长江三角洲地区水和热通量的时空变化特征及影响因子

文中利用改进的K B模式和牛顿扩散方法及 196 1年以来的长江三角洲 (2 8～ 33°N ,118～ 12 3°E)地区的 4 8个测站的常规气象资料 ,估计了该地区近 4 0a来的蒸散量和感热通量。结合该地区的气温、太阳辐射等气候资料和 196 0年以来该区域土地资源利用变化等有关信息对该地区的潜热通量和感热通量的时 空间变化特征及其可能成因进行了综合分析。结果认为该地区自 2 0世纪 70年代开始平均蒸散量有逐渐减小的趋势 ,与 1980年相比 ,1998年区域年平均蒸散量减小了 2 4mm。区域平均感热通量与蒸散量相比在此期间变化并不明显。通过对该地区的云量、太阳辐射及土地利用变化资料分析认为 ,造成该地区平均蒸散量减少趋势的的原因之一是用于蒸发的能量即太阳辐射的减少 ,而造成太阳辐射减少的可能原因为云量及大气透明度的变化所至 ;原因之二是该地区地表覆盖条件的改变。近 2 0a来 ,该地区的水田、旱地及水域面积占总面积的比率分别减少 1.35 3% ,4 .4 4 2 %和2 .5 97% ,而城镇建设、工矿及其它建设用地面积则增加 3.345 %。耕地及水面的减小和城镇及建设用地面积的增加从整体上使区域平均蒸发量减少。     

Electrical aerosol spectrometer of Tartu University

The electrical aerosol spectrometer (EAS) of the parallel measuring principle at Tartu University is an efficient instrument for rapid measurement of the unstable size spectrum of aerosol particles. The measuring range from 10 nm to 10 μm is achieved by simultaneously using a pair of differential mobility analyzers with two different particle chargers. The particle spectrum is calculated and measurement errors are estimated in real time by using a least-squares method. Experimental calibration ensures reliability of measurement. The instrument is well suited for continuous monitoring of atmospheric aerosol.     

Elemental particle size distributions. Measured and estimated dry deposition in Sfax region (Tunisia)

Mass size distribution of the crustal elements (Al, Ca, Fe, Mg, Si, Ti), anthropogenic elements (Zn, Mn, Cr, Cu, K, P, Pb) and sea elements (Na, Cl) were obtained from measurements carried out with an inertial cascade impactor in Sfax. A fitting procedure by data inversion was applied to those data. This procedure yields accurate size distributions of aerosols in the diameter range 0.1–25 μm in two different sites. In a coastal industrial site, the mass distribution of the aerosol showed a bimodal structure; and in urban area, the lower particle mode cannot be observed. The elemental dry deposition flux was calculated as a function of particle size. The element flux size distribution increased rapidly with particle size. The modelling results indicate that the majority of the crustal and anthropogenic elements flux (>90%) was due to particles larger than 3 μm in diameter.     

东南极Lambert冰川-Amery冰架系统平衡通量分布的计算

通过对Lambert冰川盆地(LGB)考察路线上约1 700 km长的LGB剖面和距冰架末端约50 km、长150 km的A剖面, 分别利用GPS冰流速值及雷达测厚值进行冰通量的计算得出:每年流过LGB剖面的冰通量为43.95 Gta-1, 而通过A剖面的冰通量仅为26. 42 Gt*a-1, Amery冰架底部净融化量为7.8 Gt*a-1. 整个Lambert冰川-Amery冰架系统(LAS)地区的表面净物质平衡总量约为90 Gt*a-1; LGB地区的表面净物质平衡总量为46 Gt*a-1. 通过分析得出, 整个LAS地区及LGB地区均处于物质正平衡状态, 而LAS流域的上游区域S'则处于物质负平衡状态.     

渤海湾盆地北部奥陶纪岩相古地理

渤海湾盆地北部主要包括黄骅坳陷、沧县隆起、冀中坳陷和下辽河坳陷,区内奥陶系厚 6 0 0～ 80 0m,主要由石灰岩和白云岩组成。下奥陶统分为冶里组和亮甲山组,中奥陶统分为下马家沟组、上马家沟组和峰峰组,上统缺失。其中下马家沟组、上马家沟组和峰峰组又进一步划分为下段和上段。早奥陶世冶里期和亮甲山期,本区以局限海环境为主,其内散布着一些潮坪和滩。中奥陶世,本区岩相古地理面貌变化旋回极为明显,下马家沟期早期潮坪广布,晚期以局限海为主;上马家沟期早期又是潮坪广布,晚期以开阔海为主;峰峰期早期潮坪广布,晚期又以开阔海为主。在奥陶纪,本区经历了 4个大的海侵-海退旋回,其中上马家沟期晚期是本区乃至整个华北地台的最大海侵期。     

An experimental study of grain scale melt segregation mechanisms in two common crustal rock types

