基于耦合场分割算法的ANSYS二次开发及其应用

耦合场分割算法是当前研究的热点之一。本文首先对比研究了瞬态热传导方程和孔压增长消散方程,提出了一种适用于ANSYS二次开发的分割算法,并对2种不同的预测值计算模式对计算稳定性的影响进行了分析。然后,据之对ANSYS温度—结构耦合场模块进行了开发,形成了岩土工程有效应力计算模块。数值实验表明,这种方法具有较高的计算精度和良好的计算稳定性,并且能够充分利用现有程序资源,具有较高的工程应用价值。     

Winkler地基梁在温度场中受简谐激励的主共振分析

研究W inkler地基梁在温度场中受简谐激励作用的主共振问题。应用弹性理论和Galerk in方法建立W inkler地基梁在温度场中受简谐激励作用的非线性动力方程。应用非线性振动的多尺度法,求得系统主共振的近似解。分析不同参数对主共振响应曲线的影响。     

Winkler地基梁在温度场中受简谐激励的1/3次亚谐共振分析

研究W inkler地基梁在温度场中受简谐激励作用的1/3次亚谐共振问题。应用弹性理论和Galerk in方法建立W inkler地基梁在温度场中受简谐激励作用的非线性动力方程,根据非线性振动的多尺度法求得系统满足1/3次亚谐共振情况的一次近似解,并对其进行数值计算,分析了温度、调谐值、激励、阻尼、地基刚度等参数对系统的影响。     

消能减震高层方钢管混凝土框架结构振动台试验研究和弹塑性时程分析

本文首先介绍了一幢安装了粘滞阻尼器的复杂体型高层方钢管混凝土框架结构的1/15缩尺模型的模拟地震振动台试验结果;在此基础上,建立了梁、柱构件的多弹簧模型并组建了整体结构的计算分析模型,运用此计算模型首先对试验模型结构进行了动力弹塑性时程分析,计算结果和试验结果吻合较好,验证了计算模型的正确性;最后,以同样方法对原型结构进行了计算分析,并结合试验结果研究探讨了此结构的抗震性能和阻尼器的消能减震效果。结果表明:该结构未出现明显的薄弱层,能够满足规范的抗震设防要求,阻尼器发挥了一定的消能减震效果,进一步提高了结构的抗震性能。     

土-桩-钢结构相互作用体系的振动台模型试验

本项试验是研究土-结构相互作用对结构TLD减震控制影响的系列振动台模型试验的组成部分,主要目的是提供相应的对比试验数据。在这组试验中,突出的问题是TLD、上部被控结构和土层三个子系统模型基频间的协调。为了尽可能降低土层模型基频,文中采用了一种具有低剪切波速特性的土层模拟介质。最后,通过土-桩-钢结构系统的振动台模型试验,研究了土-结构相互作用对钢结构动力特性和地震反应的影响。     

土-桩-钢结构-TLD系统振动台模型试验研究

通过系列振动台模型试验,研究土-结构相互作用对结构TLD减震控制影响。文中首先提出试验模型设计中应考虑的几个主要问题及解决方法,然后介绍土-桩基础-钢结构-TLD相互作用体系的试验成果,分析TLD的减震效果,最后与刚性地基上钢结构TLD减震试验结果相比较,揭示土-结构相互作用对TLD减震效率的影响特点。试验结果表明:土-结构相互作用使得TLD减震效率降低,这一削减作用受到输入地震动的频谱特性和强度的影响。因此,对于建在土层场地上的结构进行TLD减震设计时,应充分重视工程场地条件和地震动特性等实际情况。     

A comparative study between China and U.S. on seismic design philosophy and practice of a long span arch bridge

This paper presents the first of a series of case studies on the seismic design of long span bridges （cable-stayed bridges, suspension bridges and arch bridges） under a cooperative research project on seismic behavior and design of highway bridges between the State Key Laboratory for Disaster Reduction in Civil Engineering, Tongji University and the Multidisciplinary Center for Earthquake Engineering Research, University at Buffalo. The objective of this series of case studies is to examine the differences and similarities on the seismic design practice of long span bridges in China and the U.S., to identify research needs and to develop design guidelines beneficial to bridge engineers in both countries. Unlike short to medium span bridges, long span bridges are not included in most seismic design specifications, mainly because they are location dependent and structurally unique. In this paper, an available model of a steel tied half through arch bridge with a main span of 550m in China is discussed. Analysis is focused on comparisons of the seismic responses due to different ground motions. Seismic design criteria and seismic performance requirements for long span bridges in both countries were first introduced and compared, and then three near field earthquake records with large vertical components were selected as the excitations to examine the seismic behavior and seismic vulnerability of the bridge. Results show that （1） the selected near field ground motions cause larger responses to key components （critical sections） of the bridge （such as arch rib ends） with a maximum increase of more than twice those caused by the site specific ground motions; （2） piers, longitudinal girders and arch crowns are more vulnerable to vertical motions, especially their axial forces; and （3） large vertical components of near field ground motions may not significantly affect the bridge＇s internal forces provided that their peak acceleration spectra ordinates only appear at periods of less than 0.2s. However, they may have more influence on the longitudinal displacements of sliding bearings due to their large displacement spectra ordinates at the fundamental period of the bridge.     

Kinematic source model for simulation of near-fault ground motion field using explicit finite element method

1 Introduction The prediction of broadband near-fault ground motion is an important aspect of seismic risk analysis, and is essential for the evaluation of urban seismic safety. Many methodologies are used to model the near-fault ground motions, such as the Green function method, ?nite element (FE) / ?nite difference (FD) method and a hybrid method (Aagaard, 1999; Oprsal and Zahradnik, 2002; Oprsal et al., 2003 a and b). In the hybrid method, the FE / FD method is used to model the low fr…     

储层结构控制下的开发响应特征初探--以双河油田为例

储层结构体现在层次性和拼合性2个方面.双河油田含油层段在地质层次上划分为10级:地层段、油层组、小层、单层、单砂体、成因砂体、成因增量、层系组、层系和纹层,体现了各级次的地质作用.拼合性体现为储层由不同的要素相互镶嵌叠置而成,其中较重要的是结构要素的规模及其空间匹配.基于储层的这种层次性和拼合性,形成了相应的储层剖面和平面预测模型,在区内划分出4类剖面模型样式和6类平面模型样式.不同的模型样式体现了不同的内部结构特征,而这种结构特征影响注水开发过程中的流体流动,进而形成不同的剩余油气分布样式.     

郯庐断裂带安徽段现代地震活动及应力场特征

分析了郯庐断裂带安徽段地震活动特征,利用近震直达波最大振幅比方法反演了99次中-小地震震源机制,并作了统计和聚类分析。现代地震活动整体上继承了历史地震分布格局,未显示增强趋势;断裂带及邻区应力场P轴和T轴优势方位大致呈近东西向和近南北向分布,现今承受的作用力以近水平或斜向为主,但也存在部分其它方向的应力场和近垂直方向的作用力。震源断层的破裂类型,带内以逆冲(或正断),或近逆冲(或正断)型为主。带附近较明显地呈现出走滑型或近走滑型破裂的优势;北、南亚段应力场有明显差异,即北压南张,其分界大约在北纬32°附近,北西西走向的桥头集—东关断裂是两者间的构造变换带。