冲绳海槽南部沉积层序的粒度特征

对取自冲绳海槽南部的A2 3孔经前处理后的沉积物样品进行了粒度测试,探讨了陆源沉积层序的粒度特征。沉积物平均粒径、分选系数、偏态、峰态等粒度参数的变化显示出A2 3孔的沉积层序以 4 0 0cm为界可分为上、下两段,下段各参数稳定,代表了比较稳定的水动力条件的沉积环境;上段则波动较大,小规模浊流沉积频繁发育,暗示了不稳定的沉积环境。浊流层内粗粒与细粒组分含量及粒度分布的变化具有明显的规律性。通过分析A2 3孔陆源沉积层序的各沉积参数特征,认为冲绳海槽南部的沉积环境和动力在时间尺度上有较大的变化,东海陆架物质向南部海槽的输运可能是以峡谷为通道的重力作用引起的床底沉积作用为主。另外,对陆源碎屑和全样粒度结果的对比,显示了前处理方法对于海洋沉积物粒度分析的重要性.     

冠县引黄井渠结合灌区机井建设浅议

针对目前冠县引黄井渠结合灌区机井建设发展中主要存在机井发展不平衡、机井退化、老化、成井质量差等问题，因地制宜，提出了今后灌区发展机井建设的具体措施。     

冀北地区金矿床He、Ar、Pb同位素组成及其成矿物质来源

成矿物质来源一直是成矿理论研究和找矿实践的焦点问题。选择了冀北地区3个幔枝构造金矿集中区11个金矿床黄铁矿及部分围岩进行了He、Ar同位素测定。研究表明,冀北地区主要金矿的3He/4He的值域为(0.93～7.30)×10-6,平均3.55×10-6;R/Ra=0.66～4.93,平均2.53;40Ar/36Ar=426～2073,40Ar平均为8.20×10-7cm3/g,4He/40Ar平均为2.17。矿区外围片麻岩和花岗岩的3He/4He值仅为(0.001～0.55)×10-6,反映来源上有明显差别。3He和4He在He同位素浓度图上落于地幔区附近。64个Pb同位素数据表现为矿质以幔源为主,确有部分壳源物质加入。研究认为,本区成矿物质应源于地球深部,随地幔柱多级演化,深部成矿流体由地球深部迁移到浅部,期间不可避免地存在壳幔流体的混合作用,故其值域往往界于地幔和地壳之间。     

高温高压下含水矿物脱水对斜长岩纵波速度的影响

在1GPa、室温至880℃条件下对斜长岩的纵波速度进行了测量，并对实验产物进行了鉴定分析，讨论了含水矿物脱水对岩石纵波速度的影响。实验结果表明，在680℃左右，由于斜长岩中的含水矿物绢云母和黝帘石开始脱水，矿物脱水产生的流体及其所引起岩石结构的变化可使岩石纵波速度降低10％左右。这意味着通过矿物脱水这一机制可以形成壳内低速层。     

盆地岩石圈结构与油气成藏及分布

本文综述了大陆岩石圈研究现状和克拉通盆地、裂谷盆地和前陆盆地的岩石圈结构特征,指出在古裂谷、褶皱带或区域性深断裂等陆壳构造薄弱带上发育起来的多期叠合盆地,具有很好的含油气前景。大型含油气盆地往往存在地幔上隆、地壳减薄和地壳内低速层,盆地基底沉降与盖层沉积厚度较大。适度的后期构造活动改造和岩浆活动有利于沉积盆地内油气生成与保存。     

略阳煎茶岭铜镍硫化物矿床Re—Os同位素年龄及其地质意义

采用矿石Re-Os同位素方法对陕西省煎茶岭硫化镍矿床矿石进行了成矿年代学研究,获得了878士27 Ma(1σ)的等时线年龄,首次厘定了该矿床成矿时代为新元古代,成岩成矿基本同时.通过对878 Ma硫化镍矿石初始Re-Os同位素体系的γOs计算和Re/Os值分析表明,其yOs和Re/Os值变化范围大,深部条带状矿石的Re/Os值仅为0.05,yOs为-6.70;块状矿石的Re/Os值范围为4.24～24.43,γOs为-15.37～+280.65,说明成矿过程中有壳源物质的混染;两件样品的γOs为负值(-15.37,-6.70),可能指示其超镁铁质岩浆来源于Re亏损地幔.煎茶岭超基性岩体年龄及其镍矿石的Re-Os等时线年龄与扬子克拉通北缘火山岩浆活动时间相对应,它们是扬子克拉通西北缘晋宁期构造岩浆成矿作用的产物.     

