板钉连接CFST柱-RC梁节点梁端塑性铰区受力性能数值模拟

建立竖板-栓钉连接钢管混凝土（CFST）柱-钢筋混凝土（RC）梁节点试件（SSJD）拟静力加载试验有限元模型,并在节点损伤情况、梁端荷载-位移曲线等数值模拟结果与试验结果吻合较好的基础上,进一步开展了RC梁混凝土强度、配筋率ρ_s和连接竖板长度L_b及界面连接情况等对CFST柱-RC梁节点梁端塑性铰区域力学性能的影响。研究结果表明,RC梁混凝土强度对试件SSJD塑性铰区域受力性能的影响较小;适筋范围内RC梁配筋率增加可适当提高试件SSJD承载力和延性;随着连接竖板长度的增加,梁端塑性铰区域外移,梁破坏荷载增大;本研究给出的RC梁与CFST柱之间的界面抗剪承载力模拟值与计算值吻合较好,可用于界面抗剪设计。     

Numerical simulation of deep-hole resistivity anomaly caused by drilling construction in Xinfengjiang geoelectric station

The Xinfengjiang reservoir in Guangdong Province, is one of the large reservoirs that have triggered earthquakes of magnitude greater than 6. Numerous earthquakes have occurred since the impoundment of the reservoir, making it one of the most active seismic zones in south China. In 2015, a set of deep-hole resistivity anomalies was observed in the Heping geoelectric station in Dongyuan county, located near the Xinfengjiang reservoir. After a field investigation, we found that a planned well drilling construction of new measuring channels was being carried out during that corresponding period of time. After careful comparison and analysis on the basis of the collected raw data, we had a reason to believe that drilling construction, rather than the inducement of the Xinfengjiang reservoir, was the main culprit for those unusual georesistivity values. So as to verify the above conjecture, we constructed a series of 3D finite element models based on the geological and hydrological information around Heping station and analyzed the drilling disturbances, respectively. Some significant conclusions were finally drawn according to the precise numerical simulation. This study gives a good example by combining numerical simulation with engineering practice as a way to understand the root cause of georesistivity anomalies in reality.     

Seismic performance of two-story subway station structures with different isolating systems

When the sliding bearing is fixed only at the top of the middle column of the underground structure, the cracks at the side end of the middle plate should be aggravated while the seismic damage of the mid-column should be alleviated. To enhance the seismic performance of the mid-plate, a new isolation design method has been mentioned while the elastic sliding bearings are set at the top of the mid-columns and between the side end of the mid-plate and the side wall at the same time. By establishing a nonlinear finite element analysis model for the static-dynamic coupling interaction system, the seismic response characteristics of the cast-in-place station structure without a sliding bearing have been analyzed and compared with those of the station structure with the sliding bearing fixed only at the top of the middle columns, and those of the station structure with sliding bearing be fixed between the mid-plate and the sidewall at the same time. The results show that the new isolation station structures suffer fewer earthquake damages at the mid-plate and mid-columns at the same time, which can improve the overall seismic performance of the subway station structure.     

煤矿老窑采空区地—井TEM响应特征

瞬变电磁法在我国广泛应用于煤田水文地质勘探和采空区调查,但由于方法本身的特点,地面装置纵向分辨率低,无法实现采空区精细探测。在山西某煤矿采空区探查项目中,通过岩心、测井曲线,结合以往电法勘探经验,建立了简单的煤系地层采空区模型,数值模拟了均匀半空间采空区含水、不含水时的地面瞬变电磁响应和三维水平薄板的地—井瞬变电磁响应,并结合实际案例探讨了采空区的地面、地—井瞬变电磁特征,证实了地—井瞬变电磁法具有较高的纵向分辨率,为采空区精细探查提供了思路。     

大地电磁测深反演技术有效性对比试验

设计了一个简单的三维模型:三维低阻异常体和高阻异常体位于一维层状介质模型中,以"十"字型和"米"字型观测剖面方式作为模拟方式,开展模型一维、二维、三维反演技术有效性对比试验,其中一维反演计算采用自适应正则化(ARIA)反演,二维反演计算采用非线性共轭梯度(NLCG)反演,三维反演计算采用REBOCC三维反演,将剖面下方不同的反演结果与原始模型进行对比分析,发现:在该模型条件下,一维和二维反演都能得到反映模型真实信息的结果,REBOCC三维反演更偏向重建原始模型的宏观电性特征;在一维反演结果中,对于深部的电性结构特征,通常TE极化模式的反演结果好于TM极化模式,TE/TM几何平均值反演结果介于前两者之间;在二维反演结果中,通常TM极化模式的反演结果好于TE极化模式,TE/TM联合模式反演结果与TM极化模型相当,甚至更好;模型REBOCC三维反演相比一维、二维反演更易受反演结果多解性影响,REBOCC三维反演结果偏向重建原始模型的宏观电性特征。     

