中国西北部盆地岩石热导率和生热率特征

本文根据大量实测数据,首次系统地报道了中国西北地区塔里木盆地、准噶尔盆地和柴达木盆地内的岩石热导率、岩石放射性生热率数据及其分布特征.对600多个岩石热导率和100多个实测岩石生热率的统计分析表明,沉积盆地中岩石的热物理性质与其岩性、埋藏深度和地层时代密切相关.随深度和地层时代的加大,岩石热导率增大;塔里木盆地的岩石热导率的总体平均值最大,而柴达木盆地的最小.岩石生热率在上地壳的分布是随深度的增加而减小的,但在沉积盆地的深度范围内几乎不变,其分布是均匀的,仅不同岩性的生热率差别较大.估算的岩石放射性生热产生的热量可以占到盆地地表热流的25%～45%.因此,岩石热物理性质的参数不仅与盆地的地温分布和大地热流特征密切相关,还可以为该地区盆地热历史恢复及深部地球物理的研究提供有效的参数和边界条件.     

某既有建筑物改造工程地基加固质量的综合检测

随着既有建筑物的增层改造工程的发展和技术的日益成熟 ,为了提高原有建筑物地基土强度和变形能力 ,对其基础加固处理也愈加频繁。如何准确有效地评价其地基加固质量及其空间变化的均匀性是关系此类工程安全可靠的重要保证。本文以某一工程为例 ,讨论既有建筑物增层改造工程的地基加固质量的检测和综合评价方法。该建筑物建于 5 0年代 ,原设计为 5层 ,现增层为 6层 ,采用高压注浆方法进行地基加固处理.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

云南鹤庆盆地近1Ma来的气候序列重建初探

云南鹤庆盆地近1Ma来的孢粉植物群很好地揭示了本区的环境演化过程。本文利用植物生态位知识,通过模糊数学方法对鹤庆(QH)孔孢粉序列所记录的古气候信息进行重塑,建立了近1Ma来的年均温、年降水量及年较差序列,并将本区气候演化分为4个气候旋回,32个气候期。该序列可与黄土-古土壤序列及海洋^δ18O阶段对比,但冷暖波动的幅度及降温时段持续的长短有其特色,表明本区气候既受全球气候变化的控制,又受青藏高原阶段隆升的制约;近1Ma来气温的波动幅度呈递增趋势,0.30MaB.P.尤其显著;冷、暖段间年均温的变化幅度由第一气候旋回的7℃增大到第三气候旋回的9℃(按4次平滑值计算),而样点的实际最大差值由8℃增至16℃;最强烈的降温发生在第二气候旋回中的0.45～0.14MaB.P.时间段,这与玉龙雪山冰川活动规模最大相一致;降温时年降水量及年较差值增大,证实近1Ma来,西南季风区的气候组构与东南季风区不同。     

Heat flow and thermal modeling of the Yinggehai Basin, South China Sea

Geothermal gradients are estimated to vary from 31 to 43 °C/km in the Yinggehai Basin based on 99 temperature data sets compiled from oil well data. Thirty-seven thermal conductivity measurements on core samples were made and the effects of porosity and water saturation were corrected. Thermal conductivities of mudstone and sandstone range from 1.2 to 2.7 W/m K, with a mean of 2.0±0.5 W/m K after approximate correction. Heat flow at six sites in the Yinggehai Basin range from 69 to 86 mW/m², with a mean value of 79±7 mW/m². Thick sediments and high sedimentation rates resulted in a considerable radiogenic contribution, but also depressed the heat flow. Measurements indicate the radiogenic heat production in the sediment is 1.28 μW/m³, which contributes 20% to the surface heat flow. After subtracting radiogenic heat contribution of the sediment, and sedimentation correction, the average basal heat flow from basement is about 86 mW/m².Three stages of extension are recognized in the subsidence history, and a kinematic model is used to study the thermal evolution of the basin since the Cenozoic era. Model results show that the peak value of basal heat flow was getting higher and higher through the Cenozoic. The maximum basal heat flow increased from 65 mW/m² in the first stage to 75 mW/m² in the second stage, and then 90 mW/m² in the third stage. The present temperature field of the lithosphere of the Yinggehai Basin, which is still transient, is the result of the multistage extension, but was primarily associated with the Pliocene extension.     

