抛石防波堤人工护面块体强度模拟研究

本文主要研究了混凝土人工护面块体在模型试验中的强度模拟问题，根据不同比尺要求的强度指标，确定新型材料组成成份及其配比，并针对已有防波堤护面块体的破坏情况，进行了水槽模型验证试验。     

脚靴式海上升压站灌浆连接段强度分析研究

与国内已建成的海上升压站相比,脚靴式海上升压站导管架对桩和套筒间的灌浆连接强度要求更高,完全套用单桩风电结构的分析方法会使结构设计不准确。由于桩和套筒之间设置有剪力键,当特殊情况时还需增加灌浆连接增强钢筋,在地震及撞船作用下容易导致灌浆接触界面分离等破坏,当前尚未有针对此类情况系统的灌浆连接强度校核方法。以某脚靴式海上升压站为例,分析其在在位、撞船、地震、疲劳等多个主控工况下灌浆连接、剪力键及增强钢筋的强度及稳定性,结果表明该海上升压站灌浆连接段满足设计要求,并研究了各参数对灌浆连接段强度的敏感程度,为今后脚靴式海上升压站各主控工况下的灌浆连接段强度分析、优化设计提供参考与借鉴。     

深层搅拌法在超软弱港口地基上的工程应用

某港口堆场地基上部5．0m系吹填而成，地表下18m范围均属软土，经真空预压初级加固后地基承载力仅在80—90kPa，局部区域上部淤泥土层土性指标较差，含水量大于50％，地基承载力不足60kPa。为了使地基达到230kPa的承载要求，设计采用深层搅拌法加固超软弱地基。通过现场成桩工艺试验和检测表明，桩身水泥土强度在90d龄期时大于1．80MPa，单桩承载力标准值大于150kN，以φ600桩径、桩长13．5m、置换率为0．308和φ500桩径、桩长13．5m、置换率为0．267两种方案布置的复合地基承载力标准值均超过了230kPa的设计要求。试验结果表明，深层搅拌法在港口超软弱地基土应用只要施工工艺适当，完全可以使地基承载力提高2—3．5倍以土，从而节省大量的工程投资。     

Semi-Probabilistic Evaluation of System Redundancy for Existing Offshore Structures

In this paper, a new definition of structure system redundancy is proposed in view of the various measures for structure redundancy. By introducing the terms of structure system failure at the mechanism level and equivalent reliability index, the safety for existing offshore platforms can be evaluated by the semi-probabilistic method presented in this paper. Some numerical examples are given and satisfactory results have been obtained.     

关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

Effect of nano-MgO on mechanical performance of cement stabilized silty clay

Abstract

A series of direct shear tests were performed on cement-admixed silty clay to investigate the effect of cement content and nano-magnesia (MgO) on its shear strength properties. For each normal stress, shear strength increased with cement content. However, an obvious increment in shear strength was achieved when the cement content was adjusted from 13% to 17%. Both cohesion and friction angle of cemented soil increased with cement content, and exponential function was adopted to correlate both the factors with cement content. For cement content of 10% investigated in this study, the optimum nano-MgO content was 10‰, wherein the cohesion could reach the peak value. The microstructure of the mixture revealed that the structure of the mixture was compacted for the optimum nano-MgO content. However, micro-cracks were formed when the amount of nano-MgO exceeded its optimum content.     

Flexural performances of prestressed high strength concrete piles reinforced with hybrid GFRP and steel bars

Abstract

This study developed prestressed high-strength concrete (PHC) piles reinforced with high-strength materials (glass fiber-reinforced polymer (GFRP) bars) for flexural performance enhancement. Flexural strengths and behaviors of PHC piles reinforced with hybrid GFRP and steel bars were experimentally investigated, respectively. Large-scale specimens with total lengths of 12,000?mm and diameters of 600?mm were constructed and tested under bending, accompanied by evaluation of effects of non-prestressed reinforcement type and longitudinal reinforcement ratio. J-factors were calculated to evaluate deformability of all the specimens. PHC piles reinforced with GFRP bars were demonstrated to have much higher flexural capacity than those reinforced with steel bars. Moreover, strains at the midspans of cross sections of all the specimens basically conformed to the assumption of plane section. Failure of PHC piles reinforced with GFRP bars was attributable to gradual concrete crushing, while that of PHC piles reinforced with steel bars resulted from steel yielding. Results of this study were expected to provide theoretical basis for wide engineering applications of PHC piles reinforced with hybrid GFRP bars and steel bars in marine structures.     

Dynamic characteristics of marine soft clay under variable phase difference and initial static shear stress

Abstract

Under seismic loading, the soil layer is subjected to multidirectional cyclic shear stress with different amplitudes and frequencies because of the coupling of multiple shear waves and the soil element within a slope or behind a retaining wall is subjected to initial static shear stress before subjected to cyclic loading. Due to the complexity of seismic loading propagation, a phase difference exists between the initial static shear stress and cyclic shear stress. To investigate the influence of the phase difference and initial static shear stress on cyclic shear strain, cyclic modulus, and cyclic strength, a series of laboratory tests are performed on Wenzhou marine soft clay by multi-directional simple shear system, which can simulate the actual state better by controlling the horizontal cyclic stress in the x and y directions simultaneously. As the phase difference varies from 0° to 90°, the dynamic shear modulus increases and cyclic strain accumulation decreases with an increasing number of cycles. The shear strain increases with the initial shear stress.     

海冰弯曲强度的研究

简要介绍了国内外海冰弯曲强度研究概况;给出了1990年冬作者在辽东湾西部的实验结果;并且讨论了海冰弯曲强度与应力率的关系。     

复合加载条件下吸力式沉箱基础承载特性数值分析

吸力式沉箱基础的承载特性是海洋工程结构设施建造与设计中的一个关键问题。这种新型的深水海洋基础型式,通常承受竖向上拔荷载与水平荷载的共同作用,其工作性能与设计理论远远不能满足工程实践的需要。本文采用有限元分析方法对吸力式沉箱基础的极限承载特性进行数值计算。以大型通用有限元分析软件ABAQUS为平台,通过二次开发,数值实现了Swipe试验加载方法和固定位移比分析方法,针对不同的沉箱长径比、土的强度折减系数,探讨了沉箱基础在垂直上拔荷载和水平荷载单调联合作用下的极限承载力,通过对不同荷载组合的数值计算构造了复合加载条件下沉箱基础破坏包络面。