Interpretation of single-well tracer tests using fractional-flow dimensions. Part 1: Theory and mathematical models

Generalized equations using fractional-flow dimensions were derived to estimate the Darcy and seepage velocities obtained from the point-dilution and the single-well injection-withdrawal field tests conducted in fractured-rock aquifers. Seepage velocities can only be estimated from single-well tests if the hydraulic conductivity and the hydraulic gradient are known a priori. However, if a radial-convergent test is also performed between two boreholes, the kinematic porosity can be estimated and be used to estimate the seepage velocity from the single-well test results. To apply the generalized equations, the flow dimension and the extent of the flow region must be known. Therefore, the generalized radial flow (GRF) model of Barker (1988; a generalized radial flow model for hydraulic tests in fractured rock. Water Resour Res 24(10):1796–1804) is used to estimate the flow dimension because of its wide range of applications. A pumping test performed on the boreholes will yield an estimate of the fractional-flow dimension by applying the GRF model. Electronic Publication     

Premier pôle paléomagnétique,d'âge Moscovien contraint par un test du pli,obtenu dans le bassin d'Illizi (Craton saharien,Algérie)First palaeomagnetic pole,of Moscovian age constrained by a fold test,in the Illizi Basin (Saharan Craton,Algeria)

Palaeomagnetic study, carried out in the Moscovian (～305 Ma) formation in the Edjeleh anticline, shows the existence of three magnetisation components. Two of them are probably Cenozoic and Permian remagnetisations. The third component determined by both well defined ChRMs and remagnetisation circles analysis passes the fold test. Because the folding started before or during the Stephano-Autunian, this third component is the primary magnetisation. Its palaeomagnetic pole (28.3°S, 58.9°E), close to other poles from the Saharan platform obtained from neighbouring periods but without palaeomagnetic tests, confirms the age of these last data. To cite this article: B. Bayou et al., C. R. Geoscience 334 (2002) 81–87.     

均匀土-箱基-结构相互作用体系的计算分析

采用通用有限元程序ANSYS，针对捱动台试验中的均匀土-箱基-结构试验进行了三维有限元分析，计算中土体的本构模型采用等效线性模型，利用面-面接触单元考虑土体与基础交界面的状态非线性。计算表明，基础底面和土体发生滑移，基础侧面和土体之间发生了滑移和脱离，上部结构柱顶加速度反应主要由基础转动引起的摆动分量组成，通过与试验结果的对照研究，二者得出的规律基本一致，验证了采用的计算模型与分析方法的合理性，为进一步计算研究和实际工程应用奠定了基础。     

A comparison of tectonic ambient shear stress value in China with that in western USA

Introduction The stress status of the earths crust is closely related to global structure, the direction of plate movement, the drive mechanism of plate, earthquake cause, etc. Therefore the researches of the stress status of the earths crust and the process of dynamic evolution are paid a great attention to by many people around the world (Zoback, Zoback, 1980; Zoback, et al, 1989; Zoback, 1989; Spence, 1997; Fuchs, 1997; Plenefish, Bonjer, 1997; Muller, et al, 1997; XU, et al, 1989; WAN…     

Torsional vibrations of elastic foundation on saturated media

A comprehensive analytical solution is developed to examine the torsional vibration of an elastic foundation on a semi-infinite saturated elastic medium for the first time. First, the governing equations of saturated media are solved by use of Hankel transform techniques. Then, based on the assumption that the contact between the foundation and the half-space is perfectly bonded, this dynamic mixed boundary-value problem can lead to dual integral equations, which are further reduced to the standard Fredholm integral equations of the second kind and solved by numerical procedures. Numerical examples are given at the end of the paper. The numerical results indicate that the response of the elastic foundation strongly depends on the material and geometrical properties of both the saturated soil-foundation system and the load acting on the foundation. In most of the cases, the dynamic behavior of an elastic foundation on saturated media significantly differs from that of a rigid plate bearing on the elastic half-space.     

