Influence of Cyclic Wetting Drying on Collapse Behaviour of Compacted Residual Soil

The climatic zones where residual soils occur are often characterized by alternate wet and dry seasons. Laboratory studies of earlier workers have established that the alternate wetting and drying process affects the swell-shrink potentials, water content, void ratio and particle cementation of expansive soils. The influence of cyclic wetting and drying on the collapse behaviour of residual soils has not been examined. This paper examines the influence of alternate wetting and drying on the collapse behaviour of compacted residual soil specimens from Bangalore District. Results of such a study are useful in anticipating changes in collapse behaviour of compacted residual soil fills. Experimental results indicated that the cyclic wetting and drying process increased the degree of expansiveness of the residual soils and reduced their collapse tendency. Changes in the swell/collapse behaviour of compacted residual soil specimens from wetting drying effects are attributed to reduction in water content, void ratio and possible growth of cementation bonds.     

Compressibility and shear strength of a residual soil

A detailed study was performed to investigate the compressibility and the shear strength of a residual soil in Omdurman, Sudan. The soil resulted from weathering of sandstone and mudstone. The soil is classified as sandy clayey silt (MH-CH) and is generally partially saturated. Consolidation tests were performed to study the compressibility of the soil and UU, CIU and insitu tests (CPT and SPT) were performed to study the shear strength characteristics of the soil. The characteristics of this residual soil can generally be predicted using correlations proposed in the literature for transported soils. The soil is of low to medium compressibility and exhibits slight apparent overconsolidation behavior. The soil dilates during shear and shows no long term effective cohesion. Problems associated with open cuts in this soil are attributed to loss of strength upon saturation.     

Comparison of magnetic parameters with vehicular Br levels in urban roadside soils

Chemical methods are generally chosen to monitor soil pollution but magnetic measurements proved to yield additional information at low cost and less time consumption. In this investigation, the novel use of rapid and non-destructive magnetic measurements to characterize Br levels in Xuzhou (China) urban roadside soils was reported. X-ray fluorescence spectrometry (XRF) was used to quantify Br in the soil samples. Data from 21 roadside soil samples confirm Br contamination, with a mean level of 4.36 mg kg⁻¹ and a range of 2.4–8.7 mg kg⁻¹. These values are higher than that of unpolluted soils in Xuzhou that averages 1.1 mg kg⁻¹. Hierarchical clustering analysis shows Br in Xuzhou roadside soils is mainly from road traffic. Clear correlations between Br levels and simple magnetic parameters [mass specific susceptibility (χ _LF), susceptibility of anhysteretic remanent magnetization (χ _ARM), saturation isothermal remanence (SIRM)] are observed. The present study shows that these three magnetic parameters can be used as a proxy for Br levels in Xuzhou urban roadside soils.     

Large-scale mass wasting in ancient volcanic materials

Giant landslides are significant hazards associated with many active volcanic edifices. We describe a similar feature on ancient (>4 Ma) volcanic deposits subject to active tectonism. The landslide is approximately 3 km long by 1 km wide, with an estimated depth of 400 m. Side margins are straight and parallel, mimicking regional structure; narrow valleys incised down these margins provide low-strength side-release surfaces. Between these is a giant slump consisting of at least four, largely intact, discrete blocks that have moved down-dip a distance of >500 m. A series of flows with areal extents ranging from 0.01 to 0.5 km² extends from the front of the failure. The materials represent an eroded sequence of andesite flows on the flanks of a stratovolcano. These have undergone two phases of hydrothermal alteration, and are deeply weathered to low-density (1040±80 kg m⁻³) silt (59%) and clay (35%) materials with strength properties typical of weathered silts (c=26±3 kN m⁻²; φ=42±8°). The size and location of this landslide preclude detailed geotechnical investigation of the failure. The worth of numerical stability analysis as an alternative technique in assessing the nature of the failure and hence the risk it poses to nearby communities is investigated. Sensitivity analysis identified likely conditions under which initial failure may have occurred: analyses for sensitivity to strength and earthquake acceleration needed conversion to critical combinations (F=1.0) of water table and strength/acceleration to remove the overriding influence of water table fluctuations. Failure was likely initiated either by a high water table level (83-84%), or some combination of intensity VII-IX earthquake waves together with water table heights of 40-80%. A general hazard assessment indicates that the risk associated with creep and catastrophic failure of the main mass is small, whereas the risk from flow failures near the toe of the landslide may be high. Important parameters (hydrological regime, flow failure morphology, age of initiation, and rates of movement) requiring closer investigation are identified. Development of a model is crucial to assessing the hazard associated with a feature such as that described here. With limited resources, a detailed stability analysis is a powerful tool as an initial stage in hazard analysis.     

