地铁施工对济南白泉泉群流量的影响

为研究地铁建设对济南白泉泉群的影响，在综合分析白泉泉域地质、水文地质条件的基础上，假定研究区岩溶强径流带位置及水力性质，利用FEFLOW软件建立地下水流数值模型。以规划地铁M1号线为研究对象，分析了济南东站、梁王站、梁王东站分别施工及3个站同时施工4种情景下，采用施工降水或施工降水+人工回灌两种施工方式对白泉泉群流量的影响。结果表明：单独采用施工降水的施工方式使得白泉泉群流量衰减，其中3个站同时施工对泉流量的影响最大，泉流量最大衰减达5.48%；各站分别施工时，济南东站对泉流量影响最大，泉流量较未施工时减少了0.043×10⁴ m³/d。采用施工降水+人工回灌的施工方式，能够有效缓解泉流量的衰减，各车站施工时的泉流量衰减由仅施工降水时的2.26%~5.48%降低至0.08%~1.21%。岩溶强径流带有利于地下水形成优势径流，促进白泉泉群补给，一定程度上缓解因地铁施工引起的泉流量衰减。     

A Step Towards Evaluation of the Seismic Response Reduction Factor in Multistorey Reinforced Concrete Frames

A seismic nonlinear time-history analysis was made for four-, six-, and eight-storey reinforced concrete buildings. These buildings were made as three-dimensional space frame structures with shear walls in both orthogonal directions. They have five bays with 4.8 m spacing each in the horizontal direction, and three bays with 4.2 m spacing each in the transversal direction. The frames were designed according to the Jordanian Seismic Code of practice for Seismic Zones 4, 3, 2, and 1 as proposed for Jordan by several authors. Time-history analysis was made using the El Centro (N-S) earthquake record of May 1940 as an actual earthquake excitation. The response reduction factor (R) that primarily consists of two factors that are the ductility reduction (Rµ) and the overstrength (), is obtained. It has been seen that the seismic zoning has a slight effect on the ductility reduction factor for different buildings, since it ranges from Zone 4 to Zone 1 as 2.37 to 2.52, 1.72 to 1.78, and 1.14 to 1.18 for four-, six-, and eight-storey buildings, respectively. Moreover, it is observed that, for different buildings and different seismic zones, the ductility reduction factor (Rµ) is slightly different from the system ductility factor (µ) especially for higher values of µ (i.e., Rµ µ). The response reduction factor, called overstrength (), was evaluated. The overstrength factor was found to vary with seismic zones (Z) , number of stories, and design gravity loads. However, the dependency on seismic zones was the strongest. The average overstrength of these buildings in Zones 4 and 1 was 2.61 and 6.94, respectively. The overstrength increased as the number of storeys decreased: overstrength of a four-storey building was higher than an eight-storey building by 36% in Zone 4, and 39% in Zone 1. Furthermore, buildings of the three heights had an average overstrength 165.9% higher in Zone 1 than in Zone 4. These observations have a significant implications for the seismic design codes which currently do not take into account the variation of the response reduction factor, R (i.e., ductility reduction factor times overstrength).     

Research on temporal and spatial distribution, evolutionary character and mechanism of crustal deformation field before and after the Tangshan earthquake

Ｒｅｓｅａｒｃｈｏｎｔｅｍｐｏｒａｌａｎｄｓｐａｔｉａｌｄｉｓｔｒｉｂｕ┐ｔｉｏｎ,ｅｖｏｌｕｔｉｏｎａｒｙｃｈａｒａｃｔｅｒａｎｄｍｅｃｈａｎｉｓｍｏｆｃｒｕｓｔａｌｄｅｆｏｒｍａｔｉｏｎｆｉｅｌｄｂｅｆｏｒｅａｎｄａｆｔｅｒｔｈｅＴａｎｇｓｈａｎ...     