桥梁隔震体系振动台试验研究(III)——测试结果分析

根据前文所述的测试结果 ,本文主要分析了隔震构造、橡胶支座水平刚度、地震输入频谱特性、地震烈度、输入方向、桥墩高度、桥墩嵌固程度等因素对隔震效果的影响 ,揭示了隔震体系耗散地震能量输入的机理 ,所得出的结论对工程实践具有指导意义。     

中国与美国西部平均构造剪应力值的比较

提出了一种估计一个地区平均构造剪应力值的方法．用这种方法，选取哈佛大学公布的1977～1999年共15 993次地震的矩张量数据，估计了美国西部19个地区、中国和邻区43个地区(每个地区为1010范围)的平均环境剪应力值．结果表明，美国西部南加州西部海域和南加州应力最高，达13.7和12.0 MPa，然后向北、向南和向东逐渐递减，但最小也达8.7 MPa，是最高值的63%．中国新疆西北部地区和西藏察隅地区应力水平最高，达17.2和12.9 MPa，比美国高．中国的华北、云南、四川、台湾和美国南加州的应力水平差不多．中国南北地震带的应力水平为13 MPa左右，比南加州略高．两个重要地区的平均剪应力值分布图，提供了地学的基本数据．这些结果可为研究地震活动的大背景提供依据，对研究强地面运动参数(如峰值加速度及反应谱等)的衰减关系也是有用的．      

Hybrid vibration experiments with a bridge foundation system model

In order to improve seismic design technology of bridges, it is necessary to evaluate the vibration characteristics of a bridge–soil system that consists of soil, foundation structure, pier and superstructure. However, there have been few experimental studies on seismic behavior of bridge–soil system. In this paper, we conducted the hybrid vibration experiment on seismic behavior of bridge–soil system, and examined the applicability of hybrid vibration experiment to study seismic response of bridge–soil system. Based on the experiment results, seismic response of bridge was quantitatively studied.     

A method to estimate hydraulic conductivity while drilling

A field test and analysis method has been developed to estimate the vertical distribution of hydraulic conductivity in shallow unconsolidated aquifers. The field method uses fluid injection ports and pressure transducers in a hollow auger that measure the hydraulic head outside the auger at several distances from the injection point. A constant injection rate is maintained for a duration time sufficient for the system to become steady state. Exploiting the analogy between electrical resistivity in geophysics and hydraulic flow two methods are used to estimate conductivity with depth: a half-space model based on spherical flow from a point injection at each measurement site, and a one-dimensional inversion of an entire dataset.

The injection methodology, conducted in three separate drilling operations, was investigated for repeatability, reproducibility, linearity, and for different injection sources. Repeatability tests, conducted at 10 levels, demonstrated standard deviations of generally less than 10%. Reproducibility tests conducted in three, closely spaced drilling operations generally showed a standard deviation of less than 20%, which is probably due to lateral variations in hydraulic conductivity. Linearity tests, made to determine dependency on flow rates, showed no indication of a flow rate bias. In order to obtain estimates of the hydraulic conductivity by an independent means, a series of measurements were made by injecting water through screens installed at two separate depths in a monitoring pipe near the measurement site. These estimates differed from the corresponding estimates obtained by injection in the hollow auger by a factor of less than 3.5, which can be attributed to variations in geology and the inaccurate estimates of the distance between the measurement and the injection sites at depth.     

结构振动控制的半主动磁流变质量驱动器(MR-AMD)

本文首先提出了一种新型的半主动磁流变质量驱动器（MR－AMD），该装置用磁流变驱动器替代AMD的液压驱动系统；其次采用所提出的半主动控制算法仿真分析了MR－AMD用于结构振动控制的有效性；第三，比较了半主动质量驱动器（MR－AMD）、调谐质量阻尼器（TMD）及主动质量驱动器（AMD）对同一模型结构的控制效果。分析结果表明，MR－AMD作为一种半主动质量驱动器有效地降低了结构的反应，其控制效果虽然不如具有相同质量块参数的AMD但却优于TMD，且同AMD一样具有较宽的有效频带范围。