地形面方法在渭河盆地活断层研究中的应用

本文主要依据地形图和航空照片解译，并经已有地质、钻孔资料验证及野外实地考察的方法来研究地形面及其变形特征，由此确定渭河盆地活断层的分布、最新活动特征及活动规律，为地震预报及地震危险性分析提供依据。     

Structural characterization of deep-water deposits in a foreland basin, Silla Syncline (Chilean Patagonia), with applications to depositional processes

Based on our detailed structural characterization, we examine possible relationships between thrust faults and strike-slip faults and thrust-cored folds and depositional units in the Silla Syncline, a 4 km wide fold composed of fine-grained mudstone, coarse sandstone and conglomerate deposits of the Cerro Toro Formation in the Magallanes foreland basin, Chilean Patagonia. The syncline is bounded on its western flank by an asymmetric anticline and on its eastern flank by a broad zone of thrust faults and associated folds, which are oriented sub-parallel to the syncline axis. Deposition of the coarse-grained units of the Silla Syncline appears to have taken place in this structurally defined trough controlled primarily by thrust fault related growth structures flanking the syncline.The syncline and surrounding area have also been deformed by two sets of strike-slip faults, one right-lateral and one left-lateral. The strike-slip and thrust faulting operated contemporaneously for much of their active periods, although it appears that thrust faulting, confined within the fine-grained units, initiated slightly earlier than strike-slip faulting. In addition, younger igneous intrusions at high angle to bedding generally localize along the strike-slip faults. The cross-cutting relationships among the intrusions, strike-slip faults, and flexural slip faults show that all these structures were active during the same period, which extends beyond mid-Miocene.These conclusions support the premise that structures in deep-water sediments are important for understanding not only the deformation of a foreland basin, but also its depositional architecture.     

扇贝的养殖环境及其体内的细菌学分析

自1992年9月～1994年11月，对青岛胶州湾养殖的扇贝及环境中的细菌组成和某些生态学特性进行了调查。养殖区表层海水中异养菌和弧菌平均数各波动于（21．2～39．7）×102／cm3和（7．3～19．2）×102／cm3之间。其中1号和4号站位的菌数比其它越位都高，这和它们靠近码头，受到附近的排水污染有关。在扇贝的消化盲囊和性腺内也分离到异养菌和弧菌，分别为103～105个g和103～105个／g。这些细菌可能因扇贝遇到环境改变防御能力下降时，扩散到其它器官并大量繁殖，因而造成感染而死亡。从对分离菌的药物敏感试验结果看，近年一些菌株对原来敏感的药物产生了抗药性，如四环索和链霉素，今后在育苗过程中避免滥用抗菌药物是十分重要的。     

红河断裂构造带在东南亚的延伸特征及其大地构造意义

根据地质、地貌及地球物理资料分析,探讨展布于云南边陲哀牢山两侧的北西向断裂组成的红河断裂构造带,在东南亚的延伸特征。提出在该延伸带两侧沉积建造、构造活动,地球物理场和大地构造发展上均有显著差异。并进一步探讨该断裂构造带在大地构造上的意义。     

High heat flow anomalies on an old oceanic plate observed seaward of the Japan Trench

Thirty-three new measurements on the seaward slope and outer rise of the Japan Trench along a parallel of 38°45′N revealed the existence of high heat flow anomalies on the subducting Pacific plate, where the seafloor age is about 135 m.y.. The most prominent anomaly with the highest value of 114 mW/m² is associated with a small mound on the outer rise, which was reported to be a kind of mud volcano. On the seaward slope of the trench, heat flow is variable: high (70–90 mW/m²) at some locations and normal for the seafloor age (about 50 mW/m²) at others. The spatial variation of heat flow may be related to development of normal faults and horst/graben structures due to bending of the Pacific plate before subduction, with fluid flow along the fault zones enhancing the vertical heat transfer. Possible heat sources of the high heat flow anomalies are intra-plate volcanism in the last several million years like that discovered recently on the Pacific plate east of the Japan Trench.     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

System for normalization of a hamiltonian function based on lie series

A software system for normalization of a Hamiltonian function is described. A few examples of its applications are given. It is written in PASCAL and runs on an IBM XT/AT with 640 KB memory.     

Fault zone geometry of a mature active normal fault: A potential high permeability channel (Pirgaki fault, Corinth rift, Greece)

We present results from petrophysical analysis of a normal fault zone with the aim of defining the flow pathways and their behavior during seismic and interseismic periods. Data are obtained on porosity geometry, strain structure and mineralogy of different domains of a normal fault zone in the Corinth rift. Data point out a close relationship between mineralogy of the clayey minerals, porosity network and strain structures and allow definition of a macroscopic anisotropy of the flow parameters with a strong control by microscopic ultracataclasite structures. The Pirgaki fault zone, developed within pelagic limestone, has a sharp asymmetric porosity profile, with a high porosity volume in the fault core and in the damage zone of the hanging wall. From porosity volumes and threshold measurements, a matrix permeability variation of 6 orders of magnitude could be expected between the protolith and the fault core. Modifications of this pathway during seismic and interseismic phases are depicted. Healing of cracks formed during seismic slip events occurred in the fault core zone and the porous network in the damage zone is sealed in a second step. The lens geometry of the fault core zone is associated with dissolution surfaces and open conduits where dissolved matter could move out of the fault core zone. These elementary processes are developed in particular along Riedel's structures and depend on the orientation of the strain surfaces relative to the local stress and depend also on the roughness of each surface type. P-surfaces are smooth and control shearing process. R-surfaces are rough and present two wavelengths of roughness. The long one controls localization of dissolution surfaces and conduits; the short one is characteristic of dissolution surfaces. The dissolved matter can precipitate in the open structures of the hanging wall damage zone, decreasing the connectivity of the macroscopic conduit developed within this part of the fault zone.     

Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.