Ongoing methane discharge at well site 22/4b (North Sea) and discovery of a spiral vortex bubble plume motion

First direct evidence for ongoing gas seepage activity on the abandoned well site 22/4b (Northern North Sea, 57°55′ N, 01°38′ E) and discovery of neighboring seepage activity is provided from observations since 2005. A manned submersible dive in 2006 discovered several extraordinary intense seepage sites within a 60 m wide and 20 m deep crater cut into the flat 96 m deep seafloor. Capture and (isotope) chemical analyses of the gas bubbles near the seafloor revealed in situ concentrations of methane between 88 and 90%Vol. with δ¹³C–CH₄ values around −74‰ VPDB, indicating a biogenic origin. Bulk methane concentrations throughout the water column were assessed by 120 Niskin water samples showing up to 400.000 nM CH₄ in the crater at depth. In contrast, concentrations above the thermocline were orders of magnitude lower, with a median value of 20 nM. A dye tracer injection into the gas seeps revealed upwelling bubble and water motion with gas plume rise velocities up to ∼1 ms⁻¹ (determined near the seabed). However, the dissolved dye did not pass the thermocline, but returned down to the seabed. Measurements of direct bubble-mediated atmospheric flux revealed low values of 0.7 ± 0.3 kty⁻¹, much less than current state-of-the-art bubble dissolution models would predict for such a strong and upwelling in situ gas bubble flux at shallow water depths (i.e. ∼100 m).Acoustic multibeam water column imaging data indicate a pronounced 200 m lateral intrusion at the thermocline together with high methane concentration at this layer. A partly downward-orientated bubble plume motion is also visible in the acoustic data with potential short-circuiting in accordance to the dye experiment. This observation could partly explain the observed trapping of most of the released gas below the well-established thermocline in the North Sea. Moreover, 3D analyses of the multibeam water column data reveal that the upwelling plume transforms into a spiral expanding vortex while rising through the water column. Such a spiral vortex motion has never been reported before for marine gas seepage and might represent an important process with strong implication on plume dynamics, dissolution behavior, gas escape to the atmosphere, and is considered very important for respective modeling approaches.     

Long-term development and current status of the Barcelona continental shelf: A source-to-sink approach

The Barcelona continental shelf, off the city of Barcelona (NE Spain), is a relatively narrow canyon-bounded shelf in the northwestern Mediterranean Sea. Three medium-size rivers (Tordera, Besós and Llobregat) and several ephemeral rivulets flow into this margin. Two main domains have been recognized in the Barcelona shelf: (i) a modern, river-influenced area, and (ii) a relict, sediment depleted area, both affected by a variety of human impacts. A detailed geomorphologic study based on multibeam bathymetry and backscatter data, high resolution seismic profiles, and surface sediment samples allowed mapping and interpreting the main distinctive seafloor features on the Barcelona shelf. Modern sedimentary features reveal that the Llobregat River is the main sediment source of the Barcelona prodeltaic shelf. High-discharge fluvial events result in the formation of suspended sediment plumes and sediment waves on the shelf floor. Relict (late Pleistocene–Holocene) sedimentary features reflect that an important shift occurred in the seashore direction between MIS 4 and MIS 2, and that recent neotectonic reactivation has created a set of seafloor faults. The Barcelona inner and middle shelf is severely impacted by anthropogenic activities such as the enlargement works of the Port of Barcelona, sewage pipes, dredging, anchoring and trawling.     

Qualitative and Quantitative Description of Multibeam Echosounder Systematic Errors on Rocky Areas

This paper deals with the problem of systematic depth errors made in surveying dumped rocks with multibeam echosounder. These errors may induce dangers for navigation in very shallow water areas or huge costs for coastal engineering contractors who perform rock dumping operation and surveying. We analyze results from four different multibeam echosounder systems and compare those data to a reference digital terrain model of a dumped rocks area obtained from a 3D terrestrial laser scanner. The systematic depth errors are statistically described and analysed on local areas. Finally, we propose a look-up table linking the error amplitude with the rock size, resulting from our error analysis.     

