Trichodesmium erythraeum (Ehrenberg) bloom along the southwest coast of India (Arabian Sea) and its impact on trace metal concentrations in seawater

The incidence of a large scale Trichodesmium erythraeum bloom along the southwest coast of India (Arabian Sea) observed in May 2005 is reported. Around 4802 filaments of T. erythraeum ml⁻¹ seawater was observed and a colony consisted of 3.6 × 10⁵ cells. The bloom was predominant off Suratkal (12° 59′N and 74° 31′E) with a depth of about 47 m, covering an area of 7 km in length and 2 km width. The concentrations of Zinc, Cadmium, Lead, Copper, Nickel and Cobalt were determined in samples collected from the bloom and non-bloom sites using stripping voltammetry. The observed hydrographical and meteorological parameters were found to be favorable for the bloom. The concentrations of Zinc, Cadmium and Nickel were found to be higher at bloom stations, while the concentrations of Lead, Copper and Cobalt were found to be very low at bloom stations. Elevated concentrations of Cadmium and Cobalt were observed at Valappad mainly due to the decomposition of detrital material produced in the bloom. Statistically significant differences (P > 0.01) in metal concentrations between the bloom and non-bloom stations were not observed except for Copper. Metals such as Lead, Copper and Cobalt were removed from the seawater at all places where bloom was observed. Cadmium was found to be slowly released during the decaying process of the bloom.     

罗氏沼虾育苗用水中Mg2+与Ca2+含量及Mg2+/Ca2+对出苗率的影响

１９９１年３－６月和１９９２年３－６月在南汇县东海水产养殖公司对罗氏沼虾育苗用水调配原则与不同基础水的调配方法进行试验研究。结果表明，育苗用水中Ｍｇ＾２＋与Ｃａ＾２＋含量及Ｍｇ＾２＋／Ｃａ＾２＋必须达到一定的范围，这是调配的基本原则。以鱼塘水作基础水时，需添加６种化学药品，其中Ｍｇ＾２＋与Ｃａ＾２＋含量可适范围分别为３００．０－４４０．０ｍｇ／Ｌ与１７０．０－２４４．０ｍｇ／Ｌ，Ｍｇ＾２＋／Ｃａ＾     

On the recovery of surface wave by pressure transfer function

Except the commonly selected pressure transfer function derived from the linear wave theory, a previous study on the pressure transfer function for recovering surface wave from underwater pressure transducer suggested that the pressure transfer function is a function of frequency parameter only. With careful analysis, this study showed that the pressure transfer function should include a transducer submergence parameter as that given by the linear theory. It was found that the previously suggested empirical formula should be restricted to measurements with the pressure transducer close to the surface; otherwise overestimation of wave height would result. Field measurements were carried out with an acoustic wave gauge and a synchronized pressure transducer located at various depths with submergence parameter close to 1 (near the sea floor). It was shown that the previous one-parameter empirical formula might overestimate the significant wave height by more than 30%. This study found that with deep-water wave bursts excluded, the transfer function based on the linear wave theory provided a fairly good estimation on the significant wave heights, with an average deviation of 3.6%.     

The Nonlinear Wave Force on a Circular Cylinder in Shallow Water

Based on the 1st order cnoidal wave theory, the nonlinear wave diffraction around a circular cylinder in shallow water is studied in this paper. The equation of the wave surface around the cylinder is formulated and by using this formula the wave surface elevation on the cylinder surface can be obtained. In this paper, the formula for calculating the cnoidal wave force on a circular cylinder is also derived. For the wave conditions which are often encountered in practical engineering designs, the ratios of the nonlinear wave forces to the linear wave forces are calculated, and the results are plotted in this paper for design purposes. In order to verify the theoretical results, model tests are conducted. After comparing the test results with the theoretical ones, it is concluded that, in shallow water, for the case of T g / d~(1/2) > 8-10 and H / d > 0.3, the cnoidal wave theory should be used to calculate the wave action on a cylindrical pier.     

Low-frequency damping of a moored semisubmersible obtained from simulated extinction tests and mean wave drift forces

Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective.     

