Hydrogeological monitoring was conducted around a pilot cavern for underground cryogenic LNG (Liquefied Natural Gas) storage. The monitoring was mainly focused on the operation of a drainage and recharge system. After the operation of the drainage system commenced, the drainage rate decreased rapidly in the initial stages and then decreased gradually. Hydrogeological monitoring revealed that the rock drainage system operated effectively. During drainage, the water table was maintained below the cavern roof. The recharge for ice-ring formation was performed in two phases. The first phase involved the cessation of pumping in downward-drainage holes and the second involved the closure of upward boreholes. Since the water table was maintained below the cavern roof, artificial recharge was planned at first. However, it was not implemented due to heavy rainfall in the recharge stage. On the basis of hydrogeological monitoring and hydraulic tests, it was found that the fractures above the roof and on the right wall of the pilot cavern mainly affected seepage into the cavern and thermal variation due to the storage of liquid nitrogen. Thermal variation was examined by the thermometers installed around the pilot cavern. The cooling and thawing processes reveal the characteristics of thermal distribution in the rock and the 0 °C isotherm. The cooling phase lasted for six months, and the 0 °C isotherm progressed in time after the injection of liquid nitrogen into the cavern. The isotherm propagated up to about 4 m from the floor and the sidewall of the cavern and about 3 m from the cavern roof. The cooling rate of the rock mass above the cavern roof was lower than that of the other cavern sides due to the gaseous space in the upper part of the containment. The fractures were analyzed and considered for thermal modeling. A two-dimensional finite element analysis was performed to compare the field monitoring at the pilot cavern. The numerical modeling shows the distance between the ice ring and heat transfer pattern of the fractures around the pilot cavern. The propagation of the measured and calculated 0 °C isotherm reveals that the water-conveying joint on the right wall might affect thermal propagation through a thermal pipe. 相似文献
The influence of rock fabric on physical weathering due to the salt crystallization of selected brecciated dolostones is discussed. These dual-porosity dolostones are representative of heterogeneous and anisotropic building rocks, and present highly complex and heterogeneous rock fabric features. The pore structure of the matrix and clasts is described in terms of porosity and pore size distribution, whereas the relative strength for each textural component is assessed using the Knoop hardness test. The whole characterisation process was carried out using the same samples as those used in the standard salt durability test (EN-12370), including connected porosity, the water saturation coefficient, fissure density, compressional wave velocity and waveform energy.
Results show the most important rock fabric elements to be considered are the matrix and clast properties and the nature of fissures. Firstly, a relatively weak matrix was the focus of major granular disintegration as it presents high porosity, low pore radius and reduced strength. Secondly, narrow micro-fissures appear to be important in the decay process due to the effectiveness of crystallization pressure generated by salt growth. On the contrary, macro-fissures do not contribute greatly to rock decay since they act as sinks to consume the high supersaturations caused by growth of large crystals. Additionally, an analysis of stress generated by crystallization was carried out based on the general situation of a lenticular crystal geometry. Finally, the relationships between whole petrophysical properties and durability were established using a principal component analysis. This analysis has clearly established that the durability of rocks affected by salt crystallization mechanisms diminishes in weaker and anisotropic rocks with high porosity and fissure density. 相似文献
We report single-grain quartz luminescence ages for the Puritjarra rock shelter, with the aim of resolving an apparent discrepancy between ages obtained by 14C and a variety of luminescence methods, previously reported. Ages now found at all depths to 75 cm (ages to 30 ka) can be interpreted as largely resolving the differences. This implied caveat arises because single-grain methods are statistically inefficient. As a consequence, a degree of interpretation is inevitable in analysing the data. The emphasis in the present paper is an analysis making use of weighted histograms. The measurements by single grain OSL and 14C, including ABOX–SC, taken together, can be regarded as compatible. They indicate human occupation of the Puritjarra rock shelter at least as early as 30 ka BP. 相似文献
This paper presents the development and utilisation of an automated image processing algorithm for detection and analysis
of grains. Using optical polarising microscopy, a set of colored images are collected from an area on a thin section. A filtering
operation, using rotation of a morphological alternating sequence filter (based on a structuring element), is used to remove
twinning features within individual grains. Filtering is followed by the watershed segmentation technique to determine grain
boundaries. The method is used for the identification of calcite grains in marble and the subsequent analysis of morphological
anisotropy. 相似文献
Aerodynamic parameters including the zero-plane displacement (d), roughness length (20), and friction velocity (u*) on the different underlying surfaces of heavy-grazing site, medium-grazing site, light-grazing site, no-grazing site, dune, inter-dune, grassland, rice paddy site, wheat site, soybean site, and maize site have been computed based on the Monin-Obukhov similarity theory by utilizing the micrometeorologically observed data of dune and vegetation in the semi-arid area at Naiman, Inner Mongolia of China, conducted jointly by the Institute of Desert Research, Chinese Academy of Sciences and the National Institute of Agro-Environmental Sciences of Japan in 1990-1994. And their relationships between wind speed and Richardson number are analyzed. The aerodynamic characteristics of different man-made disturbed grassland ecosystems are also compared. Result shows that the vegetation coverage and the above-ground biomass decrease with the increase in man-made stress of the grassland. The roughness length for different underlying surfaces is closely related to vegetation height, above-ground biomass, and ground surface undulation, and Richardson number Ri is also its influencing factor. The friction velocity varies largely on different underlying surfaces, and it is positively proportional to wind speed and roughness length. The aerodynamic parameters of various times on the same underlying surface are different, too. Above results indicate that grassland and vegetation are of significance in preventing desertification, especially in the arid and semi-arid land ecosystems. And the results of this paper are also important for constructing the land surface physical process as well as regional climate model. 相似文献