A singular evolutive extended Kalman filter to assimilate ocean color data in a coupled physical–biochemical model of the North Atlantic ocean

Within the European DIADEM project, a data assimilation system for coupled ocean circulation and marine ecosystem models has been implemented for the North Atlantic and the Nordic Seas. One objective of this project is to demonstrate the relevance of sophisticated methods to assimilate satellite data such as altimetry, surface temperature and ocean color, into realistic ocean models. In this paper, the singular evolutive extended Kalman (SEEK) filter, which is an advanced assimilation scheme where three-dimensional, multivariate error statistics are taken into account, is used to assimilate ocean color data into the biological component of the coupled system. The marine ecosystem model, derived from the FDM model [J. Mar. Res. 48 (1990) 591], includes 11 nitrogen and carbon compartments and describes the synthesis of organic matter in the euphotic zone, its consumption by animals of upper trophic levels, and the recycling of detritic material in the deep ocean. The circulation model coupled to the ecosystem is the Miami isopycnic coordinate ocean model (MICOM), which covers the Atlantic and the Arctic Oceans with an enhanced resolution in the North Atlantic basin. The model is forced with realistic ECMWF ocean/atmosphere fluxes, which permits to resolve the seasonal variability of the circulation and mixed layer properties. In the twin assimimation experiments reported here, the predictions of the coupled model are corrected every 10 days using pseudo-measurements of surface phytoplankton as a substitute to chlorophyll concentrations measured from space. The diagnostics of these experiments indicate that the assimilation is feasible with a reduced-order Kalman filter of small rank (of order 10) as long as a sufficiently good identification of the error structure is available. In addition, the control of non-observed quantities such as zooplankton and nitrate concentrations is made possible, owing to the multivariate nature of the analysis scheme. However, a too severe truncation of the error sub-space downgrades the propagation of surface information below the mixed layer. The reduction of the actual state vector to the surface layers is therefore investigated to improve the estimation process in the perspective of sea-viewing wide field-of-view sensor (SeaWiFS) data assimilation experiments.     

The permeability of faults within siliciclastic petroleum reservoirs of the North Sea and Norwegian Continental Shelf

Faulting in Middle Jurassic reservoirs occurred at shallow depth during regional extension. Clean sandstones (<15% clay) deformed without significant grain fracturing and permeability reduction. Faults in impure sandstones (15–40% clay) experienced significant syn-deformation compaction and permeability reduction. Enhanced compaction during deeper burial reduced their permeabilities further from an average of 0.05 mD at <2.5 km to 0.001 mD at >4 km. Clay-rich sediments (>40% clay) deformed to produce clay smears with very low permeabilities (<0.001 mD). Faulting in the Rotliegendes occurred at greater depth during both basin extension and inversion. Extensional faulting produced cataclasites with permeability reductions of <10–>10⁶; their permeabilities range from 0.2 to 0.0001 mD and are inversely related to their maximum burial depth. Faults formed or reactivated during inversion experienced permeability increase. These results can be extrapolated to other hydrocarbon reservoirs if differences in stress and temperature history are taken into account.The permeability of most (>80%) faults is not sufficiently low, compared to their wallrock, to retard single-phase fluid flow on a km-scale. Nevertheless, most faults could retard the flow of a non-wetting phase if present at low saturations. It may be necessary to incorporate the two-phase fluid flow properties of fault rocks into reservoir simulators using upscaling or pseudoisation techniques. Fault property data should be calibrated against production data before it can be used confidently.     

Topographic Effect of Izu Ridge on the Distribution of the North Pacific Intermediate Water South of Japan

The topographic effect of the Izu Ridge on the horizontal distribution of the North Pacific Intermediate Water (NPIW) south of Japan has been studied using observational data obtained by the Seisui-Maru of Mie University (Mie Univ. data) and those compiled by Japan Oceanographic Data Center (JODC data). Both data sets show that water of salinity less than 34.1 psu on potential density () surface of 26.8 is confined to the eastern side of the Izu Ridge, while water of salinity less than 34.2 psu is confined to the southern area over the Izu Ridge at a depth greater than 2000 m and to the southeastern area in the Shikoku Basin. It is also shown by T-S analysis of Mie Univ. data over the Izu Ridge that water of salinity less than 34.2 psu dominates south of 30°N, where the depth of the Izu Ridge is deeper than 2000 m and NPIW can intrude westward over the Izu Ridge. JODC data reveal that relatively large standard deviations of the salinity on surface of 26.7, 26.8 and 26.9 are detected along the mean current path of the Kuroshio and the Kuroshio Extension. Almost all of the standard deviations are less than 0.05 psu in other area with the NPIW, which shows that the time variation in the salinity can be neglected. This observational evidence shows that the topographic effect of the Izu Ridge on the horizontal distribution of the NPIW, which is formed east of 145°E by the mixing of the Kuroshio water and the Oyashio water, is prominent north of 30°N with a depth shallower than 2000 m.     

郯庐断裂带的断裂活动对渤海东部中、新生代裂谷盆地发育的控制作用

郯庐断裂带自南而北穿越渤海东部,自中生代中期至新生代中期表现裂谷发育特征。裂谷发育经历两个旋回,各旋回的裂谷发育演化、盆地分布格局,沉积相带,沉积补偿速度等均受断裂带的断裂活动的强烈控制。     

红河断裂构造带在东南亚的延伸特征及其大地构造意义

根据地质、地貌及地球物理资料分析,探讨展布于云南边陲哀牢山两侧的北西向断裂组成的红河断裂构造带,在东南亚的延伸特征。提出在该延伸带两侧沉积建造、构造活动,地球物理场和大地构造发展上均有显著差异。并进一步探讨该断裂构造带在大地构造上的意义。     

The Aleutian Low, storm tracks, and winter climate variability in the Bering Sea

Previous studies have found inconsistent results regarding how wintertime conditions in the Bering Sea relate to variations in the North Pacific climate system. This problem is addressed through analysis of data from the NCEP/NCAR Reanalysis for the period 1950–2003. Composite patterns of sea-level pressure, 500 hPa geopotential heights, storm tracks and surface air temperature are presented for four situations: periods of strong Aleutian Low, weak Aleutian Low, warm Bering Sea air temperatures, and cold Bering Sea air temperatures. Winter temperatures in the Bering Sea are only marginally related to the strength of the Aleutian Low, and are much more sensitive to the position of the Aleutian Low and to variations in storm tracks. In particular, relatively warm temperatures are associated with either an enhanced storm track off the coast of Siberia, and hence anomalous southerly low-level flow, or an enhanced storm track entering the eastern Bering Sea from the southeast. These latter storms do not systematically affect the mean meridional winds, but rather serve to transport mild air of maritime origin over the Bering Sea. The leading indices for the North Pacific, such as the NP and PNA, are more representative of the patterns of tropospheric circulation and storm track anomalies associated with the strength of the Aleutian Low than patterns associated with warm and cold wintertime conditions in the Bering Sea.