Creation of pathways for melt to migrate from its source is the necessary first step for transport of magma to the upper crust. To test the role of different dehydration‐melting reactions in the development of permeability during partial melting and deformation in the crust, we experimentally deformed two common crustal rock types. A muscovite‐biotite metapelite and a biotite gneiss were deformed at conditions below, at and above their fluid‐absent solidus. For the metapelite, temperatures ranged between 650 and 800 °C at P_c=700 MPa to investigate the muscovite‐dehydration melting reaction. For the biotite gneiss, temperatures ranged between 850 and 950 °C at P_c=1000 MPa to explore biotite dehydration‐melting under lower crustal conditions. Deformation for both sets of experiments was performed at the same strain rate (ε.) 1.37×10^?5 s^?1. In the presence of deformation, the positive ΔV and associated high dilational strain of the muscovite dehydration‐melting reaction produces an increase in melt pore pressure with partial melting of the metapelite. In contrast, the biotite dehydration‐melting reaction is not associated with a large dilational strain and during deformation and partial melting of the biotite gneiss melt pore pressure builds more gradually. Due to the different rates in pore pressure increase, melt‐enhanced deformation microstructures reflect the different dehydration melting reactions themselves. Permeability development in the two rocks differs because grain boundaries control melt distribution to a greater extent in the gneiss. Muscovite‐dehydration melting may develop melt pathways at low melt fractions due to a larger volume of melt, in comparison with biotite‐dehydration melting, generated at the solidus. This may be a viable physical mechanism in which rapid melt segregation from a metapelitic source rock can occur. Alternatively, the results from the gneiss experiments suggest continual draining of biotite‐derived magma from the lower crust with melt migration paths controlled by structural anisotropies in the protolith.     

Cation distribution and structure modelling of spinel solid solutions

 This paper presents an improved generalisation of cation distribution determination based on an accurate fit of all crystal-chemical parameters. Cations are assigned to the tetrahedral and octahedral sites of the structure according to their scattering power and a set of bond distances optimised for spinel structure. A database of 295 spinels was prepared from the literature and unpublished data. Selected compositions include the following cations: Mg²⁺, Al³⁺, Si⁴⁺, Ti⁴⁺, V³⁺, Cr³⁺, Mn²⁺, Mn³⁺, Fe²⁺, Fe³⁺, Co²⁺, Ni²⁺, Zn²⁺ and vacancies. Bond distance optimisation reveals a definite lengthening in tetrahedral distance when large amounts of Fe³⁺ or Ni²⁺ are present in the octahedral site. This means that these cations modify the octahedral angle and hence the shared octahedral edge, causing an increase in the tetrahedral distance with respect to the size of the cations entering it. Some applications to published data are discussed, showing the capacity and limitations of the method for calculating cation distribution, and for identifying inconsistencies and inaccuracies in experimental data. Received: 19 February 2001 / Accepted: 1 June 2001     

1987年8月2日江西省寻乌MS5.5级地震的震害与烈度分布

从寻乌5.5级地震的地震地质构造背景，宏观震害考察结果。结合近场强地面运动观测中几次较大地震的加速度峰值。分析宏观烈度分布特征。认为烈度分布特征除了受构造控制外，还与地形，地基土质条件有关，极震区长轴方向显示鸡笼嶂-寻乌-八尺北西向断裂是寻乌地震的主要发震断层，发震构造受控于华南块体构造应力场，发震区处于北北东向河源-邵武断裂中段和东西向断裂交汇部位。     

《CT理论与应用研究》杂志新刊标和地幔速度模型的说明

在《ＣＴ理论与应用研究》杂志１９９４~２００１年本杂志“刊标”的基础上,在其上方增加了象征三维体视学成像的三角形四面体的透视图;该刊标的右下侧为医学断面成像扫描仪(包括各种Ｘ－ＣＴ机与核磁共振ＭＲＩ扫描仪等);其左下侧为三维地幔速度模型和地球核的示意图,切出有两个地幔剖面,表示纵波速度二维变化的剖面。该速度剖面系根据赵大鹏教授的理论和计算方法,按照地球上的两个大圆弧做计算和绘制的彩色图,排在本期封４:第一大圆弧,从北极经西巴基斯坦(２８°Ｎ, ６４°Ｅ)到马尔代夫群岛(３°Ｎ,７３°Ｅ);第二大圆弧从马尔代夫群岛点(３°Ｎ,７３°Ｅ)连接巴布新几内亚之南点(１２°Ｓ,１５０°Ｅ),来计算两剖面速度分布并作图的结果,其具体分布参见封４的两条彩色剖面和相应的地理位置图。由于赵教授这篇论文[１]在中国国内只有很少数图书馆收藏,在Ｅｌｓｅｖｉｅｒ Ｓｃｉｅｎｃｅ的ＥＰＳＬ网站上一般人只能查到摘要,本刊对于该地幔速度模型的制作方法和所用数据资料,该模型的优越性和特征进行了叙述,他所用的地震事件数目,多达７１２８个;用于层析反演成像的震相到时数多到近一百万条。该速度如下的特点:在所采用的速度结构中,包含用几个复杂形状的地质速度界面,如莫霍面,以及下沉板块的分界     

河流水质风险评价的灰色-随机风险率方法

提出了量化影响河流水质的随机不确定性与灰色不确定性的水质超标灰色－随机风险率概念，建立了水质超标灰色－随机风险率评价模型。在水质单项参数评价模型中，将河流污染物浓度变量的分布处理成灰色概率分布，将污染物浓度超过水质类别标准值的风险率处理成灰色概率，即水质超标灰色－随机风险率。在水质综合评价模型中，河流水环境系统被考虑为担任某一使用可能的可靠性系统，而任意一种水质参数超标意味着河流水体使用功能不能得到应有的保证，也即表明水体综合评价超标，最后借鉴系统可靠性分析的理论和方法计算水质综合超标率。该方法应用于黄河花园口断面重金属污染风险评价。