Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

夏、冬两季长江口及邻近海域悬浮物的分布特征及其沉积量

利用2001年7～8月 ,2002年1月两个航次的悬浮物浓度资料 ,并参考其它水文参数 ,简要分析长江口及邻近海域悬浮物的分布特征 :无论夏季还是冬季 ,长江入海悬浮物总是向东南方输运 ;冬季由于再悬浮作用显著 ,悬浮物浓度明显高于夏季 ,且南北分布范围也明显增大 ,垂向分布均匀。同时采用数值模拟的海流流速值和观测的悬浮物浓度值计算悬浮物的断面通量 ,并最终得计算区悬浮物夏、冬两季的沉积量 ,夏、冬季长江口及邻近海域悬浮物的沉积量分别为0.79×108t,1.44×108t。     

东太平洋多金属结核分布的二维趋势面分析

对规则网的 469个测站的多金属结核丰度和 93个测站的 Mn、 Cu、 Co、 Ni元素进行趋势面分析 ,经 F检验 ,各变量的变异性显著 ,拟合度较低 ,表明多金属结核丰度及 Mn、Cu、Co、Ni金属元素的控制因素比较复杂。趋势面分析结果与相关分析结果一致 ,Mn、Cu、Ni元素有极相似的趋势特征 ,有两个轴向分布 ,一个为东西向轴 ,高值区在东部 ,另一个为北西向轴 ,高值区在北西部 ;结核丰度与 Co也有极相似的趋势特征 ,高值区在西部。应用逐次趋势面分析的结果将结核丰度的地质特征分解成各种简单控制因素的叠加 ,使对多金属结核的控矿因素、分布规律和物质来源的研究方法多样化     

16米风化砂回填地基的深层振密加固

结合北方某重力式深水 ( -1 6.0 m)码头沉箱后壁 1 4.5 m范围的回填风化砂经深层振密处理这一工程实例 ,介绍了回填砂振密的技术要求、施工工艺和方法及振密效果的检测。同时对施工与检测中的某些技术问题提出了自己的看法。     

中国海区区域地质编图中重磁图的编制方法

本文简要介绍了局控项目《中国海区１∶５０万区域地质编图（大连幅）》重力异常图、磁力异常图的编制过程，给出了一种以计算机为手段、实现编图自动化的新方法，并分析了该方法与以往编图方法的不同和优点，以国际分幅在中国海区开展区域地质编图尚属首次，在既无海区地质调查规范，又无海区地质调查编图规范的情况下，这一工作无异具有开创性。从理论上系统总结出一套切实可行的编图方法，对于编制中国海区区域地质调查编图规范以     

Analytic Solution of Interaction Between Surface Waves and Floating Elastic Plates with Elastic End-Restraints

Based on the dynamic theories of water waves and Mindlin plates,the analytic solution of interaction between surface waves and two-dimensional floating elastic plates with edge-restraint is constructed by use of the Wiener-Hopf technique.Firstly,without regard for elastic edge restraint,the wave-induced responses of elastic floating plate analyzed by the present method are in good agreement with the results from literature and experimental results.Therefore,it can be shown that the present method is valid.Secondly,three end-restraint cases(i.e.,the left-end elastic restraints,the both-end elastic restraints,and the right-end elastic restraints)are proposed to reduce the vibration of floating plates,in which the spring is used to connect the sea bottom and the floating plate's left(or right)edge.The relations between the spring stiffness and the parameters of wave-induced responses of floating plates are discussed.Moreover,the effective method to reduce the vibration of floating elastic plates can be obtained through comparison.     

走航测深数据的自动采集

本文介绍应用IBM微机实现走航实时水深及定位数据的自动采集系统。给出了联机系统方框图及采集、传送数据的程序流程图。并对IBM-PC/XT微机与测深仪之间的接口、数码转换和数据处理作了简要的叙述。     

中华鲟配合饲料适宜蛋白质含量及最佳蛋白能量比研究

以酪蛋白和明胶为蛋白源 ,添加豆油、鱼油、糊精、纤维素以及适量的维生素和矿物质混合剂配制试验饲料 ,饲料配成5个蛋白质水平 ,每个蛋白水平分别包括5个能量级 ,以体质量增长倍数、蛋白质效率和饲料系数为评判依据 ,对体质量为8.73g±0.79g的中华鲟(Acipensersinensis)的适宜蛋白质含量及其蛋白能量比进行了研究。经过为期8周的试验 ,结果表明 :中华鲟幼鲟配合饲料中的适宜蛋白质含量范围为35.7%～41.8% ,饲料的最佳蛋白能量比范围为21.85～30.05ng/J。当试验饲料蛋白质含量为40.3% ,蛋白能量比为27.85ng/J时 ,试验鲟鱼获得最大体质量增长倍数为11.60±1.20,最低的饲料系数为1.68±0.23,以及最高的蛋白质效率为1.58%±0.14%。     

北太平洋宽吻海豚正常生理指标数值的算法

连续5年对青岛海豚表演馆中北太平洋宽吻海豚(Tursiops gille Dall)进行现场实验和行为学研究，获取了大量的生理指标数据，运用不同的分析和计算方法对所得数据进行了筛选、剔除及处理，确立了海豚各生理指标的正常闽值和范围确定的方法，从而为准确了解海豚机体的生理状况、疾病诊断及治疗奠定了基础。