Characteristics of Seafloor Morphology and Ferromanganese Nodule Occurrence in the Korea Deep-sea Environmental Study (KODES) Area, NE Equatorial Pacific

Seafloor morphology and ferromanganese nodule occurrence were studied using a multibeam side scan sonar (SeaBeam, 2000) and a deep-sea camera system in the Korea Deep-sea Environmental Study (KODES) area, northeast equatorial Pacific. Seafloor morphology and nodule abundance are highly variable even in this small study area. The NNE-SSW oriented hills are parallel and about 100-200 m high. Valleys are very flat-floored, while hilltops are rugged with depressions of tens of meters. Cliffs to about 100 m bound the valleys and the hills. The study area can be classified into three types based both on nodule occurrence and seafloor morphology, mostly G- and B-types and some M-type. G-type is characterized by high nodule abundance, ubiquitous bioturbation, and flat seafloor morphology, while B-type is characterized by irregular-shaped nodules, variable nodule abundance, occurrence of giant nodules and sediment lumps, rugged bottom morphology with depressions, and white calcareous surface sediments. Medium nodule abundance and a generally flat seafloor characterize M-type. G-type occurs mostly in the valley regions, while B-type is on the hilltop areas. M-type is located between the hilltop and the valley. Tectonic movement of the Pacific plate resulted in the elongated abyssal hills and cliffs. The rugged morphology on hilltops resulted from erosion and redistribution of surface siliceous sediments on hilltops by bottom currents, outcropping of underlying calcareous sediments, and dissolution of the carbonate sediments by corrosive bottom water undersaturated with CaCO 3 . Sediment eroded from the hills, which is relatively young and organic-rich, is deposited in the valleys, and diagenetic metal supply to manganese nodules in the valley area is more active than on the hills. We suggest that tectonic movement ultimately constrains morphology, surface sediment facies, bottom currents and sediment redistribution, bioturbation, thickness of the sedimentary layer, and other conditions, which are all interrelated and control nodule occurrence. The best potential area for mining in the study area is the G-type valley zones with about 3-4 km width and NNW-SSE orientation.     

Drowned shelf-edge deltas, barrier islands and related features along the outer continental shelf north of the head of De Soto Canyon, NE Gulf of Mexico

Four drowned shelf-edge delta complexes, two drowned shelf deltas, three drowned barrier islands, large areas of “hardground”, and fields of bedforms on the mid and outer continental shelf and uppermost slope north of the head of De Soto Canyon, NE Gulf of Mexico were mapped with high-resolution multibeam echosounder. Deltas formed not during the last eustatic low stand, but during one or more interstadials when eustatic sea levels were only 60 to 80 m below present sea level. The barrier islands and deltas must have been cemented prior to rapid falls of eustatic sea level that occurred during global glaciations. Cementation is necessary to have preserved the barrier islands from erosion and subsequent destruction by the rapid sea-level rise during the last deglaciation. The preservation of the relict bathymetry is so good that features that superficially resemble trough blowouts are found in association with one of the relict barrier islands. Asymmetric bedforms on the midshelf in water depths of 50 to 60 m indicate transport directions to the SW but asymmetric bedforms in water depths of the upper slope between 100 and 120 m on the S and SE flanks of the drowned shelf-edge deltas indicate a different current direction, a separate flow that is a continuation of a SW-flowing current that was previously found on the upper slope off NW Florida.     

Shelf habitat distribution as a legacy of Late Quaternary marine transgressions: A case study from a tropical carbonate province

The legacy of multiple marine transgressions is preserved in a complex morphology of ridges, mounds and reefs on the Carnarvon continental shelf, Western Australia. High-resolution multibeam sonar mapping, underwater photography and sampling across a 280 km² area seaward of the Ningaloo Coast World Heritage Area shows that these raised features provide hardground habitat for modern coral and sponge communities. Prominent among these features is a 20 m high and 15 km long shore-parallel ridge at 60 m water depth. This ridge preserves the largely unaltered form of a fringing reef and is interpreted as the predecessor to modern Ningaloo Reef. Landward of the drowned reef, the inner shelf is covered by hundreds of mounds (bommies) up to 5 m high and linear ridges up to 1.5 km long and 16 m high. The ridges are uniformly oriented to the north-northeast and several converge at their landward limit. On the basis of their shape and alignment, these ridges are interpreted as relict long-walled parabolic dunes. Their preservation is attributed to cementation of calcareous sands to form aeolianite, prior to the post-glacial marine transgression. Some dune ridges abut areas of reef that rise to sea level and are highly irregular in outline but maintain a broad shore-parallel trend. These are tentatively interpreted as Last Interglacial in age. The mid-shelf and outer shelf are mostly sediment covered with relatively low densities of epibenthic biota and have patches of low-profile ridges that may also be relict reef shorelines. An evolutionary model for the Carnarvon shelf is proposed that relates the formation of drowned fringing reefs and aeolian dunes to Late Quaternary eustatic sea level.     