Thermal expansion and crystal structure of FeSi between 4 and 1173 K determined by time-of-flight neutron powder diffraction

The thermal expansion and crystal structure of FeSi has been determined by neutron powder diffraction between 4 and 1173?K. No evidence was seen of any structural or magnetic transitions at low temperatures. The average volumetric thermal expansion coefficient above room temperature was found to be 4.85(5)?×?10^?5?K^?1. The cell volume was fitted over the complete temperature range using Grüneisen approximations to the zero pressure equation of state, with the internal energy calculated via a Debye model; a Grüneisen second-order approximation gave the following parameters: θ_D=445(11)?K, V ₀=89.596(8)?ų, K ₀′=4.4(4) and γ′=2.33(3), where θ_D is the Debye temperature, V ₀ is V at T=0?K, K ₀′ is the first derivative with respect to pressure of the incompressibility and γ′ is a Grüneisen parameter. The thermodynamic Grüneisen parameter, γ_th, has been calculated from experimental data in the range 4–400?K. The crystal structure was found to be almost invariant with temperature. The thermal vibrations of the Fe atoms are almost isotropic at all temperatures; those of the Si atoms become more anisotropic as the temperature increases.     

Reconstruction of the climate in the Tianmu Mountain area, Zhejiang Province, in the last 160 years by ? 13C sequence of tree ring α-cellulose

Based on cross-dating tree rings from the Tianmu Mountain, Zhejiang Province, the tree rings α-cellulose δ 13C time series was measured. By spectrum analysis, the variation of tree-ring δ13C sequence shows a quasi periodicity of 4.4 years, which is coincident with the standard cycle of El Nino. After removing the long-term decrease trend of the δ13C variation related to atmospheric CO2 concentration, the response of the δ13C to climate elements was analyzed using meteorology data from a nearby weather station. The results suggest that there is a distinct relativity between high-frequency variation of tree ring δ 13C series and seasonal climate parameters, e.g. Temperature and precipitation, with a significant time-lag effect. In addition, the high frequency also reflects the strength change of the East Asian Monsoon. The multiple regression method was employed to reconstruct the historical climate, and to analyze the climate change and trend in the last 160 years in the northern Zhejiang Province.     

螺旋CT三维重建在骨盆骨折中的应用

目的：探讨用螺旋CT三维重建评价骨盆骨折的临床应用价值。方法：收集骨盆骨折17例，采用螺旋CT三维重建检查。结果：17例检查均取得清晰立体图像，且可消除某一骨性结构，单独观察骨盆某一组成骨的骨折情况。结论：螺旋CT三维重建在骨盆骨折的诊断、手术方案的设计及教学等有较高价值。     

Nonlinear earthquake response analysis and energy calculation for seismic slit shear wall structures

Based on the concept of structural passive control, a new type of slit shear wall, with improved seismic performance when compared to an ordinary solid shear wall, was proposed by the authors in 1996. The idea has been verified by a series of pseudo-static and dynamic tests. In this paper a macro numerical model is developed for the wall element and the energy dissipation device. Then, nonlinear time history analysis is carried out for a 10-story slit shear wall model tested on a shaking table. Furthermore, the seismic input energy and the individual energy dissipated by the components are calculated by a method based on Newmark-β assumptions for this shear wall model, and the advantages of this shear wall are further demonstrated by the calculation results from the viewpoint of energy. Finally, according to the seismic damage criterion on the basis of plastic accumulative energy and maximum response, the optimal analysis is carried out to select design parameters for the energy dissipation device.     

Quantitative reconstruction of the lake water paleotemperature of Daihai Lake, Inner Mongolia, China and its significance in paleoclimate

By measuring Sr/Ca ratios of the ostracod shells (Limnocthere cf. inopinata) in sediments of the Daihai Lake, and combined with Sr²⁺/Ca²⁺ ratios of the lake water, this paper obtained paleosalinity of the lake water. Vaporizing experiment of the lake water in laboratory showed that there was a quantitative relationship between salinity and oxygen isotope. Using this relationship, oxygen isotope values of the paleo-lake water were calculated. By measuring the oxygen isotope of the authigenic carbonate in the lake’s sediments, and in combination with the oxygen isotope values of the paleo-lake water, the paleotemperature of the lake water was calculated. Finally, based on these proxies, the paleoclimate in the lake basin was explored.