顺向次生成层结构边坡稳定性影响因素分析

边坡稳定性影响因素分析是认识边坡变形破坏机制、评价稳定性和预测变形发展趋势的重要前提。针对边坡工程中的出现的次生成层结构边坡,首先简要分析其次生成层结构岩体的主要成因机制;然后根据顺向次生成层结构边坡的特点和工程经验,选取影响这类边坡稳定性的重要因素,通过参数取值正交试验,并采用UDEC软件对其进行数值模拟,获得各影响因素对边坡变形破坏影响程度的量化结果。研究结果表明：这类成层结构是接近地表的岩体在外生作用下由于差异卸荷回弹作用、应力分异和动荷载作用发生应力释放而形成的次生结构;各因素对顺向次生成层结构边坡稳定性影响的主次顺序各不相同;而在单一影响因素变化下其边坡稳定性系数、次生成层最大张开程度、坡顶最大位移又表现出不一样的特点。该研究结果对顺向次生成层结构边坡的开挖设计和支护措施选择具有重要理论和实践意义。     

Determining the location of buried plastic water pipes from measurements of ground surface vibration

‘Mapping the Underworld’ is a UK-based project, which aims to create a multi-sensor device that combines complementary technologies for remote buried utility service detection and location. One of the technologies to be incorporated in the device is low-frequency vibro-acoustics, and techniques for detecting buried infrastructure, in particular plastic water pipes, are being investigated. One of the proposed techniques involves excitation of the pipe at some known location with concurrent vibrational mapping of the ground surface in order to infer the location of the remainder of the pipe. In this paper, measurements made on a dedicated pipe rig are reported. Frequency response measurements relating vibrational velocity on the ground to the input excitation were acquired. Contour plots of the unwrapped phase revealed the location of the pipe to within 0.1-0.2 m. Magnitude contour plots revealed the excitation point and also the location of the pipe end. By examining the unwrapped phase gradients along a line above the pipe, it was possible to identify the wave-type within the pipe responsible for the ground surface vibration. Furthermore, changes in the ground surface phase speed computed using this method enabled the location of the end of the pipe to be confirmed.     

Postbuckling of shear deformable stiffened anisotropic laminated cylindrical shell under axial compression

A postbuckling analysis is presented for a shear deformable anisotropic laminated cylindrical shell with stiffener of finite length subjected to axial compression. The material of each layer of the shell is assumed to be linearly elastic, anisotropic and fiber-reinforced. The governing equations are based on a higher order shear deformation shell theory with von Kármán-Donnell-type of kinematic nonlinearity and including the extension/twist, extension/flexural and flexural/twist couplings. The ‘smeared stiffener’ approach is adopted for the beam stiffeners. This arrangement allows the beam stiffeners to be assembled directly into the global stiffness matrix. The nonlinear prebuckling deformations and initial geometric imperfections of the shell are both taken into account. A singular perturbation technique is employed to determine the buckling loads and postbuckling equilibrium paths. The numerical illustrations concern the postbuckling response of perfect and imperfect, grid, axial, ring stiffened, and unstiffened shells. The results confirm that there exists a compressive stress along with an associate shear stress and twisting when the anisotropic shell is subjected to axial compression. The postbuckling equilibrium path is unstable for the moderately thick cylindrical shell under axial compression and the stiffened shell structure is imperfection-sensitive.     

海冰形变对北极冬季CICE模式冰厚模拟结果的影响

海冰数值模式是研究海冰动力热力状态参量及之间联系的有效途径。目前对冰厚数值模拟结果的分析远远少于对海冰范围/面积和密集度的研究,对冰速与海冰形变对冰厚分布影响的研究也尚欠缺。本文利用Los Alamos sea ice model（CICE）海冰模式模拟了1980−2018年的北极海冰变化,并使用遥感、同化冰厚数据进行比对验证,分析了模拟冰速和海冰形变对冰厚的影响,计算了冰速的散度和切变偏差对冰厚偏差的贡献。结果显示,CICE对北极70°N以北区域平均冰厚和冰速的年际变化模拟基本合理,但模拟的平均冰厚和冰速多年变化趋势均小于同化数据的变化率;模拟和观测冰厚的空间分布差异与冰速和形变率的偏差有密切联系,主要表现为波弗特海的正偏差和北极中央区至弗拉姆海峡的负偏差。泛北极区域散度和切变偏差在3月之前对冰厚偏差的贡献在13%～16%之间变化,3−4月则由16%跃变至27%。散度偏差主导了11月、12月波弗特海区域的冰厚正偏差,切变偏差主导了冬季加拿大群岛以北海域和穿极流区域的冰厚负偏差。     

基于加速度传感器数据融合的隧道施工地面沉降监测技术研究

地面沉降的监测和控制一直是制约隧道施工安全的关键问题,目前地表沉降量一般利用水准仪等传统设备、通过人工定期测量获取,无法进行实时动态观测。随着无线传感器网络和微机电系统的高速发展,通过在地表布置无线传感器节点,即可对隧道施工引起的地面沉降进行实时监测。本文对处于盾构施工期的某隧道开展了基于加速度传感器数据融合的地面沉降监测技术研究。首先,在隧道上方和两侧布置了内嵌两套加速度传感器的节点盒,获取原始监测数据;然后,利用旋转矩阵求解其空间法向量,并通过投影得到地表节点在隧道轴向上的倾斜角;最终,通过集中式卡尔曼滤波对上述两类传感器的倾斜角进行融合估计,推导出传感器倾斜角随时间的变化情况。基于该方法,通过布置传感器节点监测网,即可估算隧道施工引起的地表绝对沉降量。     

Observations of vertical ground accelerations exceeding gravity during the 1997 Umbria-Marche (central Italy) earthquakes

We found extensive evidence that the vertical ground accelerations produced during the largest shock (M = 6.0) of the 1997 Umbria-Marche earthquake sequence exceeded 1g in two areas close to the heavily-damaged villages of Annifo and Colle Croce. This evidence comes from the striking observation of thousands of freshly fractured and broken rocks and stones in these areas. Some of the broken stones lie isolated on soft detritic soil while others had been previously piled up, probably a long time agoto clear the fields for farming. The freshness of the cuts and fractures and the consistency of the observations for thousands of rocks and stones in these areas indicate that these rocks were thrown upwards during the earthquake, with breakage occurring at the time of impact. Ground motion calculations consistent with the static deformation inferred from GPS and interferometry data, show that the broken stones and rocks are found in the zone where the strongest shaking took place during the earthquake and that most of the shaking there was vertical.