Room-temperature equation of state of Li<Subscript>2</Subscript>VOSiO<Subscript>4</Subscript> up to 8.5 GPa

High-pressure single-crystal X-ray diffraction measurements of lattice parameters of the compound Li₂VOSiO₄, which crystallises with a natisite-type structure, has been carried out to a pressure of 8.54(5) GPa at room temperature. Unit-cell volume data were fitted with a second-order Birch-Murnaghan EoS (BM-EoS), simultaneously refining V ₀ and K ₀ using the data weighted by the uncertainties in V. The bulk modulus is K ₀ = 99(1) GPa, with K′ fixed to 4. Refinements of third order equations-of-state yielded values of K′ that did not differ significantly from 4. The compressibility of the unit-cell is strongly anisotropic with the c axis (K ₀(c) = 49.7 ± 0.5 GPa) approximately four times more compressible than the a axis (K ₀(a) = 195 ± 3 GPa).     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Optical spectrum based measurement of flotation slurry contents

Monitoring and control of a flotation circuit is mainly based on the information gained by assaying the process slurry lines. In flotation plants, usually an X-ray fluorescence analyzer is used to obtain the on-line assays. This article introduces the visual and near-infrared reflectance spectroscopic analysis of the process slurries as a supplementary method which complements the on-line assay information available from an X-ray fluorescence analyzer. It is shown that the spectral information can be used to accurately predict the element contents in the slurry in between successive XRF analyses. Since the spectral measurements can be taken with high frequency as opposed to the sparse X-ray fluorescence analysis, a practically continuous on-line estimate of the slurry contents is reached. These estimates can be used in the plant control to improve the overall performance of the circuits and to yield also economical savings. Additionally, the frequent monitoring of the grades can provide means to eliminate rapid disturbances in the circuits, thus improving the stability of the process.     

黄河三角洲沿岸及邻近海区细粒沉积物中的碳酸盐

本文用X-射线衍射法直接计算了来自黄河三角洲沿岸及邻近海区80个沉积样的细粒组分(<2μm)中的碳酸盐含量。计算结果与全样的容量法分析结果基本一致。研究结果表明,本区细粒沉积物中碳酸盐含量变化受沉积物来源、海区水动力作用、海底地貌特征和碳酸盐的地球化学行为等因素所影响。     

Dynamic Analysis of a Single-Column Platform (II)

This paper describes the study of a single-column structure used as well-head platform. In order to check the reliability of computation theory and programme, model tests have been carried out. The paper introduces the conclusion of tests and the dynamic properties of single-column platform are obtained.     

A comparison of several wave spectra for the random wave diffraction by a semi-infinite breakwater

A comparison of the diffraction of multidirectional random waves using several selected wave spectrum models is presented in this paper. Six wave spectrum models, Bretschneider, Pierson–Moskowitz, ISSC, ITTC, Mitsuyasu, and JONSWAP spectrum, are considered. A discrete form for each of the given spectrum models is used to specify the incident wave conditions. Analytical solutions based on both the Fresnel integrals and polynomial approximations of the Fresnel integrals and numerical solutions of a boundary integral approach have been used to obtain the two-dimensional wave diffraction by a semi-infinite breakwater at uniform water depth. The diffraction of random waves is based on the cumulative superposition of linear diffraction solution. The results of predicted random wave diffraction for each of the given spectrum models are compared with those of the published physical model presented by Briggs et al. [1995. Wave diffraction around breakwater. Journal of Waterway, Port, Coastal and Ocean Engineering—ASCE 121(1), 23–35]. Reasonable agreement is obtained in all cases. The effect of the directional spreading function is also examined from the results of the random wave diffraction. Based on these comparisons, the present model for the analysis of various wave spectra is found to be an accurate and efficient tool for predicting the random wave field around a semi-infinite breakwater or inside a harbor of arbitrary geometry in practical applications.     

On the radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas

The radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas of finite depth is investigated. The analytical expressions for the radiated and diffracted potentials are derived as infinite series by use of the method of separation of variables. The unknown coefficients in the series are determined by the eigenfunction expansion matching method. The expressions for wave forces, hydrodynamic coefficients and reflection and transmission coefficients are given and verified by the boundary element method. Using the present analytical solution, the hydrodynamic influences of the angle of incidence, the submergence, the width and the thickness of the structure on the wave forces, hydrodynamic coefficients, and reflection and transmission coefficients are discussed in detail.     

Analytic Solution of Interaction Between Surface Waves and Floating Elastic Plates with Elastic End-Restraints

Based on the dynamic theories of water waves and Mindlin plates,the analytic solution of interaction between surface waves and two-dimensional floating elastic plates with edge-restraint is constructed by use of the Wiener-Hopf technique.Firstly,without regard for elastic edge restraint,the wave-induced responses of elastic floating plate analyzed by the present method are in good agreement with the results from literature and experimental results.Therefore,it can be shown that the present method is valid.Secondly,three end-restraint cases(i.e.,the left-end elastic restraints,the both-end elastic restraints,and the right-end elastic restraints)are proposed to reduce the vibration of floating plates,in which the spring is used to connect the sea bottom and the floating plate's left(or right)edge.The relations between the spring stiffness and the parameters of wave-induced responses of floating plates are discussed.Moreover,the effective method to reduce the vibration of floating elastic plates can be obtained through comparison.     

Wave Defending Effects of V-Type Bottom-Mounted Breakwaters

An analytical method is developed for the study of the wave defending effects of the V-type bottom-mounted breakwater. The breakwater is assumed to be rigid, thin, impermeable and vertically located in water of constant depth. The fluid domain is divided into three sub-regions by an imaginary interface. The velocity potential in each region is expanded by eigenfunctions. By satisfying the corresponding boundary conditions and matching conditions in and between sub-regions, a set of hnear algebraic equations can be obtained to determine the unknown coetfficients for the eigenfunction expansions for each sub-region. The accuracy of the present model is verified by a comparison with existing results for the case of an isolated breakwater. Numerical results, in the form of contour maps of the relative wave amplitude around the breakwater, are presented for a range of wave and breakwater parameters. The results show that the V-type bottommounted breakwater is generally effective in defending against waves. In general, the wave height in the protected area is about 20-50 percent of the incident wave height.