试论火山岩储层的类型及其成因特征

本文在总结前人研究的基础上，结合胜利及辽河油田最新资料，提出了一种火山岩油气藏储层分类方案，共分为火山熔岩型、火山碎屑岩型和潜火山岩型3种类型。其中火山碎屑岩型又可分为正常火山碎屑岩型和火山碎屑沉积岩型两种亚类型；潜火山岩型分为隐爆角砾岩型和蚀变岩型两种亚类型。文中结合实例对各种类型储层的成因机制、空间展布特点以及储集性的变化特征进行了阐述和讨论。     

韧性剪切带的变形变质与同构造熔融作用——以中祁连地块宝库河韧性走滑剪切带为例

宝库河韧性剪切带是发育在中祁连地块北缘上的一条向北陡倾,走向近东西,宽约6 km的右行平移型韧性剪切带.剪切带内岩石原岩为泥质岩、基性岩和花岗岩,变质程度达角闪岩相,变形变质温度在685～763±46℃之间,压力在0.62～0.83±0.13 GPa范围内.其内长英质条带非常发育,规模变化较大,分布局部相对集中且受剪切带控制,走向与剪切带一致,平行于叶理,孤立无根,并在后期递进变形过程中发生不同程度的糜棱岩化、布丁化和褶皱,主要成分为长石和石英,明显不同于韧性剪切前或后侵入的花岗岩脉或岩体.长英质条带特征、REE配分模式及剪切带内岩石的变形变质温度说明剪切带内发育的长英质条带与基体是同源的,是在剪切应变过程中剪切热使围岩内部分物质发生动态熔融形成的,是同构造熔融作用的产物.     

The importance of plant root characteristics in controlling concentrated flow erosion rates

While it has been demonstrated in numerous studies that the aboveground characteristics of the vegetation are of particular importance with respect to soil erosion control, this study argues the importance of separating the influence of vegetation on soil erosion rates into two parts: the impact of leaves and stems (aboveground biomass) and the influence of roots (belowground biomass). Although both plant parameters form inseparable constituents of the total plant organism, most studies attribute the impact of vegetation on soil erosion rates mainly to the characteristics of the aboveground biomass. This triggers the question whether the belowground biomass is of no or negligible importance with respect to soil erosion by concentrated flow. This study tried to answer this question by comparing cross‐sectional areas of concentrated flow channels (rills and ephemeral gullies) in the Belgian Loess Belt for different cereal and grass plant densities. The results of these measurements highlighted the fact that both an increase in shoot density as well as an increase in root density resulted in an exponential decrease of concentrated flow erosion rates. Since protection of the soil surface in the early plant growth stages is crucial with respect to the reduction of water erosion rates, increasing the plant root density in the topsoil could be a viable erosion control strategy. Copyright © 2003 John Wiley & Sons, Ltd.     

Mechanisms of riverbank failure along the Arno River,central Italy

Riverbanks along the Arno River have been investigated with the aims of de?ning the main mechanisms of failure and retreat, their spatial distribution, and their causes. Geomorphological aspects were investigated by a reconnaissance of riverbank processes, for a number (26) of representative sites. Laboratory and in situ tests were then performed on a selected number of riverbanks (15). Based on the material characteristics, six main typologies of riverbanks have been de?ned, with homogeneous ?ne‐grained and composite banks representing the most frequent types. Slab‐type failures are the most frequent mechanism observed on ?ne‐grained banks, while cantilever failures prevail on composite banks. The role of river stage and related pore water pressure distributions in triggering the main observed mechanisms of failure has been investigated using two different types of stability analysis. The ?rst was conducted for 15 riverbanks, using the limit equilibrium method and considering simpli?ed hypotheses for pore water pressure distribution (annulment of negative pore pressures in the portion of the bank between low water stage and peak stage). Stability conditions and predicted mechanisms of failure are shown to be in reasonably good agreement with ?eld observations. Three riverbanks, representative of the main alluvial reaches of the river, were then selected for a more detailed bank stability analysis, consisting of: (a) de?nition of characteristic hydrographs of the reach with different return periods; (b) modelling of saturated and unsaturated ?ow using ?nite element seepage analysis; and (c) stability analysis with the limit equilibrium method, by adopting pore water pressure values derived from the seepage analysis. The results are compared to those obtained from the previous simpli?ed analysis, and are used to investigate the different responses, in terms of stability, to different hydrological and riverbank conditions. Copyright © 2003 John Wiley & Sons, Ltd.