合肥遥测台网地震速报系统

论述了适用于遥测地震台网大震速报的一套计算机处理系统,系统设计以《全国遥测台网观测技术规范》和《近震分析》理论为依据,实现了数据输入,震相选择,数据处理,地震定位,震级计算,结果输出及贮存等多项功能,达到了快速确定地震三要素,提高速报速度和精度之目的,是一个较完善的,实用的速报系统。     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

1786年康定地震形变特征的初步研究

本文对鲜水河断裂带南东段,康定断裂地震的形变带进行了分析。认为,地震形变带主要由发育于地形斜坡上的线性坡中槽或垄岗组成。形变带具分段特点,单条长850—1500米,呈右阶“斜列式”展布,中段(极震区)一带为现状型。其中的破裂面具正断兼扭动特点。空间特征上,坡中槽一侧的交替上升变化是依次、轮换出现的,它是地震断层运动屈曲作用(Fault buckling)导致地表变形的反映。这种形变现象与该带北西段(炉霍段)走滑型地震的形变带相比有明显的差异,也表明鲜水河断裂带北西、南东两段的地震破裂方式是不尽相同的,它为同一走滑带不同地段运动特征的差异提供了证据。     

A combined study of macroseismic data and focal mechanisms applied to the West-Bohemian earthquake,Czechoslovakia

The main shock of the West-Bohemian earthquake swarm, Czechoslovakia, (magnitudem=4.5, depthh=10 km) exhibits an irregular areal distribution of macroseismic intensities 6° to 7° MSK-64. Four lobes of the 6° isoseismal are found and the maximum observed intensity is located at a distance of 8 km from the instrumentally determined epicentre. This distribution can be explained by the energy flux of the directS wave generated by a circular source, the hypocentral location and focal mechanism of which are taken from independent instrumental studies. The theoretical intensity, which is assumed to be logarithmically proportional to the integrated squared ground-motion velocity (i.e.,I=const+log v ² (t)dt), fits the observed intensity with an overall root-mean-square error less than 0.5°. It is important that the present intensity data can also be equally well explained by the isotropic source. The fit was attained by means of a horizontally layered model though large fault zones and an extended sedimentary basin suggest a significant lateral heterogeneity of the epicentral region. The results encourage a broader application of the simple modelling technique used.     

突发性地面增温与临震前兆——以1988年澜沧、耿马7.6,7.2级地震为例

本文通过较多的地面温度资料分析,认为1988年11月6日澜沧、耿马地震前几天,震区及其周围大范围的突发性地面增温异常是一种临震前兆,总结了增温异常的时空演变规律与地震活动的关系,并对其形成机制提出初步想法     

论四川盆地三叠系地下水水文地质条件

四川盆地三叠系地下水可划分出碎屑岩孔隙裂隙和碳酸盐岩岩溶裂隙两大储集类型。按此处构造开启程度和埋深条件等的不同,下中三叠统地下水有沉积变质水和渗入淋滤水两种基本成因类型,水动力特征各异。沉积变质水处于深埋封闭条件,受地静压力驱动控制;渗入淋滤水分布于背斜露头区和浅部地区,受静水压力驱动控制。并由此控制了盆地三叠系盐类的保存条件。     

Effects of dynamic shear strength and time-histories stress analysis on newmark sliding block analyses

A simplified procedure for evaluating aseismic stability of slope subjected to earthquake shaking, in which the effect of dynamic shear strength and time-history stress on the yielding angular acceleration of sliding block is taken into account, is presented. The fundamental feature of this procedure is the dynamic shear strength. The numerical computations are performed by using the proposed method. It is shown that the computed sliding displacement for a given core dam, with either method of dynamic shear strength properly considered, is more rational compared with the conventional computational results based on static shear strength.     

Non-volcanic deep low-frequency tremors accompanying slow slips in the southwest Japan subduction zone

Non-volcanic deep low-frequency tremors in southwest Japan exhibit a strong temporal and spatial correlation with slow slip detected by the dense seismic network. The tremor signal is characterized by a low-frequency vibration with a predominant frequency of 0.5–5 Hz without distinct P- or S-wave onset. The tremors are located using the coherent pattern of envelopes over many stations, and are estimated to occur near the transition zone on the plate boundary on the forearc side along the strike of the descending Philippine Sea plate. The belt-like distribution of tremors consists of many clusters. In western Shikoku, the major tremor activity has a recurrence interval of approximately six months, with each episode lasting over a week. The tremor source area migrates during each episode along the strike of the subducting plate with a migration velocity of about 10 km/day. Slow slip events occur contemporaneously with this tremor activity, with a coincident estimated source area that also migrates during each episode. The coupling of tremor and slow slip in western Shikoku is very similar to the episodic tremor and slip phenomenon reported for the Cascadia margin in northwest North America. The duration and recurrence interval of these episodes varies between tremor clusters even on the same subduction zone, attributable to regional difference in the frictional properties of the plate interface.     

3-D seismic structure of the source area of the 1993 Latur, India, earthquake and its implications for rupture nucleations

The Latur earthquake (M_w 6.1) of 29 September 1993 is a rare stable continental region (SCR) earthquake that occurred on a previously unknown blind fault. In this study, we determined detailed three-dimensional (3-D) P- and S-wave velocity (V_p, V_s) and Poisson's ratio (σ) structures by inverting the first P- and S-wave high-quality arrival time data from 142 aftershocks that were recorded by a network of temporary seismic stations. The source zone of the Latur earthquake shows strong lateral heterogeneities in V_p, V_s and σ structures, extending in a volume of about 90 × 90 × 15 km³. The mainshock occurred within, but near the boundary, of a low-V_p, high-V_s and low-σ zone. This suggests that the structural asperities at the mainshock hypocenter are associated with a partially fluid-saturated fractured rock in a previously unknown source zone with intersecting fault surfaces. This might have triggered the 1993 Latur mainshock and its aftershock sequence. Our results are in good agreement with other geophysical studies that suggest high conductivity and high concentration of radiogenic helium gas beneath the source zone of the Latur earthquake. Our study provides an additional evidence for the presence of fluid related anomaly at the hidden source zone of the Latur earthquake in the SCR and helps us understand the genesis of damaging earthquakes in the SCR of the world.     

A way to synchronize models with seismic faults for earthquake forecasting: Insights from a simple stochastic model

Numerical models are starting to be used for determining the future behaviour of seismic faults and fault networks. Their final goal would be to forecast future large earthquakes. In order to use them for this task, it is necessary to synchronize each model with the current status of the actual fault or fault network it simulates (just as, for example, meteorologists synchronize their models with the atmosphere by incorporating current atmospheric data in them). However, lithospheric dynamics is largely unobservable: important parameters cannot (or can rarely) be measured in Nature. Earthquakes, though, provide indirect but measurable clues of the stress and strain status in the lithosphere, which should be helpful for the synchronization of the models.The rupture area is one of the measurable parameters of earthquakes. Here we explore how it can be used to at least synchronize fault models between themselves and forecast synthetic earthquakes. Our purpose here is to forecast synthetic earthquakes in a simple but stochastic (random) fault model. By imposing the rupture area of the synthetic earthquakes of this model on other models, the latter become partially synchronized with the first one. We use these partially synchronized models to successfully forecast most of the largest earthquakes generated by the first model. This forecasting strategy outperforms others that only take into account the earthquake series. Our results suggest that probably a good way to synchronize more detailed models with real faults is to force them to reproduce the sequence of previous earthquake ruptures on the faults. This hypothesis could be tested in the future with more detailed models and actual seismic data.