Gravity torques for surface waves

The effects of the gravity torques acting on the angular momentum of surface gravity waves are calculated theoretically. For short crested waves the gravity torque is caused by the force of gravity on the orbiting fluid particles acting down the slopes of the crests and troughs and in the direction parallel to the crests and troughs. The gravity torque tries to rotate the angular momentum vectors, and thus the waves themselves, counterclockwise in the horizontal plane, as viewed from above, in both hemispheres. The amount of rotation per unit time is computed to be significant assuming reasonable values for the along-crest and trough slopes for waves in a storm area. The gravity torque has a frequency which is double the frequency of the waves. For long crested waves the gravity torque acts in the vertical plane of the orbit and tries to decelerate the particles when they rise and accelerate them when they fall. By disrupting the horizontal cyclostrophic balance of forces on the fluid particles (centrifugal force versus pressure force) the gravity torque accounts qualitatively for the three characteristics of breaking waves: that they break at the surface, that they break at the crest, and that the crest breaks in the direction of wave propagation.     

A comparison of several wave spectra for the random wave diffraction by a semi-infinite breakwater

A comparison of the diffraction of multidirectional random waves using several selected wave spectrum models is presented in this paper. Six wave spectrum models, Bretschneider, Pierson–Moskowitz, ISSC, ITTC, Mitsuyasu, and JONSWAP spectrum, are considered. A discrete form for each of the given spectrum models is used to specify the incident wave conditions. Analytical solutions based on both the Fresnel integrals and polynomial approximations of the Fresnel integrals and numerical solutions of a boundary integral approach have been used to obtain the two-dimensional wave diffraction by a semi-infinite breakwater at uniform water depth. The diffraction of random waves is based on the cumulative superposition of linear diffraction solution. The results of predicted random wave diffraction for each of the given spectrum models are compared with those of the published physical model presented by Briggs et al. [1995. Wave diffraction around breakwater. Journal of Waterway, Port, Coastal and Ocean Engineering—ASCE 121(1), 23–35]. Reasonable agreement is obtained in all cases. The effect of the directional spreading function is also examined from the results of the random wave diffraction. Based on these comparisons, the present model for the analysis of various wave spectra is found to be an accurate and efficient tool for predicting the random wave field around a semi-infinite breakwater or inside a harbor of arbitrary geometry in practical applications.     

Acoustic plane-wave scattering from a rough surface over a random fluid medium

Acoustic plane-wave scattering from a rough surface overlying a fluid half-space with a sound-speed distribution subject to a small random variation is considered. Under the assumption that the surface roughness and medium randomness are statistically independent, the scattered field may be derived by first solving for the mean field in the medium, and then incorporating with boundary-perturbation method to obtain the total mean field and the power spectral density of the scattered field. The employed algorithm is compatible to the analysis available in the existing literature so that the formulations are conveniently integrated. The results for the power spectral density have shown that the effects of medium inhomogeneities on the rough surface scattering are limited in a spectral regime where the scattered components have shallow grazing angles. The distribution of the power spectral density over the space is primarily governed by the power spectrum and correlation lengths of the rough surface.     

Preliminary optical classification of lakes and coastal waters in Estonia and south Finland

A preliminary optical classification of lakes in Estonia and south Finland which can also be used for small bays of the Baltic Sea is elaborated. The classification is based on the optical properties of water (diffuse attenuation coefficient, diffuse reflectance) and parameters that are routinely monitored in water bodies (Secchi depth, concentration of chlorophyll-a, total suspended matter and yellow substance). The data complex used for our classification covers different types of water ecosystems (ranging from oligotrophic to hypertrophic) and the variability of water constituent concentrations in the ice-free period in Estonia and south Finland. Using cluster analysis, we found 5 optical classes of waters: clear (C), moderate (M), turbid (T), very turbid (V) and brown (B). There is satisfactory correspondence between class of water, shape of diffuse attenuation coefficient and diffuse reflectance spectra and trophic state of the lakes.     

Fully nonlinear numerical wave tank (NWT) simulations and wave run-up prediction around 3-D structures

A finite-difference scheme and a modified marker-and-cell (MAC) algorithm have been developed to investigate the interactions of fully nonlinear waves with two- or three-dimensional structures of arbitrary shape. The Navier–Stokes (NS) and continuity equations are solved in the computational domain and the boundary values are updated at each time step by the finite-difference time-marching scheme in the framework of a rectangular coordinate system. The fully nonlinear kinematic free-surface condition is implemented by the marker-density function (MDF) technique developed for two fluid layers.To demonstrate the capability and accuracy of the present method, the numerical simulation of backstep flows with free-surface, and the numerical tests of the MDF technique with limit functions are conducted. The 3D program was then applied to nonlinear wave interactions with conical gravity platforms of circular and octagonal cross-sections. The numerical prediction of maximum wave run-up on arctic structures is compared with the prediction of the Shore Protection Manual (SPM) method and those of linear and second-order diffraction analyses based on potential theory and boundary element method (BEM). Through this comparison, the effects of non-linearity and viscosity on wave loading and run-up are discussed.