库水位变化对库岸边坡稳定性的影响

在假定坡体孔隙水水位为水平线且不考虑渗透作用影响的基础上,基于极限平衡法考察了水位上升及下降的快慢对边坡安全系数的影响。对比计算表明:在水位缓慢变化即坡体内外水位线等高的条件下,边坡的安全系数随着水位坡高比的增大先略减小后急剧增大,且在水位坡高比为0.3处取得最小值,在边坡完全淹没于水中时取得最大值。当边坡完全淹没于水中后,水位高于坡顶的多少对边坡安全系数没有影响;在水位骤降或陡升条件下,相同库水位对应的边坡安全系数基本上均小于水位缓慢变化情况下的安全系数,故工程实际中无论是排水还是蓄水,都应尽量保持水位缓慢变化,这样才能使边坡处于较安全的状态。     

Seismic velocities of granulite-facies xenoliths from Central Ireland: Implications for lower crustal composition and anisotropy

V_p and V_s values have been measured experimentally and calculated for granulite-facies lower crustal xenoliths from central Ireland close to the Caledonian Iapetus suture zone. The xenoliths are predominantly foliated and lineated metapelitic (garnet–sillimanite–K-feldspar) granulites. Their metapelitic composition is unusual compared with the mostly mafic composition of lower crustal xenoliths world-wide. Based on thermobarometry, the metapelitic xenoliths were entrained from depths of c. 20–25 ± 3.5 km and rare mafic granulites from depths of 31–33 ± 3.4 km. The xenoliths were emplaced during Lower Carboniferous volcanism and are considered to represent samples of the present day lower crust.V_p values for the metapelitic granulites range between 6.26 and 7.99 km s^{− 1} with a mean value of 7.09 ± 0.4 km s^{− 1}. Psammite and granitic orthogneiss samples have calculated V_p values of 6.51 and 6.23 km s^{− 1}, respectively. V_s values for the metapelites are between 3.86 and 4.34 km s^{− 1}, with a mean value of 4.1 ± 0.15 km s^{− 1}. The psammite and orthogneiss have calculated V_s values of 3.95 and 3.97 km s^{− 1}, respectively.The measured seismic velocities correlate with density and with modal mineralogy, especially the high content of sillimanite and garnet. V_p anisotropy is between 0.15% and 13.97%, and a clear compositional control is evident, mainly in relation to sillimanite abundance. Overall V_s anisotropy ranges from 1% to 11%. Poisson's ratio (σ) lies between 0.25 and 0.35 for the metapelitic granulites, mainly reflecting a high V_p value due to abundant sillimanite in the sample with the highest σ. Anisotropy is probably a function of deformation associated with the closure of the Iapetus ocean in the Silurian as well as later extension in the Devonian. The orientation of the bulk strain ellipsoid in the lower crust is difficult to constrain, but lineation is likely to be NE–SW, given the strike-slip nature of the late Caledonian and subsequent Acadian deformation.When corrected for present-day lower crustal temperature, the experimentally determined V_p values correspond well with velocities from the ICSSP, COOLE I and VARNET seismic refraction lines. Near the xenolith localities, the COOLE I line displays two lower crustal layers with in situ V_p values of 6.85–6.9 and 6.9–8.0 km s^{− 1}, respectively. The upper (lower velocity) layer corresponds well with the metapelitic granulite xenoliths while the lower (higher velocity) layer matches that of the basic granulite xenoliths, though their metamorphic pressures suggest derivation from depths corresponding to the present-day upper mantle.     

From the geological to the numerical model in the analysis of gravity-induced slope deformations: An example from the Central Apennines (Italy)

This paper presents the findings from a study on gravity-induced slope deformations along the northern slope of Mt. Nuria (Rieti-Italy). The slope extends from the village of Pendenza to the San Vittorino plain and hosts the Peschiera River springs, i.e. the most important springs of the Central Apennines (average discharge: about 18 m³/s).

Detailed geological-geomorphological and geomechanical surveys, supported by a site stress-strain monitoring system and laboratory tests, led us to define the main evolutionary features of the studied phenomena. Based on the collected data, a “geological-evolutionary model” was developed with a view to identifying a spatio-temporal correlation between relief forms, jointing of the rock mass and its stress conditions. The geological-evolutionary model was expected to improve numerical simulations and to test our assumptions.

The numerical model also allowed us to simulate changes in the stress-strain conditions of the rock mass and correlate them with jointing, seepage, as well as with site-detected and site-monitored forms and deformations. In particular, significant relations between seepage, tensile stresses within the rock mass, karst solution and collapse of cavities were identified.     

指数平滑技术在斜坡位移预测中的应用

应用趋势型数据指数平滑模型预测了链子崖危岩体监测点GA的位移量.根据其观测数据呈线性趋势的特点,选取趋势型二次指数平滑的线性预测公式和合适的平滑常数值进行了计算预测.预测结果表明位移预测值与实际观测值之间的误差很小,说明该模型可很好地应用于斜坡变形位移的预测.     

