含沙浑水体的黏度测量及应用分析

含沙浑水体的高速冲击会对海底构筑物造成破坏,在计算浑水体对构筑物的作用力时,黏度是一项重要参数。本文利用落球试验和流变仪测试试验,测定了不同浓度含沙浑水体的黏度,给出其起始黏度与动力作用后的稳定黏度。结果表明:含沙量在大于400g/L时,浑水体为可用赫巴模型描述的非牛顿流体,并可简化为宾汉体;在含沙量小于400g/L时,浑水体仍可用宾汉体模型描述,在忽略较小的初始剪切应力时,可简化为牛顿流体。浓度大于400g/L的浑水体的起始黏度约为稳定黏度的100倍。文中讨论了含沙浑水体起始黏度与稳定黏度在工程计算应用中的适用情况。     

不同开口比人工鱼礁体水动力特性及礁体稳定性研究

为研究方型人工鱼礁体开口比的变化对其水动力特性的影响,利用Fluent软件模拟了边长为3m、开口比为0～0.6之间7种不同方型鱼礁体周围水流场,通过分析水流场变化规律得到了礁体流场效应、阻力系数随开口比的变化情况;基于Morison方程计算了礁体在波流作用下的受力及其抗滑移、抗倾覆安全系数。研究结果表明:当礁体开口比小于0.2时,背涡区范围较大,流场效应明显;随着开口比的增大,礁体产生的上升流范围及竖直向最大速度分量逐渐减小;对于方形开口礁体,阻力系数与开口比的关系式为Cd=0.875φ+1.088(R2=0.963,P<0.01);随着开口比的增大,礁体所受最大波流作用力、抗滑移及抗倾覆安全系数逐渐减小,但礁体不会发生滑移和倾覆,可为实际礁体结构的设计提供参考。     

Numerical flow and performance analysis of a water-jet axial flow pump

The purpose of the present study is to investigate the performance and three-dimensional flow fields in a water-jet pump. TASCflow is employed to simulate the rotator-stator coupling flow field. A standard k-ε turbulence model combined with standard wall functions is used. In order to investigate the effect of a rear stator on flow fields, the flows in two water-jet pumps with and without a rear stator are studied. Computational fluid dynamics (CFD)-predicted overall performances are in good agreement with the experimental results. Then the flow fields, such as the pressure distribution on the blade surfaces, and the axial and tangential velocity distribution, especially the radial loading distribution, are investigated at different flow rates. In addition, the effects of a rear stator and different spacings between the rotor and the stator on the overall performance and the flow fields of the water-jet pump are also investigated.     

Numerical modelling of deep sea air-lift

Deep sea air-lifting of solid particles from depth of 1600 m is simulated with a mathematical model of the three-phase flow in an upward pipe. The computations are carried out for an axisymmetric domain in a transient way. Phase distributions, pressure and velocity profiles together with flow rates for all phases are presented and analysed. The influence of the pipe diameter on the air-lift efficiency was studied for air-lift pipes of different lengths and found to be significant. The lifting efficiency increases with the increase of the pipe diameter due to the reduction of the wall friction influence on the flow. In addition, the efficiency also increases with the increase of the solid particles volume fraction at the inlet. The presented numerical model can be utilized during various stages of the design of the air-lift pumps to help answer fundamental questions on the process, and during their operation to select optimal process parameters and to address possible problems.     

