研究“源兆”的若干问题及途径分析

从位场理论的观点讨论了场和源的概念,建议将“场兆”改称为构造前兆,将“源兆”称为震源前兆。文中还分析了震源体与各种前兆观测方法探测的深度,并根据地磁与重力观测方法不同的物理基础和地质基础,指出震磁效应对于研究震源前兆的特殊意义,文中还介绍了１９７６唐山地震观测到震源前兆的部分实际地磁资料。     

Carbonyl products of the gas phase reaction of ozone with 1,1-disubstituted alkenes

Carbonyl products have been identified and their formation yields measured in experiments involving the gas phase reaction of ozone with 1,1-disubstituted alkenes at ambient T and p=1 atm. of air. Sufficient cyclohexane was added to scavenge the hydroxyl radical in order to minimize OH-alkene and OH-carbonyl reactions. Formation yields (carbonyl formed/ozone reacted) of primary carbonyls were close to the value of 1.0 that is consistent with the mechanism: O₃+R₁R₂C=CH₂ (HCHO+R₁R₂COO)+(1–)(R₁COR₂+H₂COO) where formaldehyde and the ketone R₁ COR₂ are the primary carbonyls and R₁R₂COO and H₂COO are the corresponding biradicals. Measured values of were 0.58–0.82 and indicate modest preferential formation of formaldehyde and the disubstituted biradical as compared to the ketone and the biradical H₂COO. Carbonyls other than the primary carbonyls were identified. Their formation is discussed in terms of subsequent reactions of the disubstituted biradicals R₁R₂COO. Similarities and differences between disubstituted and monosubstituted biradicals are outlined.     

Rate constants for the reactions of the NO3 radical with HCOOH/HCOO− and CH3COOH/CH3COO− in aqueous solution between 278 and 328 K

The kinetics of the aqueous phase reactions of NO₃ radicals with HCOOH/HCOO^– and CH₃COOH/CH₃COO^– have been investigated using a laser photolysis/long-path laser absorption technique. NO₃ was produced via excimer laser photolysis of peroxodisulfate anions (S₂O ₈ ^2– ) at 351 nm followed by the reactions of sulfate radicals (SO ₄ ^– ) with excess nitrate. The time-resolved detection of NO₃ was achieved by long-path laser absorption at 632.8 nm. For the reactions of NO₃ with formic acid (1) and formate (2) rate coefficients ofk ₁=(3.3±1.0)×10⁵ l mol^–1 s^–1 andk ₂=(5.0±0.4)×10⁷ l mol^–1 s^–1 were found atT=298 K andI=0.19 mol/l. The following Arrhenius expressions were derived:k ₁(T)=(3.4±0.3)×10¹⁰ exp[–(3400±600)/T] l mol^–1 s^–1 andk ₂(T)=(8.2±0.8)×10¹⁰ exp[–(2200±700)/T] l mol^–1 s^–1. The rate coefficients for the reactions of NO₃ with acetic acid (3) and acetate (4) atT=298 K andI=0.19 mol/l were determined as:k ₃=(1.3±0.3)×10⁴ l mol^–1 s^–1 andk ₄=(2.3±0.4)×10⁶ l mol^–1 s^–1. The temperature dependences for these reactions are described by:k ₃(T)=(4.9±0.5)×10⁹ exp[–(3800±700)/T] l mol^–1 s^–1 andk ₄(T)=(1.0±0.2)×10¹² exp[–(3800±1200)/T] l mol^–1 s^–1. The differences in reactivity of the anions HCOO^– and CH₃COO^– compared to their corresponding acids HCOOH and CH₃COOH are explained by the higher reactivity of NO₃ in charge transfer processes compared to H atom abstraction. From a comparison of NO₃ reactions with various droplets constituents it is concluded that the reaction of NO₃ with HCOO^– may present a dominant loss reaction of NO₃ in atmospheric droplets.     

热液成矿作用的地质地球化学动力学——以胶东牟平-乳山金矿带为例

通过对胶东牟平—乳山热液脉状金,铅锌矿床成矿动力学控制规律的研究,说明了建立热液成矿反应体系的方法,并得出以下认识:（1）区域断裂构造活动,通过影响成矿反应体系的热力学性质和条件,控制元素的富集和分散。（2）热液成矿过程中容矿断裂活动可划分为两种作用方式:脆性破裂和韧—脆性张开,构成热液成矿的两种构造动力学环境。（3）热液成矿反应体系是一种开放的动态的热力学体系。断裂的脆性破裂阶段,使体系处于强烈的过饱和状态,矿质在远离平衡状态下快速结晶,加剧物质分异;在脆—韧性张开阶段,矿质在接近平衡态体系中缓慢晶出。（4）热液演化晚期,金在残余溶液中富集;当断裂再次发生构造脉动震颤时,早期形成的块状黄铁矿矿石碎裂,富金溶液充填其中,形成含裂隙金和晶隙金的富矿石。成矿体系热力学演化与构造动力学条件有利的匹配控制着富矿石的形成。     

