材料状态对干砂小应变特性的影响

利用注能虚拟质量(EIVM)共振柱系统进行了干砂小应变特性试验,研究了有效平均正应力、土样密度、剪应变幅值以及荷载往复次数对剪切模量和阻尼比的影响。试验结果表明,剪切模量随有效平均正应力与土样密度的增加而增加,而阻尼比的变化规律则与之相反,并且有效平均正应力对干砂小应变特性的影响程度比土样密度的影响程度大得多;随着剪应变的增加,剪切模量越来越小,而阻尼比越来越大;荷载往复次数对剪切模量基本没有影响,而对阻尼比有较大影响。     

Empirical calibration of climate policy using corporate solvency: a case study of the UK’s carbon price support

Emission reductions improve the chances that dangerous anthropogenic climate change will be averted, but could also cause some firms financial distress. Corporate failures, especially if they are unnecessary, add to the social cost of abatement. Social value can be permanently destroyed by the dissolution of organizational capital, deadweight losses paid to liquidators, and unemployment. This article proposes using measures of corporate solvency as an objective tool for policy makers to calibrate the optimal stringency of climate change policies, so that they can deliver the least loss of corporate solvency for a given level of emission reductions. They could also be used to determine the generosity of any compensation to address losses to corporate solvency. We demonstrate this approach using a case study of the UK’s Carbon Price Support (a carbon tax).

Key policy insights

• Solvency metrics could be used to empirically calibrate the optimal stringency of climate policies.

• An idealized solvency trajectory for firms affected by climate change policy would cause corporate solvency to initially decline – approaching but not exceeding ‘distressed’ levels – and then gradually improve to a new ‘steady state’ once the low-carbon transition had been achieved.

• In terms of the UK’s Carbon Price Support, corporate solvency of energy-intensive industries was found to be stable subsequent to its introduction. Therefore, the available evidence does not support its later weakening.

     

An Interpretation of ISO Guidelines for the Certification of Geological Reference Materials

Recommendations for the certification of reference materials, as published by the International Organisation for Standardisation (ISO), are reviewed and proposals made as to how they can be adapted for the certification of new geological reference materials. Whilst acknowledging the important contribution made by the large number of existing matrix-matched geological reference materials, it is recommended that future characterisation programmes should follow the ISO guidelines for certification, not the least so that laboratories can readily use the resultant samples to establish the traceability of geoanalytical results.     

Mapping QTLs of caudal fin length in common carp (Cyprinus carpio L.)

Common carp (Cyprinus carpio L.) exhibits significant morphological variability in the shape and size of the caudal fin. In this study, we used 190 progeny from two F₁ parents to identify and map quantitative trait loci (QTLs) that influence caudal fin length (CFL) and the ratio (RCS) between caudal fin length and standard length (SL) based on a microsatellite genetic map of common carp. A total of 15 QTLs were detected in seven different linkage groups. One significant and eight suggestive QTLs affecting CFL were identified on LG8, LG14, LG29, LG32 and LG44, which explained 8.0%–22.1% of the phenotypic variation; six suggestive QTLs affecting RCS were detected on LG8, LG32, LG46 and LG48, which explained 7.0%–15.4% of the phenotypic variation. The QTLs for caudal fin length detected in this study may serve as a starting point for identification of genes involved in caudal fin development in common carp.     

Optimal design of two-dimensional wings in ground effect using multi-objective genetic algorithm

The shape optimization of the 2-dimensional wing in ground effect (WIG) has been performed by the integration of CFD (computational fluid dynamics) and MOGA (multi-objective genetic algorithm). Because of the trade-off between the aerodynamic forces and the height stability, it is difficult to satisfy the design requirements of efficiency and stability at the same time. In this study, the lift coefficient, the lift-drag ratio and the static height stability are chosen as the objective functions to obtain the optimal wing profiles of a WIG craft. An NACA0015 airfoil is used for the baseline model; the aerodynamic characteristics of the base model are compared with that of the optimal solutions. The profile of the airfoil is constructed by four Bezier curves with fourteen control points resulting in the eighteen coordinates, which are adopted as the design variables. The optimal solutions of the multi-objective optimization are not unique but a set of the non-dominated optima: the Pareto frontiers or a Pareto set. As the results of the multi-objective optimization, the forty Pareto optima, which include high-lift, high-efficiency, and more stable airfoils on the edge of the 3-dimensional objective space, are obtained at thirty evolutions of the generation.     

水平轴潮流能叶轮尖速比特性分析研究

针对设计尖速比对水平轴潮流能叶轮动力特性的影响问题开展研究工作。基于叶素-动量理论建立叶轮动力特性仿真模型,以叶片数量分别为2、3、4的叶轮为对象,考察设计尖速比对叶轮的功率系数的影响。研究结果表明:设计尖速比越大的叶轮,其最大效率也越高;叶片数量多的叶轮,其功率系数略优于叶片数量少的叶片。结合分析结果,给出了水平轴潮流能叶轮的设计尖速比的选择建议。     

MedFlux: Investigations of particle flux in the Twilight Zone

The MedFlux project was devised to determine and model relationships between organic matter and mineral ballasts of sinking particulate matter in the ocean. Specifically we investigated the ballast ratio hypothesis, tested various commonly used sampling and modeling techniques, and developed new technologies that would allow better characterization of particle biogeochemistry. Here we describe the rationale for the project, the biogeochemical provenance of the DYFAMED site, the international support structure, and highlights from the papers published here. Additional MedFlux papers can be accessed at the MedFlux web site (http://msrc.sunysb.edu/MedFlux/).     

Calculation and analysis of negative skin of monopile applied for offshore wind turbine

Monopiles are considered to be as a kind of viable foundation types for offshore wind turbines. The effect of negative skin friction on pile foundation is always an important problem. There are very important theoretical and practical significance to study the distribution law of negative skin friction and the calculation method. Based on the special stratum, the stress and strain of the monopile and soil are simplified, and the improved Kezdi’s double-broken-line model is adopted. The analytical solution of negative skin friction of monopile is deduced according to the degree of skin friction. An engineering case was analyzed by the method, and the calculated results agree well with the measured data. The calculation method proposed can accurately describe the range of the monopile skin frictional distribution and the position of the neutral point, and it is simple and convenient to calculate, that is also a feasible method for calculating the negative skin friction of monopile of offshore wind turbines in practical engineering.     

Sharks caught in the KwaZulu-Natal bather protection programme,South Africa. 14. The smooth hammerhead shark Sphyrna zygaena (Linnaeus)

The current study provides long-term catch-rate, biological and feeding data for smooth hammerhead sharks, Sphyrna zygaena, caught in South Africa’s KwaZulu-Natal bather protection programme. In total, 2 512 S. zygaena were caught in net installations between 1978 and 2014, and 72 S. zygaena were caught on drumlines between 2007 and 2014. There was no significant log-linear year trend in the net catch rate over time (slope = 0.0054, t = 1.808, p = 0.07). However, there was a significant temporal increase in mean size of the captured sharks (slope = 0.0012, t = 3.502, p < 0.001). A quasi-Poisson generalised additive mixed model showed that increasing latitude, winter months, colder sea temperatures and the deployment of drumlines all had a significant positive effect on the catch rate of sharks in nets. The size frequency of the catch was unimodal, with significantly more females caught in the nets and more males on the drumlines. The majority (93.1%) of all sharks caught were immature and measured between 80 and 120 cm precaudal length. Teleosts and cephalopods dominated the sharks’ diet in terms of all dietary indices. The prey species consumed indicate that immature S. zygaena are feeding primarily within the pelagic zone of shallow coastal habitats.