金平龙脖河地区元古界龙脖河岩群的建立

将金平县龙脖河口一带原划二叠纪的玄武岩组，三叠纪的个旧组、火把冲组，更正为元古代，并命名为龙脖河岩群。为研究该区的地层展布、大地构造环境、古地理、构造活动等提供了新资料。     

三类高强度悬式瓷绝缘子的成分和物相分析

为探讨高原牌70kN和进口120，210kN瓷绝缘子的成分和结构性能，中采用原子吸收光谱（AAS）和X射线衍射（XRD）方法，对三类产品进行了检测。结果表明，有效成分除K2O外，70kN和210kN的SiO2,Al2O3,Fe2O3含量接近，主晶相基本相同，有刚玉，莫来石、石英和长石等；结晶相总量：70kN35%，120kN40%,210kN48%，这表明机械强度愈大，结晶相含量愈高，只需调整70kN原样的部分成分，粒度和工艺，即生产出高等级（如210kN)瓷绝缘子。     

Correlation of TBM and drilling machine performances with rock brittleness

The correlations between three different methods of measuring brittleness and both drillability and borability were statistically investigated using the raw data obtained from the experimental works of different researchers.

Strong exponential relationships between the penetration rates of tunnel boring machine (TBM) and the brittleness of B₁ (the ratio of compressive strength to tensile strength) and B₂ (the ratio of compressive strength minus tensile strength to compressive strength plus tensile strength) were found. There is no correlation between the penetration rates of the diamond drilling tool and the brittleness values. Strong exponential correlations exist between the penetration rates of rotary drills and the brittleness of B₁ and B₂. However, no correlation between the penetration rate of rotary drills and the brittleness of B₃ (the product of percentage of fines in impact strength test and compressive strength) was found. The penetration rate of percussive drills does not exhibit a correlation with the brittleness of B₁ and B₂, but the penetration rate of percussive drills is strongly correlated with the brittleness of B₃.

It was concluded that each method of measuring brittleness has its usage in rock excavation depending on practical utility.     

Crack damage stress as a composite function of porosity and elastic matrix stiffness in dolomites and limestones

Twenty-five uniaxial compression tests were performed to determine stress at onset of dilation, referred to herein as “the crack damage stress,” in heterogeneous dolomites and limestones. A simplified model for crack damage stress (σ_cd) is developed here using porosity, elastic modulus, Poisson's ratio and three empirical coefficients. The model shows that when porosity decreases and elastic modulus increases, σ_cd rapidly increases and approaches its maximum value. On the other hand, when porosity increases and elastic modulus decreases, σ_cd rapidly decreases and approaches its minimum value. The proposed model is validated for six heterogeneous limestone and dolomite formations which are widely distributed in Israel.     

内蒙古宝音图岩群变质基性火山岩锆石U-Pb年龄及意义

内蒙古达茂旗宝音图岩群是在达茂旗、查干呼绍地区 1:5万区调和白云鄂博幅 1:2 5万区调过程中从过去的巴特敖包群和白云鄂博群未分岩组解体出来的中级变质岩系。通过对宝音图岩群中阳起钠长片岩、二云片岩 (原岩均为基性火山岩 )进行单颗粒锆石U -Pb法年龄测定 ,获得了两条不一致线上交点年龄 (2 486± 42 )Ma、(2 496± 2 6 )Ma ,代表了宝音图岩群基性火山岩及宝音图岩群的形成时代 ;在不一致线之外不同成因的锆石的2 0 7Pb/ 2 0 6Pb表面年龄 (2 2 2 7± 15 )Ma ,寓示着 2 2 0 0Ma左右发生了一次区域性变质热事件 ;下交点年龄 (319±486 )Ma和 (40 6± 46 )Ma ,代表了 2 5 0～ 480Ma时期该区大面积岩浆侵位及宝音图岩群后期变形变质改造的时期 ,两个年龄样的获得为研究古元古代古陆的裂解及白云鄂博海槽的形成提供了直接依据。     

