Laboratory and case studies of thermal cycling and stored strain on the stability of selected marbles

Studies of marble panels from the exterior of two buildings document the processes leading to bowing of the material. Bowing of panels is most extensive in those areas that are exposed to direct or reflected thermal energy. The thermal anisotropic behavior of calcite results in grain-boundary separation, grain sliding and microfracturing. The resulting loss of strength is one factor leading to bowing. The development of bows further reduces the panel strength as the outer portions elongate by inelastic deformation mechanisms. Laboratory experiments cycling marble samples for over 200 cycles at three temperatures up to 107°C above room conditions show similar strength losses as the natural situation. The second factor contributing to the bowing process is the release of residual elastic strain. The strain is in part stored in the marble from its geologic history, but may also be accumulated during thermal cycling due to the properties of calcite. Marble panels have been found to bow when stored outside, but not attached to any framework, indicating that the release of residual strain is a critical factor in producing the bows.     

Splash-saltation trajectories of soil particles under wind-driven rain

It is usually recognized that relatively large amounts of soil particles cannot be transported by raindrop splashes under windless rain. However, the splash-saltation process can cause net transportation in the prevailing wind direction since variations in splash-saltation trajectory due to the wind are expected in wind-driven rain. Therefore, determining the combined effect of rain and wind on the process should enable improvement of the estimation of erosion for any given prediction technique. This paper presents experimental data on the effects of slope aspect, slope gradient, and horizontal wind velocity on the splash-saltation trajectories of soil particles under wind-driven rain. In a wind tunnel facility equipped with a rainfall simulator, the rains driven by horizontal wind velocities of 6, 10, and 14 m s⁻¹ were allowed to impact three agricultural soils packed into 20×55 cm soil pans placed at both windward and leeward slopes of 7%, 15%, and 20%. Splash-saltation trajectories were measured by trapping the splashed particles at distances downwind on a 7-m uniform slope segment in the upslope and downslope directions, respectively, for windward and leeward slopes. Exponential decay curves were fitted for the mass distribution of splash-saltation sediment as a function of travel distance, and the average splash-saltation trajectory was derived from the average value of the fitted functions. The results demonstrated that the average trajectory of a raindrop-induced and wind-driven soil particle was substantially affected by the wind shear velocity, and it had the greatest correlation (r=0.96 for all data) with the shear velocity; however, neither slope aspect nor slope gradient significantly predicted the splash-saltation trajectory. More significantly, a statistical analysis conducted with nonlinear regression model of C₁(u_*²/g) showed that average trajectory of splash saltation was approximately three times greater than that of typical saltating sand grain.     

Origin of layering in cumulate gabbros in the Oman ophiolite: Insights from magnetic susceptibility measurements in the Wadi Sadm area

Abstract   Magnetic susceptibility and the anisotropy of magnetic susceptibility were measured on an 800-cm-thick succession of cumulate gabbro in the Sadm area of the Oman ophiolite. The section contained three distinct cumulate units. The susceptibility tends to decrease upward in each from a melanocratic layer (several tens of centimeters thick) to a leucocratic layer (a few meters thick). The susceptibility decreases in accordance with the decreasing number of magnetite grains, which are the alteration product mainly of olivine minerals. This suggests the cyclic downward accumulation of olivine in the cumulate gabbro. The apparent strain deduced from the patterns of magnetic and grain fabrics was the result mostly of simple shear, so that the layering of gabbro is understood to be formed primarily by a crystal cumulus process followed by simple shear deformation.     

