Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

Re-Os同位素对峨眉山大火成岩省成因制约的探讨

峨眉山大火成岩省（ELIP）主要由玄武岩、玄武质火山碎屑岩及少量的苦橄岩（包括越南的科马提岩）、长英质岩石以及层状岩体和岩墙组成,其物质来源直接关系到其成因是否与地幔柱活动有关。Re-Os同位素体系是地核、地幔和地壳物质的最佳示踪剂。前人对ELIP内的Re-Os同位素研究表明,低Ti玄武岩的Os含量为0．006×10^-9-0．40010^-9,^187Os／^188Os初始值为0．1371～1．403,并提出其与地幔柱活动有关;而高Ti玄武岩的Os含量为0．00410^-9～0．56010^-9,^187Os／^188Os初始值为0．1271～5．19,认为起源于大陆岩石圈地幔或地幔柱上升过程中受到大量岩石圈地幔“混染”（xu JF et al．,2007）;科马提岩的0s含量为1．2410^-9～7．0010^-9,^187Os／^188Os初始值为0．1251～0．1261,苦橄岩的Os含量为0．3210^-9～2．32910^-9,^187Os／^188Os初始值为0．1233～0．1266,指示苦橄岩和科马提岩均来自亏损地幔源区（Hanski et al．,2004;陈雷等,2007）。本文利用Os含量最低、^187Os／^188Os最高的高Ti玄武岩作为地壳端员,用铁质陨石、原始上地幔（PUM）和亏损地幔（DMM）作为地核和各种地幔端员,分别做二元混合计算,结果显示绝大多数玄武岩和所有苦橄岩及科马提岩均落在地壳和DMM混合曲线附近,并且邻区特提斯洋地幔岩与DMM具有相近的Os含量和^187Os／^188Os组成,据此推测峨眉山火成岩的形成与特提斯洋的活动有关,主要受控于地壳和亏损地幔的相互作用。     

A community-wide intercomparison exercise for the determination of dissolved iron in seawater

The first large-scale international intercomparison of analytical methods for the determination of dissolved iron in seawater was carried out between October 2000 and December 2002. The exercise was conducted as a rigorously “blind” comparison of 7 analytical techniques by 24 international laboratories. The comparison was based on a large volume (700 L), filtered surface seawater sample collected from the South Atlantic Ocean (the “IRONAGES” sample), which was acidified, mixed and bottled at sea. Two 1-L sample bottles were sent to each participant. Integrity and blindness were achieved by having the experiment designed and carried out by a small team, and overseen by an independent data manager. Storage, homogeneity and time-series stability experiments conducted over 2.5 years showed that inter-bottle variability of the IRONAGES sample was good (< 7%), although there was a decrease in iron concentration in the bottles over time (0.8–0.5 nM) before a stable value was observed. This raises questions over the suitability of sample acidification and storage.     

Prolonged Magmatic and Tectonic Development of the Caribbean Igneous Province Revealed by a Diving Submersible Survey

Using the diving submersible survey NAUTICA we investigated the central part of the Caribbean large igneous province (CLIP) to observe and sample internal portions of this proposed oceanic plateau. Most of the samples are gabbroic and doleritic rocks; basalts are scarce. Radiometric dating by ⁴⁰Ar/³⁹Ar incremental heating experiments indicate that the intrusive rocks are Campanian in age (81–75 Ma). In some places these intrusive rocks underlie older Santonian (85–83 Ma) extrusive basaltic rocks, suggesting that the Campanian rocks represent a sill injection and an underplating episode. Results of the diving program supplemented by information from ODP and DSDP drilling sites document a 20 m.y. period (94–75 Ma) of igneous activity in the submerged portion of the Caribbean large igneous province (CLIP). In the northern part of the Beata Ridge late Campanian and/or post Campanian uplift is documented by prominent Maastrichtian (71–65 Ma) erosion and the establishment of a Paleocene-middle Eocene (65–49 Ma) carbonate platform. During and after the uplift an extensional period is indicated by seismic images and the subsidence (3 km depth) of the carbonate platform. Paleocene ages (55–56 Ma) determined on some volcanic samples are attributed to localised decompression mantle melting that accompanied the extension. We document a prolonged period of magmatic and tectonic events that do not fit with the current models of short-lived plateau formation during mantle plume initiation but shares many similarities with the constructional histories of other oceanic large igneous provinces.     