岩石圈流变机制的确定及影响岩石圈流变强度的因素

讨论了确定岩石圈流变强度中存在的问题，根据Byerlee定律，给出了在Anderson断层系统下三种断层的摩擦滑动强度公式，利用小标本实验结果外推，用大标本实验结果作约束，得到岩石圈几种典型岩石的脆性破裂规律，利用上述结果和传统的方法，分别得到了鄂尔多斯和山西裂谷两个典型地区的流变强度随深度的变化。结果表明，以往的计算对岩石圈流变强度的估计过高，对脆性形变区估计不足，流变机制估计不对；岩石圈有力学分层的特性，但各地分层的深度范围不同，使得成层和力学作用变得复杂，讨论了水、应变率以及多相矿物对流变强度的影响。     

多矿物岩石流变规律的研究进展及存在问题

总结了近年来由多种矿物组成的岩石的流变规律的研究，阐述了多矿物岩石流变性质研究的意义和进展，再从实验和理论两个方面，详细论述了目前最具代表性的三种理论模型，算术平均方法、几何平均方法和能量极小方法，最后，指出这方面研究仍然存在的问题和进一步研究的方向。     

基于高温高压岩石破裂实验结果对中强地震前震中附近区域部分地震学现象的初步解释

依据高温高压岩石破裂实验结果并结合理论分析，对 附近区域不同深度温压条件下岩石变形破坏性质及破坏失稳的力学行为进行了研究，在一次应力加载循环中，发生破坏的部位随时间具有向深部下迁的趋势。考虑到深度温压条件下岩石的渐进式破坏行为及突发失稳，对主震前震中附近区域小地震活动的增强、平静、活化等现象，以及b值等时间序列参数变化的可能机理进行初步探讨，并简单讨论了两类平静和两类b值变化的可能原因。     

Inferring erosional resistance of bedrock units in the east Tennessee mountains from digital elevation data

Measures of local relief, regional relief, and slope were calculated from digital elevation models (DEMs) for 50 bedrock units in the Ridge and Valley and Blue Ridge provinces of Tennessee. Each of these measures was normalized and the three were then averaged to produce the erosional resistance index (ERI). Bedrock units with higher ERI values include coarse clastics, intermediate clastics, and metaplutonics. Units with lower values include shales, limestones, limestones plus dolostones, and carbonates plus fine clastics. Dolostones tend to have intermediate values. The calculated ERI values were compared with subjective ratings by a geologist with decades of field experience in east Tennessee. Generally, the agreement between the two ratings was good, the most glaring exception being several shales with improbably high ERI values. These turned out to be thin units cropping out beneath very hard sandstones, allowing them to stand higher and steeper than would otherwise be possible. A systematic method for detecting such erroneously high ERI values is suggested. Inspection of a drainage map superimposed on the geology map shows that in a given area, streams tend to flow on rock units with the lowest ERI values. In addition, statistical analysis shows that bedrock units with the lowest ERI values are, on average, almost three times closer to the nearest stream and six times as likely to have streams flowing on them than are units with highest values. Further, the effect of ERI on stream location is strongest for streams with drainage areas between 1 and 30 km². Thus, small streams appear to be subject to greater lithologic control than are larger streams.     

软弱结构面粒度成分与抗剪强度参数的关系探讨

软弱结构面一直是水电工程建设中的一个重要工程地质问题, 选取合理的力学参数对大坝建基面的选取及未来坝基抗滑稳定性具有重大意义。本文在大量试验资料基础上, 研究了沉积岩地区某重力坝电站坝址区软弱夹层粒度成分和抗剪强度参数之间的相关关系, 建立了不同稠度状态下的相关方程。并结合《混凝土重力坝设计规范》中提出的用粒度成分定量指标选取软弱结构面抗剪强度参数, 对软弱结构面抗剪强度参数取值问题进行了探讨。