地震短临综合预报方法的研究

本文在《中国震例》资料基础上,详细分析了华北地区１７次中强以上地震前的短临异常,得到华北地区中强以上地震短临异常的三个综合特征,在归纳出短临异常综合特征的基础上,提出了两个判定孕震过程、前兆异常由中期向短期过渡的定量的综合标志。据中期异常的追踪分析和短临异常综合分析相结合的原则,定义并计算了综合预报指标Ｓ值,以此值作为是否发生中强以上地震的判据。本文的重点是在分析短临异常综合特征的基础上,结合实用     

合肥遥测台网地震速报系统

论述了适用于遥测地震台网大震速报的一套计算机处理系统,系统设计以《全国遥测台网观测技术规范》和《近震分析》理论为依据,实现了数据输入,震相选择,数据处理,地震定位,震级计算,结果输出及贮存等多项功能,达到了快速确定地震三要素,提高速报速度和精度之目的,是一个较完善的,实用的速报系统。     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

A combined study of macroseismic data and focal mechanisms applied to the West-Bohemian earthquake,Czechoslovakia

The main shock of the West-Bohemian earthquake swarm, Czechoslovakia, (magnitudem=4.5, depthh=10 km) exhibits an irregular areal distribution of macroseismic intensities 6° to 7° MSK-64. Four lobes of the 6° isoseismal are found and the maximum observed intensity is located at a distance of 8 km from the instrumentally determined epicentre. This distribution can be explained by the energy flux of the directS wave generated by a circular source, the hypocentral location and focal mechanism of which are taken from independent instrumental studies. The theoretical intensity, which is assumed to be logarithmically proportional to the integrated squared ground-motion velocity (i.e.,I=const+log v ² (t)dt), fits the observed intensity with an overall root-mean-square error less than 0.5°. It is important that the present intensity data can also be equally well explained by the isotropic source. The fit was attained by means of a horizontally layered model though large fault zones and an extended sedimentary basin suggest a significant lateral heterogeneity of the epicentral region. The results encourage a broader application of the simple modelling technique used.     

突发性地面增温与临震前兆——以1988年澜沧、耿马7.6,7.2级地震为例

本文通过较多的地面温度资料分析,认为1988年11月6日澜沧、耿马地震前几天,震区及其周围大范围的突发性地面增温异常是一种临震前兆,总结了增温异常的时空演变规律与地震活动的关系,并对其形成机制提出初步想法     

Variability in Early Amazonian Tharsis stress state based on wrinkle ridges and strike-slip faulting

We present evidence for a decrease in the magnitude of Tharsis-circumferential compressive stress during the Late Hesperian to the Middle Amazonian based on chronologic changes in the predominant style of faulting in southern Amazonis Planitia. Using high-resolution MOLA topography, we identify a population of strike-slip faults that exhibit Middle Amazonian-aged displacements of regional chrono-stratigraphic units. These strike-slip faults are adjacent to an older population of previously documented Late Hesperian-aged thrust faults (wrinkle ridges). Along-strike orientations of these thrust and strike-slip faults reveal the Tharsis-radial stress to be the area's most compressive remote principal stress and that this stress orientation and magnitude persisted throughout the Late Hesperian to the Middle Amazonian. We show that the change in the predominant style of faulting from thrust faulting to strike-slip faulting during this time requires a decrease of the Tharsis-circumferential compressive stress to a magnitude less than lithostatic load, with negligible change in stress orientation.     

Effects of dynamic shear strength and time-histories stress analysis on newmark sliding block analyses

A simplified procedure for evaluating aseismic stability of slope subjected to earthquake shaking, in which the effect of dynamic shear strength and time-history stress on the yielding angular acceleration of sliding block is taken into account, is presented. The fundamental feature of this procedure is the dynamic shear strength. The numerical computations are performed by using the proposed method. It is shown that the computed sliding displacement for a given core dam, with either method of dynamic shear strength properly considered, is more rational compared with the conventional computational results based on static shear strength.