沉降值的数量关系。为老采空区土地稳定性评估以及剩余沉降量的计算方法提供科学依据与借鉴。     

基于坐标转换的高铁平面精测网复测稳定性分析方法探讨

首先介绍了现有各级平面精测网复测稳定性分析的常规方法,然后结合GRP网中判别CPⅢ点稳定性的方法,尝试使用三参数坐标转换进行高铁平面精测网复测稳定性分析,最后以某高铁CPI控制网实测数据为例进行分析。结果表明,不能完全使用三参数坐标转换代替常规方法进行精测网的稳定性分析,但可在使用坐标转换后的点位残差进行稳定性评价时,结合常规法进行综合分析,可提高常规法分析判别效率。     

A diagnostic analysis on the effect of the residual layer in convective boundary layer development near Mongolia using 20th century reanalysis data

Although the residual layer has already been noted in the classical diurnal cycle of the atmospheric boundary layer,its effect on the development of the convective boundary layer has not been well studied. In this study, based on 3-hourly20 th century reanalysis data, the residual layer is considered as a common layer capping the convective boundary layer. It is identified daily by investigating the development of the convective boundary layer. The region of interest is bounded by(30°–60° N, 80°–120° E), where a residual layer deeper than 2000 m has been reported using radiosondes. The lapse rate and wind shear within the residual layer are compared with the surface sensible heat flux by investigating their climatological means, interannual variations and daily variations. The lapse rate of the residual layer and the convective boundary layer depth correspond well in their seasonal variations and climatological mean patterns. On the interannual scale, the correlation coefficient between their regional averaged(40°–50°N, 90°–110° E) variations is higher than that between the surface sensible heat flux and convective boundary layer depth. On the daily scale, the correlation between the lapse rate and the convective boundary layer depth in most months is still statistically significant during 1970–2012. Therefore, we suggest that the existence of a deep neutral residual layer is crucial to the formation of a deep convective boundary layer near the Mongolian regions.     

Finding the most variable stars in the Orion Belt with the All Sky Automated Survey

We look for high‐amplitude variable young stars in the open clusters and associations of the Orion Belt. We use public data from the ASAS‐3 Photometric V ‐band Catalogue of the All Sky Automated Survey, infrared photometry from the 2MASS and IRAS catalogues, proper motions, and the Aladin sky atlas to obtain a list of the most variable stars in a survey area of side 5° centred on the bright star Alnilam (ε Ori) in the centre of the Orion Belt. We identify 32 highly variable stars, of which 16 had not been reported to vary before. They are mostly variable young stars and candidates (16) and background giants (8), but there are also field cataclysmic variables, contact binaries, and eclipsing binary candidates. Of the young stars, which typically are active Herbig Ae/Be and T Tauri stars with Hα emission and infrared flux excess, we discover four new variables and confirm the variability status of another two. Some of them belong to the well known σ Orionis cluster. Besides, six of the eight giants are new variables, and three are new periodic variables (© 2010 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Distribution and invasion of Spartina alterniflora within the Jiaozhou Bay monitored by remote sensing image

Spartina alterniflora as an alien invasive plant, poses a serious threat to the ecological functions of the coastal wetland of the Jiaozhou Bay. As of 2019, the distribution area of S. alterniflora in the Jiaozhou Bay has reached more than 500 hm². For this reason, combined with field surveys, remote sensing monitoring of the invasion S.alterniflora in the Jiaozhou Bay has been carried out. To accurately identify S. alterniflora within the Jiaozhou Bay coastal wetland, we used a new m...     

柴达木盆地北缘东段石炭纪至白垩纪构造演化 模式及地层缺失原因探讨

为了明确柴达木盆地北缘东段石炭纪至白垩纪盆地演化历史,分析石炭系—侏罗系缺失的原因,本文重新确定了石炭系和侏罗系残余地层分布范围,并根据平衡剖面恢复和断裂落差计算,分析了主要断裂的活动特征,提出了柴北缘东段石炭纪至白垩纪的构造演化模式。应用有限单元法模拟了柴北缘东段印支期(三叠纪)、燕山早期(早—中侏罗世)、燕山晚期(晚侏罗世—白垩纪)的应力场,对构造演化模式加以验证。研究结果表明:柴北缘东段自石炭纪至白垩纪经历了石炭纪—二叠纪伸展、三叠纪挤压褶皱、早—中侏罗世断陷、晚侏罗世—白垩纪早期挤压坳陷和白垩纪末挤压反转五个构造演化阶段。三叠纪,柴北缘东段在印支期发育两排近东西走向的背斜凸起,造成石炭系—二叠系在各地区遭受不同程度的剥蚀;侏罗纪—白垩纪早期,欧南地区为继承性隆起区,未完全接受沉积;白垩纪末,受燕山晚期旋回影响,构造反转,逆冲断裂复活,绿梁山、锡铁山、埃姆尼克山、欧隆布鲁克山等主要山体隆升,遭受剥蚀。