Prediction of ground displacements and velocities from groundwater level changes at the Vallcebre landslide (Eastern Pyrenees, Spain)

In active landslides, the prediction of acceleration of movement is a crucial issue for the design and performance of warning systems. The landslide of Vallcebre in the Eastern Pyreenes, Spain, has been monitored since 1996 and data on rainfall, groundwater levels and ground displacements are measured on a regular basis. Displacements observed in borehole wire extensometers have shown an immediate response of the landslide to rainfall episodes. This rapid response is likely due to the presence of preferential drainage ways. The occurrence of nearly constant rates of displacement in coincidence with steady groundwater levels suggests the presence of viscous forces developed during the movement. An attempt to predict both landslide displacements and velocities was performed at Vallcebre by solving the momentum equation in which a viscous term (Bingham and power law) was added. Results show that, using similar rheological parameters for the entire landslide, computed displacements reproduce quite accurately the displacements observed at three selected wire extensometers. These results indicate that prediction of displacements from groundwater level changes is feasible.     

Experimental and theoretical study of a cylindrical oscillating water column device with a quadratic power take-off model

The wave power extraction by a cylindrical oscillating water column (OWC) device with a quadratic power take-off (PTO) model was studied experimentally and theoretically. In the experiment, a scaled model OWC was tested in a wave flume, with an orifice being used to simulate a quadratic PTO mechanism. In the theoretical analysis, the quadratic PTO model was linearized based on Lorenz's principle of equivalent work, which allows us to perform a frequency domain analysis using an eigen-function matching method. The effects of higher harmonic components and the spatial non-uniformity of the surface velocity inside the chamber were discussed. A semi-analytical model was proposed to understand the viscous loss affecting the measured capture length. Our treatment of the quadratic PTO model was validated by comparing quasi-linear theoretical capture length and the laboratory measurement. Our results also showed that the effects of spatial non-uniformity and viscous loss could be noticeable for shorter waves.     

消能减震高层方钢管混凝土框架结构振动台试验研究和弹塑性时程分析

本文首先介绍了一幢安装了粘滞阻尼器的复杂体型高层方钢管混凝土框架结构的1/15缩尺模型的模拟地震振动台试验结果;在此基础上,建立了梁、柱构件的多弹簧模型并组建了整体结构的计算分析模型,运用此计算模型首先对试验模型结构进行了动力弹塑性时程分析,计算结果和试验结果吻合较好,验证了计算模型的正确性;最后,以同样方法对原型结构进行了计算分析,并结合试验结果研究探讨了此结构的抗震性能和阻尼器的消能减震效果。结果表明:该结构未出现明显的薄弱层,能够满足规范的抗震设防要求,阻尼器发挥了一定的消能减震效果,进一步提高了结构的抗震性能。     

基于ANSYS软件benchmark模型耗能减振控制分析

本文系统介绍了当前国际结构振动控制的公共平台———Benchm ark模型,首次给出使用通用有限元软件ANSYS对第3阶段20层非线性钢框架抗震结构的有限元建模,结果表明,模态、无控地震反应分析结果和ASCE给出的MATLAB结果相同。利用粘滞阻尼器对此模型的耗能减振数值仿真分析的结果表明:粘滞阻尼器是一种性能很好的阻尼器,使用本文给出ANSYS的Benchm ark有限元模型来进行耗能减振控制分析是方便的、可行的。     

阻尼器连接填充墙在柔性框架结构中的应用研究

阻尼器连接填充墙采用黏滞阻尼器与主体框架结构连接,是一种新型填充墙与框架的柔性连接方式,能满足柔性框架结构的大变形需求.为使得阻尼器连接填充墙达到最优的力学性能,结构布置和构件力学参数的选择十分重要,采用有限元软件ABAQUS分别建立了柔性钢框架结构和阻尼器连接填充墙-框架结构的有限元模型,考察不同阻尼系数阻尼器连接填...     

