Noise reduction and detection of weak, coherent signals through phase-weighted stacks

We present a new tool for efficient incoherent noise reduction for array data employing complex trace analysis. An amplitude-unbiased coherency measure is designed based on the instantaneous phase, which is used to weight the samples of an ordinary, linear stack. The result is called the phase-weighted stack (PWS) and is cleaned from incoherent noise. PWS thus permits detection of weak but coherent arrivals. The method presented can easily be extended to phase-weighted cross-correlations or be applied in the τ p domain. We illustrate and discuss the advantages and disadvantages of PWS in comparison with other coherency measures and present examples. We further show that our non-linear stacking technique enables us to detect a weak lower-mantle P -to- S conversion from a depth of approximately 840 km on array data. Hints of an 840 km discontinuity have been reported; however, such a discontinuity is not yet established due to the lack of further evidence.     

Seismic anisotropy within the uppermost mantle of southern Germany

This paper presents an updated interpretation of seismic anisotropy within the uppermost mantle of southern Germany. The dense network of reversed and crossing refraction profiles in this area made it possible to observe almost 900 traveltimes of the P_n phase that could be effectively used in a time-term analysis to determine horizontal velocity distribution immediately below the Moho. For 12 crossing profiles, amplitude ratios of the P_n phase compared to the dominant crustal phase were utilized to resolve azimuthally dependent velocity gradients with depth. A P -wave anisotropy of 3–4 per cent in a horizontal plane immediately below the Moho at a depth of 30 km, increasing to 11 per cent at a depth of 40 km, was determined. For the axis of the highest velocity of about 8.03 km s⁻¹ at a depth of 30 km a direction of N31°F was obtained. The azimuthal dependence of the observed P_n amplitude is explained by an azimuth-dependent sub-Moho velocity gradient decreasing from 0.06 s⁻¹ in the fast direction to 0 s⁻¹ in the slow direction of horizontal P -wave velocity. From the seismic results in this study a petrological model suggesting a change of modal composition and percentage of oriented olivine with depth was derived.     

随机地震荷载作用下饱和粉土的液化特性

为了考虑随机地震荷载作用下饱和粉土的液化特性，研究了如何通过合理的地震响应分析确定饱和粉土层受到的随机地震荷载，进一步探讨了随机地震荷载作用下的动三轴试验技术，以及利用此种试验分析饱和粉土液化特性的方法。研究结果为形成判别饱和粉土层地震液化可能性的新方法提供了依据。     

Seismic Ground Motion Expected for the Eastern District of Naples

The seismic ground motion of a test area in the eastern district of Naples is computed with a hybrid technique based on the mode summation and the finite difference methods. This technique allows us the realistic modelling of source and propagation effects, including local soil conditions. In the modelling, we consider the 1980 Irpinia earthquake, a good example of strong shaking for the area of Naples, which is located about 90 km from the epicenter.The detailed geological setting is reconstructed from a large number of drillings. The sub-soil is mainly formed by alluvial (ash, stratified sand and peat) and pyroclastic materials overlying a pyroclastic rock (yellow neapolitan tuff), representing the neapolitan bedrock. The detailed information available on mechanical properties of the sub-soil and its geometry warrants the application of the sophisticated hybrid technique.As expected, the sedimentary cover causes an increase of the signal's amplitudes and duration. If thin peat layers are present, the amplification effects are reduced, and the peak ground accelerations are similar to those observed for the bedrock model. This can be explained by the backscattering of wave energy at such layers, that tend to seismically decouple the upper from the lower part of the structure.For SH-waves, the influence of the variations of the S-wave velocities on the spectral amplification is studied, by considering locally measured velocities and values determined from near-by down-hole measurements. The comparison between the computed spectral amplifications confirms the key role of an accurate determination of the seismic velocities of the different layers.The comparison performed between a realistic 2-D seismic response and a standard 1-D response, based on the vertical propagation of waves in a plane layered structure, shows considerable difference, from which it is evident that serious caution must be taken in the modelling of expected ground motion at a specific site.     

Attenuation differences in layer 2A in intermediate- and slow-spreading oceanic crust

In situ seismic attenuationQ⁻¹logs are derived from borehole velocity profiles and reveal sharp boundaries between morphologies of the extrusive volcanic layers in intermediate- and slow-spreading oceanic crust.Q⁻¹logs are calculated from the scattering attenuation associated with vertical velocity heterogeneity in Ocean Drilling Program Holes 504B and 896A and in Hole 395A, located in 5.9–7.3 Ma crust on the Pacific and Atlantic plates, respectively. Our results strongly tie crustal properties to seismic measurables and observed geological structures: we find that the scattering attenuation can be used to identify the extrusive volcanic sequence because it is closely related to changes in the degree of vertical heterogeneity. We interpret a distinct decrease in the Q⁻¹log at the transition below the extrusive volcanic layer to correspond with the seismic layer 2A/2B boundary. The boundary is located at 465 m depth below the sea floor in both Hole 395A and 504B, although this is likely to be a coincidence of the sediment thickness at these sites. Layer 2A is estimated to be approximately 150 m thick in Hole 504B and > 300 m thick in Hole 395A. Cyclic sequences of high-porosity pillows and low-porosity massive units in the uppermost 100 m of volcanics in Hole 395A result in large velocity heterogeneities which cause > 5 times more attenuation in this layer than in Hole 504B. In Hole 896A, by contrast, fewer pillows, more massive flows, and a greater volume of carbonate veins decrease the velocity heterogeneity and attenuation significantly over only 1 km distance from Hole 504B. We conclude that the attenuation in the extrusive volcanics of the ocean crust is largely controlled by variation in local heterogeneity and morphology as well as by subsequent hydrothermal alteration. The observed differences inQ⁻¹profiles and layer 2A thickness at these sites may be attributed to variations in the volume and duration of volcanic activity at mid-ocean spreading centers for these Pacific and Atlantic ridge segments.