利用地震属性研究准噶尔盆地西北缘拐19井区下侏罗统三工河组沉积环境

在准噶尔盆地西北缘，寻找岩性圈闭油气藏已是至关重要的问题。但人们几乎还是用常规的手段来寻找岩性油气藏，没有实质性进展。本文是以利用宽方位角采集的地震数据为基础，对数据进行高保真资料处理和参考标准层的层拉平解释。利用前人的区域地质研究成果和钻井解释成果对侏罗系的沉积环境进行了精细的描述，确定了拐19井区在下侏罗统三工河组的出油层段附近的沉积环境由湖泊相－三角洲前缘相－河流相－湖泊相的演化过程。利用地震属性解释的结果也能较好地反映目标区的沉积环境变迁，并且与区域地质、测井解释结果相吻合，为寻找油气提供了很好的依据。由此得出利用地震属性可以进行沉积环境变迁分析，为油田寻找岩性圈闭及油气藏做出贡献。     

Elastic models for nonlinear response of rigid passive piles

Recent study indicates that the response of rigid passive piles is dominated by elastic pile–soil interaction and may be estimated using theory for lateral piles. The difference lies in that passive piles normally are associated with a large scatter of the ratio of maximum bending moment over maximum shear force and induce a limiting pressure that is ~1/3 that on laterally loaded piles. This disparity prompts this study. This paper proposes pressure‐based pile–soil models and develops their associated solutions to capture response of rigid piles subjected to soil movement. The impact of soil movement was encapsulated into a power‐law distributed loading over a sliding depth, and load transfer model was adopted to mimic the pile–soil interaction. The solutions are presented in explicit expressions and can be readily obtained. They are capable of capturing responses of model piles in a sliding soil owing to the impact of sliding depth and relative strength between sliding and stable layer on limiting force prior to ultimate state. In comparison with available solutions for ultimate state, this study reveals the 1/3 limiting pressure (of the active piles) on passive piles was induced by elastic interaction. The current models employing distributed pressure for moving soil are more pertinent to passive piles (rather than plastic soil flow). An example calculation against instrumented model piles is provided, which demonstrates the accuracy of the current solutions for design slope stabilising piles. Copyright © 2014 John Wiley & Sons, Ltd.     

Exploring the interaction of surface roughness and slope gradient in controlling rates of soil loss from sloping farmland on the Loess Plateau of China

Surface roughness and slope gradient are two important factors influencing soil erosion. The objective of this study was to investigate the interaction of surface roughness and slope gradient in controlling soil loss from sloping farmland due to water erosion on the Loess Plateau, China. Following the surface features of sloping farmland in the plateau region, we manually prepared rough surfaces using four tillage practices (contour drilling, artificial digging, manual hoeing, and contour plowing), with a smooth surface as the control measure. Five slope gradients (3°, 5°, 10°, 15°, and 20°) and two rainfall intensities (60 and 90 mm/hr) were considered in the artificial rainfall simulation experiment. The results showed that the runoff volume and sediment yield increased with increasing slope gradient under the same tillage treatment. At gentle slope gradients (e.g., 3° and 5°), the increase in surface roughness prevented the runoff and sediment production, that is, the surface roughness reduced the positive effect of slope gradient on the runoff volume and sediment yield to a certain extent. At steep slope gradients, however, the enhancing effect of slope gradient on soil erosion gradually increased and surpassed the reduction effect of surface roughness. This study reveals the existence of a critical slope gradient that influences the interaction of surface roughness and slope gradient in controlling soil erosion on sloping farmland. If the slope gradient is equal to or less than the critical value, an increase in surface roughness would decrease soil erosion. Otherwise, the increase in surface roughness would be ineffective for preventing soil erosion. The critical slope gradient would be smaller under higher rainfall intensity. These findings are helpful for us to understand the process of soil erosion and relevant for supporting soil and water conservation in the Loess Plateau region of China.     

Displacement analytical prediction of shallow tunnel based on unified displacement function under slope boundary

For slope condition of ground surface, the asymmetrical deformation about the vertical center line and the horizontal center line of the tunnel cross section can be formed. A unified displacement function expressed by the Fourier series is presented to express the asymmetrical deformation of the tunnel cross section. Five basic deformation modes corresponding to the expansion order 2 are a complete deformation mode to reflect deformation behaviors of the tunnel cross section under slope boundary. Such this complete displacement mode is implemented into the complex variable solution for analytically predicting tunneling-induced ground deformation under slope boundary. All of these analytical solutions are verified by good agreements of the comparison between the analytical solutions and finite element method results. A parameter study is carried out to investigate the influence of deformation modes of the tunnel cross section, geometrical conditions of the tunnel and the slope angle, and “Buoyancy effect” on the displacement field. Finally, the proposed method is consistent with measured data of the Hejie tunnel in China qualitatively. The presented solution can provide a simplified indication for evaluating the ground deformation under slope condition of ground surface.     

Numerical and analytical observations on long and infinite slopes

Interest in the mechanics of landslides has led to renewed evaluation of the infinite slope equations, and the need for a more general framework for estimating the factor of safety of long and infinite slopes involving non‐homogeneous soil profiles. The paper describes finite element methods that demonstrate the potential for predicting failure in long slope profiles where the critical mechanism is not necessarily at the base of the soil layer. The influence of slope angle is also examined in long slopes, leading to some counter‐intuitive conclusions about the impact of slope steepness on the factor of safety. Copyright © 2010 John Wiley & Sons, Ltd.