多波束关键技术——波束形成原理

换能器阵元的不同排列组合决定其指向性，波束形成是多波束测量的关键技术。文中通过数学计算总结了不同换能器阵进行波束形成的工作原理，并介绍了利用二维DFT进行频域波束形成的一般方法。最后结合现役多波束测深系统，简单解释说明不同系统所采用的波束形成技术。     

Halokinetics and other features of GLORIA long-range sidescan sonar data from the Red Sea

The Red Sea is an unusual example of a rift basin that transitioned from its evaporitic stage to fully open-ocean conditions at the end of the Miocene (∼5.3 Ma), much more recently than older Mesozoic margins around the Atlantic and Gulf of Mexico. The patterns of halokinetic deformation occurring in the Red Sea are potentially of interest for understanding more generally how evaporite deposits deform during this early stage. Relevant to this issue, a line of reconnaissance sidescan sonar data (GLORIA) collected along the Red Sea in 1979 is re-evaluated here. We first interpret the data with the aid of newly compiled bathymetry from multibeam sonars in the central and southern Red Sea. Features in the acoustic backscatter data are associated with ridges, valleys and rounded flow fronts produced by halokinetic deformation. Some areas of higher acoustic backscattering from the evaporites are suggested to relate to roughness produced by deformation of the evaporite surface. Within the volcanic (oceanic) axial valleys, areas of differing high and low backscattering suggest varied sediment cover and/or carbonate encrustations. With the benefit of the above experience, we then interpreted data from the northern Red Sea, where there are fewer multibeam data available. Rounded fronts of halokinetic deformation are present in the Zabargad Fracture Zone, a broad, shallow valley crossing the Red Sea obliquely. The presence of halokinetic deformation here is evidence that subsidence has occurred along the fracture zone. Elsewhere in the northern Red Sea, the GLORIA data reveal folds in the evaporite surface, suggesting local areas of convergence, like those implied by multibeam data from inter-trough zones further south. Some linear features are observed, many of which are likely to be ridges overlying salt walls. Interestingly, several such features are oriented along an accommodation zone that is oriented parallel to the plate spreading direction. Several rounded, corrugated features are interpreted as possible evaporite flow fronts. Overall, the impression from the data is of a strongly mobile seabed in the Red Sea because of halokinetic deformation, involving both vertical and horizontal movements. However, salt walls appear more common than in the central and southern axial Red Sea, where horizontal movements instead tend to dominate.     

Morphology of pockmarks along the western continental margin of India: Employing multibeam bathymetry and backscatter data

This study addresses the morphology of pockmarks along the western continental margin of India using multibeam bathymetry and backscatter data. Here, for the first time we have utilized the application of ArcGIS (Geographical Information System) for understanding the morphology of pockmarks from the western continental margin of India. The pockmarks observed in water depths of 145–330 m are circular, elliptical or elongated in plan-view, with an average length and width of 157 (±72) m and 83 (±19) m respectively. The average pockmark relief and perimeter are 1.9 (±0.9) m and 412 (±181) m, respectively. The pockmarks have average areas and volumes of 10 759 m² and 15 315 m³ respectively. Spatial separation that coincides with 210 m isobath divides the pockmarks into two groups with differing distributions and morphologies. These pockmarks originated from seepages of biogenic or thermogenic gas or from pore fluids from deeper sources, migrated vertically along the faults. Besides a possible structural control, the pockmark morphologies are also affected by bottom currents and/or by submarine slumping. The average acoustic backscatter strength from pockmark centre is higher (−35 dB) than the average backscatter of the total area (−40 dB), which suggests their possible linkage to the precipitation of diagenitic minerals from biodegradation of seepage material.     

Development in Precision Seafloor Survey and Mapping in China

This article presents a general introduction to the development in China since 1980s in precision seafloor survey and mapping. Emphasis is given to the processing and integration of data from the acquisition system centered on the multibeam bathymetric survey equipment, and to the interactive map generation systems, MBChart, SeaMap, and SeaGIIS. Application of these systems will also be described.