黄河河口演变(Ⅰ) --(一)河口水文特征

本文利用20世纪后半个世纪的完整实测资料，研究了河口径流量与输沙量的变化，自50年代至90年代呈明显递减。对黄河口的水文特征：水情、沙情、断流、离子流量、滨海潮汐、潮流、余流、温、盐度分布、风暴潮、拦门沙与盐水楔等作出定性和定量的论述。对断流的危害、成因及缓解对策作出分析。河口淤积、延伸、改道对黄河下游的影响也作出时空上的定量分析。对1855年以来近代黄河三角洲海岸线变化，作出了定量研究。     

Underice Operation of SJT-5 ROV

- The authors have used a low-cost ROV of observation type for underice surveying of the Nen-Jiang Cross-river oil pipe line in the Da Qing oil field. The operation method, process and the safety measures for severe cold areas are presented. The fruitful tries and experience may be useful to ROV operators in severe cold areas.     

城市建设中的地震小区划与浅层地震探测

简要阐述地震小区划在现代城市建设中的重要性以及在实施地震小区划的研究中浅层地震探测的重要作用及其方法原理,并给出应用浅层地震探测在城市地震小区划中的实例。     

A Numerical Model of Coastal Processes of Sand Beaches Based on Long-Term Wave Series

A numerical model of shoreline change of sand beaches based on long-term field wave data is proposed, the explicit and implicit finite difference forms of the model are described, and an application of the model is presented. Results of the application indicate that the model is sensitive to the order of the input wave data, and that the effects of long-term wave series and the effects of the mean annual wave conditions on the model are different. Instead of a single wave condition, the wave series will make the calibration and the verification of the model more practical and the results of the model more reasonable.     

完全混合活性污泥法处理含海水污水时基质降解与需氧量之间的关系

文章采用完全混合活性污泥法研究了大生活用海水进入城市污水系统后 ,不同海水盐度下基质降解与需氧量之间的关系。结果表明随着污水中海水比例的增加 ,代谢单位重量有机物所需的氧量和污泥自身氧化需氧率也呈增加趋势     

水面皮层破坏-复原过程的实验室模拟研究

依据水面红外发射和红外遥感测温原理，采用HDG－高灵敏度红外测温仪和常规测量仪器相结合的方法，在实验室空气稳定条件下，模拟测得了水面皮层破坏－复原（重建）的热力过程和气－水温差对水面皮层复原过程的影响，获得了大量的测量数据。数据分析表明，当气－水温差从3．0℃变为11．5℃时，水面皮层破坏可导致皮温增量从气－水温差3．0℃时的0．15℃变到11．5℃时的0．45℃，并发现恢复时间与气－水温差呈负线性关系。     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

地震勘探在不同地质条件下的新应用

20世纪末，地震勘探技术在油气勘探、煤田勘探、工程勘探等多方面的应用都有了突飞猛进的发展。总结了近年来地震勘探在岩性、沉积相、构造体系等不同地质条件下的应用实例，用以说明地震勘探的多用性及其强大的生命力。     

1999年以来台湾及邻近海域7.5级以上强震前的条带现象

中国台湾地区地处欧亚板块与菲律宾海板块之间,地震活动频繁．本文报道了 我国台湾地区及其邻近海域1985～2002年间5．5级以上地震的条带内外频度比分 布,并着重研究了1999—2002年中发生的3次7．5级以上地震前的条带现象．其结 果表明:台湾地区近期发生的3次7．5级以上大地震前,5．5级以上地震呈条带分 布．这些条带符合条带内地震个数Nin≥6的条件,符合条带内、外频度比Nin／(Nin Nout)≥75％的条件,也符合条带长宽比大于5的要求,只是与板内地震条带相比,条 带的长度较短．