The Mw = 6.0, 7 September 1999 Athens Earthquake

On 7 September 1999 at 11:56 GMT a destructive earthquake (M_w = 6.0) occurred close to Athens (Greece). The rupture process is examined using data from the Cornet local permanent network, as well as teleseismic recordings. Data recorded by a temporary seismological network were analyzed to study the aftershock sequence. The mainshock was relocated at 38.105°N, 23.565°E, about 20 km northwest of Athens. Four foreshocks were also relocated close to the mainshock. The modeling of teleseismic P and SH waves provides a well-constrained focal mechanism of the mainshock (strike = 105°, dip = 55° and rake = -80°) at a depth of 8 km and a seismic moment M₀ = 1.010²⁵ dyn·cm. The obtained fault plane solution represents normal faulting indicating an almost north-south extension. More than 3500 aftershocks were located, 1813 of which present RMS < 0.1 s and ERH, ERZ < 1.0 km. Two main clusters were distinguished, while the depth distribution is concentrated between 2 and 11 km. Over 1000 fault plane solutions of aftershocks were constrained, the majority of which also correspond to N–S extension. No surface breaks were observed but the fault plane solution of the mainshock is in agreement with the tectonics of the area and with the focal mechanisms obtained by aftershocks. The hypocenter of the mainshock is located on the deep western edge of the fault plane. The relocated epicenter coincides with the fringe that represents the highest deformation observed on the differential interferometric image. The calculated source duration is 5 sec, while the estimated dimensions of the fault are 15 km length and 10 km width. The source process is characterized by unilateral eastward rupture propagation, towards the city of Athens. An evident stop phase observed in the recordings of the Cornet local stations is interpreted as a barrier caused by the Aegaleo Mountain.     

半无限空间中圆形孔洞周围SH波的散射

建立了求解在含有圆形孔洞的弹性半空间中SH波散射与圆形孔洞附近动应力集中问题的解析方法。利用SH波散射的对称性和多极坐标的方法，构造了一个可以预先满足半空间自由表面上应力自由边界条件的圆形孔洞对SH波散射的波函数。利用这一波函数，则可将该问题转化成对一个圆形孔洞散射的求解问题。该问题的解答最终又可归结为对一组无究代数方程组的求解问题，并可利用截断有限项的方法对其进行计算，最后给出了有关圆形也洞附近动应力集中问题的算例和数值结果，并讨论了波数与圆孔至自由边界距离变化对动应力集中的影响。     

圆弧状沉积盆地与软土单覆盖层出平面地表运动对比

采用解析方法，通过圆弧状沉积盆地与同样参数的软土均匀单覆盖层的对比，研究沉积盆地对平面SH波二维散射效应和其出平面地表运动。数值对比结果表明：（1）波垂直入射时盆地中央地表位移幅值反应，其随频率变化形式与软土单覆盖层的地表运动有较强的对应性，且此时单覆盖层地表位移幅值为其下降；（2）盆地的二维散射效应特点显著波的汇聚作用使盆地中的地表运动显著放大，总体上较软土单覆盖层的地表位移幅值要大，其频域内的最大反应则明显大于单覆盖层情况，但最大反应在盆地表面出现的位置依赖于入射波角度、盆地深宽比和盆地的软硬程度；（3）沉积盆地中地表位移运动有强烈扭转效应，且随盆地变软和入射波频率增高而增强。     

大开间小型混凝土砌块10层模型房屋抗震性能试验研究(Ⅰ)

我国抗震设计规范（GB50011－2001）规定在6、7、8度区，混凝土小砌块结构分别可以建七、六、五层。由于混凝土小砌块结构的最大优势在于10－20层（与混凝土框架或框架剪力墙结构比）。本文按1／4比例制作了10层混凝土小砌块结构模型，按7度设防要求实施构造措施，通过振动台试验研究模型结构的抗震性能。结果表明，模型结构完全能够满足在7度区“小震不坏，大震不倒”的要求。圈梁、构造柱以及水平拉结筋构成的约束体系抗震作用是明显的。试验利用砌块的非注芯孔灌注铁砂来模拟墙体出平面动力效应。在本模型的构造措施下，平出面反应不对结构破坏起控制作用。     

Surface vibration due to a sequence of high speed moving harmonic rectangular loads

The transmission of vibrations over the surface of the ground, due to high-speed moving, vertical harmonic rectangular loads, is investigated theoretically. The problem is three-dimensional and the interior of the ground is modelled as an elastic half-space or a multilayered ground. The transformed solutions are obtained using the Fourier transform on the space variable. A new damping model in the spatial wavenumber domain, presented in Lefeuve-Mesgouez et al. [J. Sound. Vibr. 231 (2000) 1289] is used. Numerical results for the displacements on the surface are presented for loads moving with speeds up to and beyond the Rayleigh wave speed of the half-space.     

充电激发极化法在金属矿上的应用

充电激发极化法是矿山物探的一种主要方法，其兼有充电法与激发极化法的特点，可利用已有的工程，最大限度地了解地下三度空间地球物理场的分布情况，解决地质问题。概述了其理论基础和方法技术，并列举了该方法在多个金属矿上的应用实例。     

蚕庄金矿上庄矿区控矿构造特征及构造模拟

上庄矿区的主要控矿断裂具有多期活动的特点，主断裂、次级断裂及节理的多种组合方式控制了矿体的产出。运用断裂面波形模拟方法得出了控矿主断裂在成矿期的断裂面波形图，并以此对上庄矿区的深部矿体进行了预测。     

优势面等级灰色聚类评价

在以往的优势面分级的基础上,本文利用灰色聚类方法对控制大型工程区域稳定性的优势面等级进行了评价,使优势面等级分类的定量化更为可靠和可信。与以往的评价方法相比,灰色聚类方法克服了严格数值界限的弊病,是一种有价值的评价方法。     

流动环境中二维铅垂纯射流的试验研究

对均匀流动环境中的铅直二维射流进行了试验研究,得到了流动转变的条件.采用超声多普勒流速仪(ADV)对射流流场进行了测量,得到了流速矢量图和流线图,发现在射流的迎流面存在流线跌落现象.探讨了流速比对射流背流面涡心和分离点位置的影响.给出低流速比为8的射流流场的实测结果,以供数值模拟对比使用.