The morphodynamic modelling of tidal sand waves on the shoreface

An artificial sand wave on the Dutch shoreface of the North Sea has been studied in conditions with relatively strong tidal currents in the range of 0.5 to 1 m/s and sediments in the medium sand size range of 0.2 to 0.5 mm. The sand wave is perpendicular to the tidal current and has a maximum height and length of the order of 5 m and 1 km, respectively. The sand wave is dynamically active and shows migration rates of the order of a few metres per year. A numerical morphodynamic model (DELFT3D model) has been used to simulate the morphological behaviour of the sand wave in the North Sea. This model approach is based on the numerical solution of the three-dimensional shallow water equations in combination with a surface wave propagation model (wind waves) and the advection–diffusion equation for the sediment particles with online bed updating after each time step. The model results show that the sand wave grows in the case of dominant bed-load transport (weak tidal currents; relatively coarse sediment; small roughness height; low waves) and that the sand wave decays in the case of dominant suspended transport (strong currents, relatively fine sediment, large roughness height; storm waves).     

Thorium isotopes as tracers of particles dynamics and deep water circulation in the Indian sector of the Southern Ocean (ANTARES IV)

Dissolved and particulate samples were collected to study the distribution of thorium isotopes (²³⁴Th, ²³²Th and ²³⁰Th) in the water column of the Indian sector of the Southern Ocean (from 42°S to 47°S and from 60°E to 66°E, north of the Polar Front) during Austral summer 1999. Vertical profiles of excess ²³⁰Th (²³⁰Th_xs) increases linearly with depth in surface water (0–100 m) and a model was applied to estimate a residence time relative to the thorium scavenging (τ_scav). Low τ_scav in the Polar Front Zone (PFZ) are found, compared to those estimated in the Subtropical Front Zone (STZ). Changes in particle composition between the PFZ and STZ could influence the ²³⁰Th_xs scavenging efficiency and explain this difference. An innovative coupling between ²³⁴Th and ²³⁰Th_xs was then used to simultaneously constrain the settling velocities of small (0.6–60 μm) and large (above 60 μm) particles. Although the different hydrological and biogeochemical regimes visited during the ANTARES IV cruise did not explain the spatial variation of sinking velocity estimates, our results indicate that less particles may reach the seafloor north (60 ± 2 m d^− 1, station 8) than south of the Agulhas Return Current (119 ± 23 and 130 ± 5 m d^− 1 at stations 3 and 7, respectively). This information is essential for understanding particle transport and by extension, carbon export. In the deep water column, the ²³⁰Th_xs concentrations did not increase linearly with depth, probably due to lateral transport of North Atlantic Deep Water (NADW) from the Atlantic to the Indian sector, which renews the deep waters and decreases the ²³⁰Th_xs concentrations. A specific ²³⁰Th_xs transport model is applied in the deep water column and allows us to assess a “travel time” of NADW ranging from 2 to 15 years.     

A social scientist's perspective on the Census of Marine Life

Over 300 natural scientists in 53 nations are taking part in the Census of Marine Life (CoML) to investigate what lived, what lives, and what will live in the oceans. The CoML is a scientific experiment that is exploring the limits of ocean science. The paper discusses the potential applications of CoML research and the mechanisms by which the potential benefits can be measured and preserved. I recommend developing and integrating policy advisory committees with the natural science activities to both maximize the benefits of the research and to avoid unintended consequences.     

Monitoring the Kuroshio Extension with Dynamically Constrained Synthesis of the Acoustic Tomography, Satellite Altimeter and in situ Data

A finite-difference quasigeostrophic (QG) model of an open ocean region has been employed to produce a dynamically constrained synthesis of acoustic tomography and satellite altimetry data with in situ observations. The assimilation algorithm is based upon the 4D variational data interpolation scheme controlled by the model's initial and boundary conditions. The data sets analyzed include direct and differential travel times measured at the array of five acoustic transceivers deployed by JAMSTEC in the region of the Kuroshio Extension in 1997, Topex/Poseidon altimetry, CTD soundings, and ADCP velocity profiles. The region monitored is located within the area 27.5°–36.5°N, 143°–155°. The results of assimilation show that mesoscale variability can be effectively reconstructed by five transceivers measuring direct and reciprocal travel times supported by relatively sparse in situ measurements. The misfits between model and data lie within the observational error bars for all the data types used in assimilation. We have compared the results of assimilation with the statistical inversion of travel time data and analyzed energy balances of the optimized model solution. Energy exchange between the depth-averaged and shear components of the observed currents reveals a weak decay of the barotropic mode at the rate of 0.2 ± 0.7⋅10⁻⁵ cm²/s³ due to topographic interaction. Mean currents in the region are unstable with an estimate of the available potential energy flux from the mean current to the eddies of 4.7 ± 2.3⋅10⁻⁵ cm²/s³. Kinetic energy transition has the same sign and is estimated as 2.8 ± 2.5⋅10⁻⁵ cm²/s³. Potential enstrophy is transferred to the mesoscale at a rate of 5.5 ± 2.7⋅10⁻¹⁸ s⁻³. These figures provide observational evidence of the properties of free geostrophic turbulence which were predicted by theory and observed in numerical experiments. This revised version was published online in July 2006 with corrections to the Cover Date.     