油气藏水力压裂计算模拟技术研究现状与展望

水力压裂技术是油气藏尤其是页岩气开发中的核心技术,利用数值模拟方法进行压裂优化和产能预测又是水力压裂成功的关键。本文首先介绍了水力压裂技术的发展历程。然后从计算模型(二维模型、拟三维模型和全三维模型)和数值模拟方法(基于连续介质和基于非连续介质)两方面对油气藏开发领域的水力压裂计算模拟技术进行较全面的总结。最后,从以下3个方面指出现今研究的不足并提出了进一步的研究建议:(1)全三维模型的完善-全三维模型应当与真实的工程参数和监测数据结合,用于校正模型本身,而校正后的全三维模型又可预测和优化新的现场水力压裂作业; (2)数值模拟方法的选用-已有的水力压裂数值模拟方法种类繁多,需要针对各种方法的适用范围、计算效率和模拟效果等,进行全面的比较和优化; (3)页岩储层中天然裂缝网络的数值模拟-天然裂隙网络加剧了页岩储层力学性质的各向异性,同时水力裂缝沟通天然裂缝活化扩展是有利于储层的增渗增产,对压裂缝网的形态、尺寸和连通率等起着至关重要的作用。因此,数值计算过程中综合考虑页岩储层中天然裂缝与水力裂缝的相互作用,将是未来水力压裂模拟的热点。     

动力因子对地形影响下的四川暴雨落区的诊断分析

本文分析了2010年7月16～18日地形作用下四川盆地的一次持续性暴雨过程,指出此次暴雨过程是在高低层系统配置较好的情况下发生的。并以NCEP资料为初值场对此次暴雨过程进行了数值模拟,结合实况对模拟结果进行对比分析。分析表明:模式对本次四川暴雨过程的模拟较为成功,能很好地再现此次暴雨的降水落区以及强降水中心。运用广义湿位温、广义对流涡度矢量垂直分量的垂直积分和质量垂直螺旋度对受大巴山脉影响的四川东北部的暴雨落区进行了诊断分析。分析指出,广义湿位温纬向平均的垂直剖面图上,等湿位温线的倒Ω区域与四川东北部的强降水落区吻合较好,等湿位温线的倾斜程度以及湿位温异常的高度可以定性地指示降水的强弱;对广义湿位温从800 hPa到500 hPa垂直积分,用得到的湿位温的水平分布来指示东北部的暴雨落区效果较 好;用改进垂直积分区间后的广义对流涡度矢量垂直分量比用传统的对流涡度矢量垂直分量来示踪四川东北部的暴雨落区效果更好;质量垂直螺旋度能有效刻画出四川东北部地区强降水系统的典型动力场垂直结构,因此与四川东北部的地面强降水具有很好的对应关系。     

Perverse incentives under the CDM: an evaluation of HFC-23 destruction projects

The clean development mechanism (CDM) under the Kyoto Protocol allows industrialized countries to use credits from greenhouse gas (GHG) abatement projects in developing countries. A key requirement of the CDM is that the emission reductions be real, measurable and additional. This article uses data from registered projects to evaluate the extent to which these objectives are met by projects that reduce hydrofluorocarbon-23 (HFC-23) emissions in the production of hydrochlorofluorocarbon-22 (HCFC-22). The data show that HCFC-22 plants produced significantly less HFC-23 during periods when no emission credits could be claimed compared with periods when HFC-23 destruction could be credited under the CDM. Moreover, the total amount of HCFC-22 produced appears to be determined mainly by CDM rules. This suggests that the claimed emission reductions may partly not be real and that the CDM provides perverse incentives to generate more HFC-23. The accelerated phase-out of HCFCs under the Montreal Protocol on Substances that Deplete the Ozone Layer could worsen this situation. To address these issues an ambitious emission benchmark for the baseline HFC-23 emissions is proposed.     

半Lagrange法在数值预报中的应用和近年来的发展(Ⅰ)

本文就五十年代以来半Lagrange法在数值预报中的应用和近年来的发展进行评述,介绍我国在这方面的工作。还就此法和Euler法的优缺点作了比较;指出了存在的问题。