Shallow seismic measurements in harzburgite from the Oman ophiolite performed in a zone where the maximum horizontal anisotropy is expected (vertical foliation and horizontal lineation) point to a dominant dependence of seismic properties on fracturing.
Optical microscopy studies show that microcracks are guided by the serpentine (lizardite) penetrative network oriented subparallel to the harzburgite foliation and subperpendicular to the mineral lineation, and that serpentine (lizardite) vein filling has a maximum concentration of (001) planes parallel to the veins walls. The calculated elastic properties of the oriented alteration veins filled with serpentine in an anisotropic matrix formed by oriented crystals of olivine and orthopyroxene are compared with seismic velocities measured on hand specimens.
Laboratory ultrasonic data indicate that open microcracks are closed at 100 MPa pressure, e.g. (J. Geophys. Res. 65, (1960) 1083) and (Proc. ODP Sci. Results Leg 118, (1990) 227). Above this pressure, laboratory measurements and modeling show that P-compressional and S-shear wave velocities are mainly controlled by the mineral preferred orientation. Veins sealed with serpentine are effective in slightly lowering P and S velocities and increasing anisotropy. The penetrative lizardite network does not affect directly the geometry of seismic anisotropy, but contributes indirectly in the fact that this network controls the microcrack orientations.
Comparison between seismic measurements of peridotite and gabbro in the same conditions suggest that P- and S-waves anisotropies are a possible discriminating factor between the two lithologies in the suboceanic lithosphere. 相似文献
The formation of late‐stage veins can yield valuable information about the movement and composition of fluids during uplift and exhumation of high‐pressure terranes. Albite veins are especially suited to this purpose because they are ubiquitously associated with the greenschist facies overprint in high‐pressure rocks. Albite veins in retrogressed metabasic rocks from high‐pressure ophiolitic units of Alpine Corsica (France) are nearly monomineralic, and have distinct alteration haloes composed of actinolite + epidote + chlorite + albite. Estimated P–T conditions of albite vein formation are 478 ± 31 °C and 0.37 ± 0.14 GPa. The P–T estimates and petrographic constraints indicate that the albite veins formed after the regional greenschist facies retrogression, in response to continued decompression and exhumation of the terrane. Stable isotope geochemistry of the albite veins, their associated alteration haloes and unaltered hostrocks indicates that the vein‐forming fluid was derived from the ophiolite units and probably from the metabasalts within each ophiolite slice. That the vein‐forming fluid was locally derived means that a viable source of fluid to form the veins was retained in the rocks during high‐pressure metamorphism, indicating that the rocks did not completely dehydrate. This conclusion is supported by the observation of abundant lawsonite at the highest metamorphic grades. Fluids were liberated during retrogression via decompression dehydration reactions such as those that break down hydrous high‐pressure minerals like lawsonite. Albite precipitation into veins is sensitive to the solubility and speciation of Al, which is more pressure sensitive than other factors which might influence albite vein formation such as silica saturation or Na:K fluid ratios. Hydraulic fracturing in response to fluid generation during decompression was probably the main mechanism of vein formation. The associated pressure decrease with fracturing and fluid decompression may also have been sufficient to change the solubility of Al and drive albite precipitation in fracture systems. 相似文献