Slow mass movement in the Kangchenjunga area, eastern Nepal Himalaya

Abstract   The rates of the accumulated and continuous displacement of solifluction lobes in the Kangchenjunga area, eastern Nepal Himalaya, were determined using glass fiber tubes and a strain probe. Ground temperature, precipitation and soil moisture were monitored at two sites, whose altitude differed by approximately 100 m, to understand the solifluction process. The average movement rate of the glass fiber tubes on a 31° slope at altitudes of 5412–5414 m a.s.l. was approximately 11 mm/year, being almost threefold greater than that observed on a 22° slope at 5322–5325 ma.s.l. There was no significant difference in the depth of displacement at these sites. The continuous displacement measurement near the ground surface at 5414 m showed permanent downslope movement from early July. Such movement may be attributed to additional moisture supply during the monsoon season. The amplitude of the displacement cycle was highest at the ground surface, and decreased to virtually zero at and below 20 cm in depth. Probable factors leading to the relatively slow rates of downslope displacement at the surface and depth at the studied altitudes are the lack of concurrence of the freeze–thaw cycles and the high moisture condition in the soil, and the low moisture retention capacity of the soil because of steep slopes and superficial desiccation. The rate of displacement may be more pronounced at altitudes above 5600 m because of the freeze–thaw cycles during the summer season.     

锦州地震台体积式钻孔应变仪的映震情况

论述了张北MS6.2、沈阳ML4.1、内蒙古ML5.9、日本北海道MS8.0、俄蒙中交界MS7.9、青海昆仑山MS8.1地震前后,锦州地震台体积式钻孔应变仪观测震前异常的变化规律。通过计算潮汐因子、振幅因子、3点线性平滑滤波残差值等方法,识别异常。结果表明,体应变异常资料与地震有一定的相关性。     

The dependence of response spectrum on the tectonic ambient shear stress field

Introduction The acceleration response spectrum and peak ground acceleration are the necessary and im-portant parameters in earthquake-resistant design at present. They are still active research field. With the increase of digital high accurate strong motion observation data, especially the earth-quakes of Loma Prieta (M=7.0) in 1989; Landers (M=7.3) in 1992; Big Bear (M=6.4) in 1994 and Northridge (M=6.7) in 1994 in USA; Kozani (M=6.6) earthquake and afteshocks in 1995 in Greece; Dinar…     

Cause of winter gravity wave spectrum saturation

Gravity waves play a significant role in establishing the large-scale circulation and structure of the middle atmosphere. Through gravity wave saturation proc-esses, such motions are believed to cause turbulence, resulting in divergence of momentum flux and the diffusion of heat and constituents in the meso-sphere[1,2]. The mechanisms that contribute signifi-cantly to the gravity wave saturation are thought to be the dynamical and convective instabilities[3]. However, it is difficult to distin…     

Strain accumulation in sand due to cyclic loading: drained triaxial tests

Our aim is the prediction of the accumulation of strain and/or stress under cyclic loading with many (thousands to millions) cycles and relatively small amplitudes. A high-cycle constitutive model is used for this purpose. Its formulas are based on numerous cyclic tests. This paper describes drained tests with triaxial compression and uniaxial stress cycles. The influence of the strain amplitude, the average stress, the density, the cyclic preloading history and the grain size distribution on the direction and the intensity of strain accumulation is discussed.     

Tidal Stress/Strain and the b-values of Acoustic Emissions at the Underground Research Laboratory, Canada

The correlation between the b-values of acoustic emissions (AEs) and the phase of the moon was investigated at the Underground Research Laboratory (URL) in Canada. The same data as those used in Iwata (2002) were examined, which showed that the occurrence of AEs is correlated with the phase of the moon. It was expected, therefore, that the b-value of the AEs would also be sensitive to tidal stress/strain fluctuations. We investigated the variation of the b-values as a function of the phase of the moon. Results show that b-values immediately following the times of full/new moon are higher than those at other times. Using AIC (Akaike Information Criterion) and random (Monte Carlo) simulations, it was confirmed that this feature is statistically significant. We also investigated whether or not there was a change in the b-values immediately before the times of full/new moon, but no statistically significant change was observed. The results suggest that the effect of stress/strain fluctuations on AE occurrences at the URL is asymmetric to the times of full/new moon.All authors are members of the Academic Robotics Group. In listing The Academic Robotics Group, the authors are endeavoring to place each of the participant institutions on an equal footing in terms of effort and authorship. M. A. Talamini is serving as presenter.