Diagnosis of iridovirus in large yellow croaker by PCR

A rapid and sensitive PCR-based method for the detection of the large yellow croaker iridovirus(LYCIV) is described,which involves the amplification of a 295 bp fragment of the LYCIV ATPase gene from DNA isolated from naturally infected fish spleen.Sequencing of LYCIV ATPase gene fragment showed it shared 100% nucleotide sequence homology with the corresponding region of the ATPase gene of red sea bream iridovirus(RSIV) and sea bass iridovirus(SBIV),suggesting that LYCIV was homologous with RSIV and SBIV at least in part of the gemone.The specificity and sensitivity of the PCR procedure were tested on the iridovirus-infected fishes,the expected fragment was detected from spleen DNA samples of infected fishes,whereas no fragments were amplified from healthy fish spleen DNA,white spot syndrome baculoviruses(WSBV) DNA and pseudorabies virus(PRV) DNA.Detection limit of this method was 10^-7 ng positive plasmid DNA containing target sequence,equal to about 100 virions.In the infected experiment,first positive detection(1/4) appeared at Day 3 post-infection,all fish(4/4) tested positive at Day 7,however obvious symptoms were observed at Day 8,so LYCIV infection could be detected prior to the appearance of obvious symptoms.These results indicate that this PCR method could be used for early,rapid and specific detection of LYCIV infection.     

Characterization of Estuarine Marine Clays for Coastal Reclamation in Pusan, Korea

Large scale reclamation works in coastal areas of the Nakdong River plain are at various stages of progress, since early 1990's on in-situ soft marine clay deposits. These deposits are of the order of 30 to 40 m thick. A realistic rapid characterization of soft ground would ensure success of any reclamation work in this area. In order to cope with the work carried out with different agencies, it is desirable to evolve a systematic methodology. In this study, engineering properties of clays at three coastal areas, Gadukdo, Noksan and Shinho, have been generated. The analysis of data has been done within the framework of classical developments in soil mechanics. Analysis has also been made by making use of the recent developments in dealing with soft clays. The dominant factors, namely, stress, time, and environment influencing the response of clay to loading are identified.     

A study of Coriolis effects on long waves propagating in an unbounded ocean, channel and basin

The effects of Coriolis force on long waves have been discussed based on gravity waves propagating in an unbounded ocean, channel and basin. In case of ocean, results show that the Coriolis effect will be significant and negligible, when the wave period is comparable to 2π/f and much shorter, respectively. Results also show in a channel, the wave amplitude and water particle velocity decrease exponentially in the positive y direction in the northern hemisphere (where f is positive). Moreover, in a basin, the Cotidal lines have been found as curves and rotate counterclockwise around the origin.     

Integration of local–global upscaling and grid adaptivity for simulation of subsurface flow in heterogeneous formations

We propose a methodology, called multilevel local–global (MLLG) upscaling, for generating accurate upscaled models of permeabilities or transmissibilities for flow simulation on adapted grids in heterogeneous subsurface formations. The method generates an initial adapted grid based on the given fine-scale reservoir heterogeneity and potential flow paths. It then applies local–global (LG) upscaling for permeability or transmissibility [7], along with adaptivity, in an iterative manner. In each iteration of MLLG, the grid can be adapted where needed to reduce flow solver and upscaling errors. The adaptivity is controlled with a flow-based indicator. The iterative process is continued until consistency between the global solve on the adapted grid and the local solves is obtained. While each application of LG upscaling is also an iterative process, this inner iteration generally takes only one or two iterations to converge. Furthermore, the number of outer iterations is bounded above, and hence, the computational costs of this approach are low. We design a new flow-based weighting of transmissibility values in LG upscaling that significantly improves the accuracy of LG and MLLG over traditional local transmissibility calculations. For highly heterogeneous (e.g., channelized) systems, the integration of grid adaptivity and LG upscaling is shown to consistently provide more accurate coarse-scale models for global flow, relative to reference fine-scale results, than do existing upscaling techniques applied to uniform grids of similar densities. Another attractive property of the integration of upscaling and adaptivity is that process dependency is strongly reduced, that is, the approach computes accurate global flow results also for flows driven by boundary conditions different from the generic boundary conditions used to compute the upscaled parameters. The method is demonstrated on Cartesian cell-based anisotropic refinement (CCAR) grids, but it can be applied to other adaptation strategies for structured grids and extended to unstructured grids.     

Accurate local upscaling with variable compact multipoint transmissibility calculations

We propose a new single-phase local upscaling method that uses spatially varying multipoint transmissibility calculations. The method is demonstrated on two-dimensional Cartesian and adaptive Cartesian grids. For each cell face in the coarse upscaled grid, we create a local fine grid region surrounding the face on which we solve two generic local flow problems. The multipoint stencils used to calculate the fluxes across coarse grid cell faces involve the six neighboring pressure values. They are required to honor the two generic flow problems. The remaining degrees of freedom are used to maximize compactness and to ensure that the flux approximation is as close as possible to being two-point. The resulting multipoint flux approximations are spatially varying (a subset of the six neighbors is adaptively chosen) and reduce to two-point expressions in cases without full-tensor anisotropy. Numerical tests show that the method significantly improves upscaling accuracy as compared to commonly used local methods and also compares favorably with a local–global upscaling method.