高压旋喷法在镇江市南徐路软基处理中的应用

介绍了高压旋喷法在镇江市南徐路软土路基处理中的应用，提出了旋喷桩的施工工艺、质量控制要点，对应用效果作了简要评述。     

软土地基上静压预制桩承载力的工后增大效应

分析了软土地基上预制桩承载力的时效性机理，介绍了几种研究承载力时效性的经验回归公式，结合工程说明应充分认识承载力时效性的科学性和利用这种规律潜在的巨大经济效益。     

饱和土一维简谐响应解析解的求解和应用：II 应用

将相关论文[1]中得到的饱和土一维简谐响应解析解，应用到饱和土中两类压缩波的独立作用、饱和土中波的传播速度、u-p方程的适用范围等研究中。在两类压缩波的独立作用研究中，克服了以前文献中的数学不严密性。研究了饱和土各参数对三种体波波速的影响。通过比较u-w和u-p方程的解答，定量地说明了u-p方程的适用范围。     

Inelastic displacement ratios for evaluation of existing structures

Results of a detailed statistical study of constant relative strength inelastic displacement ratios to estimate maximum lateral inelastic displacement demands on existing structures from maximum lateral elastic displacement demands are presented. These ratios were computed for single‐degree‐of‐freedom systems with different levels of lateral strength normalized to the strength required to remain elastic when subjected to a relatively large ensemble of recorded earthquake ground motions. Three groups of soil conditions with shear wave velocities higher than 180m/s are considered. The influence of period of vibration, level of lateral yielding strength, site conditions, earthquake magnitude, distance to the source, and strain‐hardening ratio are evaluated and discussed. Mean inelastic displacement ratios and those associated with various percentiles are presented. A special emphasis is given to the dispersion of these ratios. It is concluded that distance to the source has a negligible influence on constant relative strength inelastic displacement ratios. However, for periods smaller than 1s earthquake magnitude and soil conditions have a moderate influence on these ratios. Strain hardening decreases maximum inelastic displacement at a fairly constant rate depending on the level of relative strength for periods of vibration longer than about 1.0s while it decreases maximum inelastic displacement non‐linearly as the period of vibration shortens and as the relative‐strength ratio increases for periods of vibration shorter than 1.0s. Finally, results from non‐linear regression analyses are presented that provide a simplified expression to be used to approximate mean inelastic displacement ratios during the evaluation of existing structures built on firm sites. Copyright © 2003 John Wiley & Sons, Ltd.     

Empirical correlations of soil parameters based on Cone Penetration Tests (CPT) for Greek soils

This study presents the results of Cone Penetration Tests (CPT) and estimated correlations with the results of other in-situ tests (standard penetration test, cross-hole, seismocone) and laboratory tests (classification and undrained shear strength tests). These tests cover nearly all types of penetrable soils in Greece and, together with the formulation of empirical correlations, complement and improve on previous studies due to the significant number of CPT measurements.     

Reflection and transmission of seismic waves at an interface betwen two saturated soils

ＲｅｆｌｅｃｔｉｏｎａｎｄｔｒａｎｓｍｉｓｉｏｎｏｆｓｅｉｓｍｉｃｗａｖｅｓａｔａｎｉｎｔｅｒｆａｃｅｂｅｔｗｅｎｔｗｏｓａｔｕｒａｔｅｄｓｏｉｌｓＪＵＮＹＡＮＧ（杨峻）ＳＨＩＭＩＮＧＷＵ（吴世明）ＺｈｅｊｉａｎｇＵｎｉｖｅｒｓｉｔｙ，Ｈａｎｇｚ...