A predictive numerical model for potential mapping of the gas hydrate stability zone in the Gulf of Cadiz

This paper presents a computational model for mapping the regional 3D distribution in which seafloor gas hydrates would be stable, that is carried out in a Geographical Information System (GIS) environment. The construction of the model is comprised of three primary steps, namely: (1) the construction of surfaces for the various variables based on available 3D data (seafloor temperature, geothermal gradient and depth-pressure); (2) the calculation of the gas function equilibrium functions for the various hydrocarbon compositions reported from hydrate and sediment samples; and (3) the calculation of the thickness of the hydrate stability zone. The solution is based on a transcendental function, which is solved iteratively in a GIS environment.The model has been applied in the northernmost continental slope of the Gulf of Cadiz, an area where an abundant supply for hydrate formation, such as extensive hydrocarbon seeps, diapirs and fault structures, is combined with deep undercurrents and a complex seafloor morphology. In the Gulf of Cadiz, the model depicts the distribution of the base of the gas hydrate stability zone for both biogenic and thermogenic gas compositions, and explains the geometry and distribution of geological structures derived from gas venting in the Tasyo Field (Gulf of Cadiz) and the generation of BSR levels on the upper continental slope.     

Estimation and prediction of plastic waste annual input into the sea from China

Marine plastic debris has been a pervasive issue since the last century, and research on its sources and fates plays a vital role in the establishment of mitigation measures. However, data on the quantity of plastic waste that enters the sea on a certain timescale remain largely unavailable in China. Here, we established a model using material flow analysis method based on life cycle assessment to follow plastic product from primary plastic to plastic waste with statistical data and monitoring data from accurate sources. This model can be used to estimate and forecast the annual input of plastic waste into the sea from China until 2020. In 2011, 0.547 3–0.751 5 million tons of plastic waste entered the seas in China, with a growth rate of 4.55% per year until 2017. And the amount will decrease to0.257 1 to 0.353 1 million tons in 2020 under the influence of governmental management. The amount of plastic waste discharged from coastal areas calculated in this study was much larger than that from river, thus it is suggested to strengthen the governance and control of plastic waste in coastal fishery activities in China in order to reduce the amount of marine plastic waste input.     

Probability of Sediment Incipient Motion Under Complex Flows

Presented in this paper is a mathematical model to calculate the probability of the sediment incipient motion,in which the effects of the fluctuating pressure and the seepage are considered.The instantaneous bed shear velocity and the pressure gradient on the bed downstream of the backward-facing step flow are obtained according to the PIV measurements.It is found that the instantaneous pressure gradient on the bed obeys normal distribution.The probability of the sediment incipient motion on the bed downstream of the backward-facing step flow is given by the mathematical model.The predicted results agree well with the experiment in the region downstream of the reattachment point while a large discrepancy between the theory and experiment is seen in the region near the reattachment point.The possible reasons for this discrepancy are discussed.     

Part II. Discontinuous Galerkin method applied to a single phase flow in porous media

Discontinuous Galerkin numerical simulations of single phase flow problem are described in this paper. The simulations show the advantages of using discontinuous approximation spaces. hp convergence results are obtained for smooth solutions. Unstructured meshes and unsmooth solutions are also considered.     

Gutter casts from the Proterozoic Bijaygarh Shale Formation,India: Their implication for storm-induced circulation in shelf settings

The orientations of elongate gutter casts occurring in inner shelf storm deposits of the Proterozoic Bijaygarh Shale Formation, India reveal a modal population oriented roughly parallel to the average trend of the associated wave ripples. Assuming that the wave ripple trend approximately represents the orientation of the contemporary shoreline, the shore-parallel gutters appear to have been formed by the geostrophic current. Some gutters oriented at high angles to the inferred shoreline presumably represent incision by wave orbital currents in a storm-induced combined flow regime. The gutters also show variations in the style of incision and infill, which may be useful in distinguishing between gutters formed by wave orbital and geostrophic currents, independently of their orientation pattern with respect to the palaeo-shoreline.     

西藏易贡滑坡物质运动全过程数值模拟研究

2000年4月9日20时05分，西藏波密县易贡乡发生的大型山体崩滑，造成极大危害。在野外调查基础上，运用离散单元法模拟该崩滑体破坏、运动的全过程，此次灾害为扎木弄沟源头的山体崩塌，振动引起沟内崩坡积物发生沙土液化而随崩塌体一起运动，形成高速碎屑流的破坏运动机制，与实际情况较为吻合。