Dynamic modeling and vibration suppression for an offshore wind turbine with a tuned mass damper in floating platform

The worldwide demand for renewable energy is increasing rapidly. Wind energy appears as a good solution to copy with the energy shortage situation. In recent years, offshore wind energy has become an attractive option due to the increasing development of the multitudinous offshore wind turbines. Because of the unstable vibration for the barge-type offshore wind turbine in various maritime conditions, an ameliorative method incorporating a tuned mass damper (TMD) in offshore wind turbine platform is proposed to demonstrate the improvement of the structural dynamic performance in this investigation. The Lagrange's equations are applied to establish a limited degree-of-freedom (DOF) mathematical model for the barge-type offshore wind turbine. The objective function is defined as the suppression rate of the standard deviation for the tower top deflection due to the fact that the tower top deflection is essential to the tower bottom fatigue loads, then frequency tuning method and genetic algorithm (GA) are employed respectively to obtain the globally optimum TMD design parameters using this objective function. Numerical simulations based on FAST have been carried out in typical load cases in order to evaluate the effect of the passive control system. The need to prevent the platform mass increasing obviously has become apparent due to the installation of a heavy TMD in the barge-type platform. In this case, partial ballast is substituted for the equal mass of the tuned mass damper, and then the vibration mitigation is simulated in five typical load cases. The results show that the passive control can improve the dynamic responses of the barge-type wind turbine by placing a TMD in the floating platform. Through replacing partial ballast with a uniform mass of the tuned mass damper, a significant reduction of the dynamic response is also observed in simulation results for the barge-type floating structure.     

双曲型不锈钢管铅阻尼器性能研究

提出一种双曲型不锈钢管铅阻尼器,阐述了其构造与特点.采用ABAQUS有限元分析软件,对双曲型不锈钢管铅阻尼器和普通钢管铅阻尼器及设过渡段(A类构造)、不设过渡段(B类构造)的双曲型不锈钢管铅阻尼器进行对比分析.结果表明:双曲型不锈钢管铅阻尼器滞回曲线对称、饱满,在小位移下即进入屈服耗能,具有优异且稳定的耗能能力;当阻尼...     

Semi-active model predictive control for 3rd generation benchmark problem using smart dampers

A semi-active strategy for model predictive control (MPC), in which magneto-rheological dampers are used as an actuator, is presented for use in reducing the nonlinear seismic response of high-rise buildings. A multi-step predictive model is developed to estimate the seismic performance of high-rise buildings, taking into account of the effects of nonlinearity, time-variability, model mismatching, and disturbances and uncertainty of controlled system parameters by the predicted error feedback in the multi-step predictive model. Based on the predictive model, a Kalman-Bucy observer suitable for semi-active strategy is proposed to estimate the state vector from the acceleration and semi-active control force feedback. The main advantage of the proposed strategy is its inherent stability, simplicity, on-line real-time operation, and the ability to handle nonlinearity, uncertainty, and time-variability properties of structures. Numerical simulation of the nonlinear seismic responses of a controlled 20-story benchmark building is carried out, and the simulation results are compared to those of other control systems. The results show that the developed semi-active strategy can efficiently reduce the nonlinear seismic response of high-rise buildings.     

500kN 足尺磁流变液阻尼器设计的关键技术

对我们制作的、目前出力居世界前列的500kN足尺MR阻尼器设计的关键技术、阻尼器的性能试验及力学模型的参数识别进行了研究。在对磁流变液材料的最大屈服剪应力、抗沉降稳定性以及磁滞响应时间等关键性能试验分析的基础上,确认该磁流变液的抗沉降稳定性和其他两项性能指标满足MR阻尼器的设计与工程应用要求。同时,对此500kN足尺MR阻尼器设计的关键技术,包括内置式碟型弹簧蓄能器、磁场防漏设计以及引线保护等进行了介绍;并通过对此MR阻尼器性能的试验,依据阻尼最小二乘法,对MR阻尼器采用的修正的B ingham模型的参数进行了识别,得到了与试验结果吻合的MR阻尼器的力学模型。通过研究可知,高性能磁流变液材料的制备以及MR阻尼器设计的关键技术是大吨位足尺MR阻尼器成功的关键。     

SMA复合摩擦阻尼器性能的试验研究

利用形状记忆合金(SMA)的超弹性效应及高阻尼性能,结合传统Pall摩擦型阻尼器的特点,提出了一种SMA复合摩擦阻尼器。在建立阻尼器力学分析模型的基础上,对SMA复合摩擦阻尼器的性能进行了试验研究,分析了位移幅值、加载频率等对阻尼器的等效刚度、单位循环耗能和等效阻尼比的影响,并与理论分析结果进行了对比。研究表明,SMA复合摩擦阻尼器在加卸载循环下会形成比较稳定的滞回曲线,表明这种阻尼器具有良好的耗能能力。