Submillimeter-wave and observations of the event on 28 November, 2001

We present a detailed study of a 1B/M6.9 impulsive flare combining high time resolution (1 ms) and instantaneous emission source localization observations at submillimeter frequencies (212 GHz), obtained with the solar submillimeter telescope (SST), and Hα data from the Hα solar telescope for argentina (HASTA). The flare, starting at 16:34 UT, occurred in active region (AR) 9715 (NOAA number) on November 28, 2001, and was followed by an Hα surge. We complement our data with magnetograms from the Michelson Doppler Imager (SOHO/MDI). SST observed a short impulsive burst at 212 GHz, presenting a weak bulk emission (of about 90 sfu) composed of a few shorter duration structures. The integrated Hα and the 212 GHz light curves present a remarkable agreement during the impulsive phase of the event. The delay between both curves stays below 12 s (the time resolution of the Hα telescope). The flare as well as the surge are linked to new flux emergence very close to the main AR bipole. Taking into account the AR magnetic field evolution, we infer that magnetic field reconnection, occurring at low coronal levels, could have been at the origin of the flare; while in the case of surge this would happen at the chromospheric level.     

The effective number of cycles of earthquake ground motion

The seismic response of any system that accumulates damage under cyclic loading is dependent not only on the maximum amplitude of the motion but also its duration. This is explicitly recognized in methods for estimating the liquefaction potential of soil deposits. Many researchers have proposed that the effective number of cycles of the ground motion is a more robust indicator of the destructive capacity of the shaking than the duration. However, as is the case with strong‐motion duration, there is no universally accepted approach to determining the effective number of cycles of motion, and the different methods that have been proposed can give widely varying results for a particular accelerogram. Definitions of the effective number of cycles of motion are reviewed, classified and compared. Measurements are found to differ particularly for accelerograms with broad‐banded frequency content, which contain a significant number of non‐zero crossing peaks. The key seismological parameters influencing the number of cycles of motion and associated equations for predicting this quantity for future earthquakes are identified. Correlations between cycle counts and different duration measures are explored and found to be rather poor in the absence of additional parameters. Copyright © 2004 John Wiley & Sons, Ltd.     

Distribution of chlorophyll-a off the Changjiang River and its dynamic cause interpretation

Red tide,also called harmful algal bloom interna-tionally,is a disaster abnormal phenomenon of oceanecology with an explosive breed or dense assemble ofone or several phytoplanktons in a specific ocean en-vironment condition,colors the seawater,influencesand harms ocean living things.The formation of redtide is controlled mainly by a complex interplay ofbiological,physical and chemical processes,but themost main cause influencing the occurrence of red tideis the seawater eutrophication,i.e.,the…     

Study on simulating strong ground motion by fractal stochastic method

The time history of strong ground motion can be synthesized by empirical Green's function (EGF) method.Firstly a large seismic event is discretized into a series of subevents; secondly recordings of earthquakes with proper size and spatial distribution are chosen as time history (EGF) of those subevents; finally the EGFs are summated to get the time history of ground motion caused by the large event.     

Ground deformation of Nisyros Volcano (Greece) for the period 1995–2002: Results from DInSAR and DGPS observations

Differential GPS (DGPS) and Differential Interferometric Synthetic Aperture Radar (DInSAR) analyses were applied to the Kos-Yali-Nisyros Volcanic Field (SE Hellenic Volcanic Arc) to quantify the ground deformation of Nisyros Volcano. After intense seismic activity in 1996, a GPS network was installed in June 1997 and re-occupied annually up to 2002. A general uplift ranging from 14 to 140 mm was determined at all stations of the network. The corresponding horizontal displacements ranged from 13 to 53 mm. The displacement vectors indicate that the island is undergoing extension towards the East, West and South. A two-source “Mogi” model combined with assumed motion along the Mandraki Fault was constructed to fit the observed deformation. The best-fit model assumes sources at a depth of 5500 m NW of the centre of the island and at 6500 m offshore ESE of Yali Island. DInSAR analysis using four pairs of images taken between May 1995 and September 2000 suggests that deformation was occurring during 1995 before the start of the seismic crisis. An amplitude of at least 56 mm along the slant range appeared for the period 1996 through 1999. This deformation is consistent with the two-source model invoked in DGPS modelling. Surface evidence of ground deformation is expressed in the contemporaneous reactivation of the Mandraki Fault. In addition, a 600 m long N-S trending irregular rupture in the caldera floor was formed between 2001 and 2002. This rupture is interpreted as the release of surface stress in the consolidated epiclastic and hydrothermal sediments of the caldera floor.     

工程勘察设计行业信息化建设问题反思及其新领域应用开发综述

本文通过对勘察设计行业信息化建设的深入思考,总结并提出了在设计院信息化建设七个领域应用开发的新思路。     

Determination of Lithium, Beryllium and Boron at Trace Levels by Laser Ablation-Inductively Coupled Plasma-Sector Field Mass Spectrometry

The analytical capabilities of laser ablation (LA)-ICP-MS in determining Li, Be and B at trace levels in geological samples have been tested on a series of glass reference materials and natural samples. The LA-ICP-MS instrument used consisted of a sector-field ICP-MS coupled with a laser ablation microprobe operating at either 266 or 213 nm wavelength. Reference glasses from NIST (SRM 612, 614 and 616) and MPI-DING (KL2-G, ML3B-G, StHs6/80-G, GOR128-G, GOR132-G, T1-G and ATHO-G) were selected to develop the analytical method and to assess the best instrumental configuration. A series of calcic amphiboles with different Li, Be and B concentrations were also analysed using both LA-ICP-MS and SIMS to test the applicability of the method to natural minerals. Results indicated that with a spot size of 40 μm the agreement between measured and reference values of Li, Be and B is generally better than 10% for NIST SRM 612 and 20% for NIST SRM 614. Average reproducibility at the 2s level was 10% for Li, 20% for Be and 15% for B. Limits of detection were approximately 100 ng g^-1 for Be and B and 200 ng g^-1 for Li. These results were confirmed by analyses carried out on natural amphiboles and compared well in terms of precision and accuracy with those commonly achieved by SIMS.