云南兰坪-思茅盆地生物地球化学找钾技术方法研究初探

在生物地球化学和“深穿透”理论的指导下,在兰坪-思茅盆地勐野井钾盐矿区及周边开展了生物地球化学找钾技术方法的探索性研究。沿江城县勐野井钾盐矿区及周边一线,对乔木类植物叶子进行了取样,分析,数据处理,特征指标筛选,获得了研究区植物样品主量和微量组分含量背景值,初步圈定了异常区,与以往圈定的找钾远景区较吻合。该区生物地球化学找钾技术取得较好的效果,今后还需扩大采样区域,获得更多样本数据,将找钾特征指标及其异常值的阈值进一步补充完善。     

Na depletion in modern adakites via melt / rock reaction within the sub-arc mantle

Interaction between slab-derived melt and mantle peridotite and the role of slab melt as a metasomatizing agent in the sub-arc mantle is being increasingly recognized. Adakite, the slab melt erupted on the surface, usually exhibits anomalously high MgO, CaO, Cr and Ni contents that indicate interaction with mantle peridotitite. Here we note that Cenozoic adakites have Na₂O contents below 5.8 wt.% with ∼95% samples lower than 5.0 wt.%, and are generally depleted in this component relative to experimental basalt partial melts (mostly beyond 5.0 wt.% and up to 9.0 wt.% Na₂O) produced under 1.5-3.0 GPa conditions that are most relevant to adakite production. We interpret the adakite Na depletion to be also a consequence of the melt / rock reaction that takes place within the hot mantle wedge. During ascent and reaction with mantle peridotite, primary adakite melts gain mantle components MgO, CaO, Cr and Ni but lose Na₂O, SiO₂ and perhaps K₂O to the mantle, leading to Na-rich mantle metasomatism. Selective assimilation of predominately mantle clinopyroxene, some spinel and minor olivine at high T/P has been considered to be an important process in producing high-Mg adakites from primary low-Mg slab melts [Killian, R., Stern, C. R., 2002. Constraints on the interaction between slab melts and the mantle wedge from adakitic glass in peridotite xenoliths. Eur. J. Mineral. 14, 25-36]. In such a process, Na depletion in the assimilated melt is the result of dilution due to the increase in melt mass. Phase relationships in the reaction system siliceous melt + peridotite and quantitative calculation suggest that assimilation of mantle clinopyroxene, olivine and spinel and fractional crystallization of sodic amphibole and orthopyroxene, under conditions of moderate T/P and increasing melt mass, is also an important process that modifies the composition of adakites and causes the Na depletion.     

Increasing critical sensitivity of the Load/Unload Response Ratio before large earthquakes with identified stress accumulation pattern

The Load/Unload Response Ratio (LURR) method is proposed for short-to-intermediate-term earthquake prediction [Yin, X.C., Chen, X.Z., Song, Z.P., Yin, C., 1995. A New Approach to Earthquake Prediction — The Load/Unload Response Ratio (LURR) Theory, Pure Appl. Geophys., 145, 701–715]. This method is based on measuring the ratio between Benioff strains released during the time periods of loading and unloading, corresponding to the Coulomb Failure Stress change induced by Earth tides on optimally oriented faults. According to the method, the LURR time series usually climb to an anomalously high peak prior to occurrence of a large earthquake. Previous studies have indicated that the size of critical seismogenic region selected for LURR measurements has great influence on the evaluation of LURR. In this study, we replace the circular region usually adopted in LURR practice with an area within which the tectonic stress change would mostly affect the Coulomb stress on a potential seismogenic fault of a future event. The Coulomb stress change before a hypothetical earthquake is calculated based on a simple back-slip dislocation model of the event. This new algorithm, by combining the LURR method with our choice of identified area with increased Coulomb stress, is devised to improve the sensitivity of LURR to measure criticality of stress accumulation before a large earthquake. Retrospective tests of this algorithm on four large earthquakes occurred in California over the last two decades show remarkable enhancement of the LURR precursory anomalies. For some strong events of lesser magnitudes occurred in the same neighborhoods and during the same time periods, significant anomalies are found if circular areas are used, and are not found if increased Coulomb stress areas are used for LURR data selection. The unique feature of this algorithm may provide stronger constraints on forecasts of the size and location of future large events.     

GPS高程拟合的方式及可靠性分析

在范围不大的区域中，高程异常具有一定的几何相关性，GPS高程拟合就是利用这一原理，求解正常高。在解析法求解过程中，首先用最小二乘法确定拟合数学模型的系数，在此基础上计算出待测点的高程异常值。通过实例验证：GPS高程拟合的精度主要取决于GPS大地高的精度、重合点正常高的精度、重合点的分布及拟模型的选择。一般在重合点数量充足且分布均匀的情况下，GPS高程拟合的精度可达到四等水准网的精度要求。