Marine tether dynamics: retrieval and deployment from a heaving platform

A tether management system of a winch module in a marine environment is proposed. For the purpose of this study the subsea body is considered as a mass attached at the free end of a long tether which is wrapped around a circular drum controlled by an external torque. The winch is considered mounted on a heaving platform. The effect of the heaving platform on the motions of the drum, tether and attached mass are studied with respect to the longitudinal vibrations of the tether in one dimension. The hydrodynamic effects are considered on the deployed portion of the tether and the tethered mass, both of which are assumed submerged in otherwise still water. The resulting nonlinear system of equations of motion is developed and solved numerically for an example of a marine tether system. The effect of the tether extensibility on the operation threshold of the system is identified. Comparison with an inextensible tether case is provided. The numerical results and their analysis for the retrieval/deployment of the system are presented.     

Effect of Pollutants on the Physical and Engineering Behavior of Lime-Treated Marine Clay

Rapid industrial growth and increasing population has resulted in the discharge of wastes into the ocean, wastes which ultimately reach the seabed and contaminate the marine sediments. The soil-contaminants interaction, and their associated physico chemical properties with sediments control the behavior of marine clays. Marine clay deposits of low strength and high compressibility are located in many coastal and offshore areas. There are several foundation problems encountered in these weak marine clays. In this study, experimental work was carried out in the laboratory to stabilize soft marine clays using the lime column technique. Also the lime-induced effects on the physical and engineering behavior of marine clays in sulfate-contaminated marine environment was investigated. Consolidation tests indicate that compressibility of the lime-treated samples was reduced to 1/2-1/3 of the virgin soil after 45 days treatment. The test results also suggest that the lime column technique can be conveniently used to improve the behavior of contaminated marine clay deposits.     

Application of Microbial BOD Sensors in Marine Monitoring

A strain of yeast, which can endure high osmotic pressure, is employed for the sensitive material of the microbial BOD sensor. Two immobilization methods are used, I.e. Calcium alginate gel be ads and PV A gel beads. The results show that the PVA gel beads is better. The influences of osmosis and heavy metal ions on the yeast entrapped in the PVA gel beads are also studied in the experiment.     

Evaluation of mine tailings effects on a benthic marine infaunal community over 29 years

Benthic infaunal and sediment data collected over 29 years were used to examine the extent and geographic range of effects and recovery from submarine tailings deposition. Empirical data were used to determine extreme and moderate effects, and identify near-, mid- and far-field zones. A simple probability test using overlap in frequency distributions was then used to determine less obvious effects, identify "normal" or "reference" conditions, and verify the geographic range of effect zones. Tailings thickness and sediment particulate copper were elevated from the outfall to 16-20 km distant, particularly below discharge depth (50 m). Changes in tailings thickness and copper levels before, during and after mining showed three distinct impact zones below discharge depth: near-field (<5 km from outfall); mid-field (5-16 km); and far-field (20 + km). Consistent faunal declines during mining were noted at sediment particulate copper levels >300 microg g(-1), and sediment tailings thickness > 15-20 cm. Extreme impoverishment at these sediment levels were; < 100 animals/m2, <2.5 g/m2 biomass and <7 taxa per station. No stations with >300 microg g(-1) copper and 20 cm tailings had more than 40 taxa. Amphipods were particularly affected by tailings, with distributions reflecting the instability in sediments from heavy deposition and/or shifting of tailings due to resuspension. The probability testing method assumed that reference conditions existed in far-field stations. There was no difference in abundance distributions between near-, mid- and far-field zones. Total taxa per station during mining was significantly reduced (<45) in both near- and mid-field stations compared with far-field (less than 10% overlap in distributions). One midfield station in Quatsino Sound (23) was in reference condition throughout the study period. Post-closure stations in the near- and mid-field had total taxa numbers approaching far-field conditions (overlap of 62% in distributions). Within 3 years following closure, total taxa values were within the far-field range for all stations sampled. Biomass showed a distinct decline in the near-field during mining, but with more overlap in near-field and far-field distributions (27%) than for total taxa per station, and was returning to far-field conditions in the post-closure years. A multivariate (Bray-Curtis) measure of dissimilarity indicated that the near- and mid-field infaunal compositions were distinct from the far-field during mining (< 10% overlap in distributions). The mid-field composition overlapped more with the far-field in the post-closure years, but the near-field composition did not, suggesting that the mine tailings are still affecting the fauna. The most abundant taxon in each of the reference and near-field station groups both showed significantly distinct relative abundance distributions between near- and far-field stations. In summary, the probability method showed that species richness, biomass, species composition and indicator taxa were useful for differentiating affected and non-affected stations. Polychaetes recolonize stable tailings most quickly, and have dominated the tailings stations in the post-closure years. Amphipods have recolonized sporadically, but seem to be highly sensitive to tailings stability. There was no evidence of recovery in dominant bivalves or echinoderms within three years after mine closure.     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.