小直径组合桩的波浪力实验分析

本文给出小直径孤立桩、两个桩和2×2个桩的波浪作用力实验结果。在波浪水槽中以0°,45°,90°三个波浪方向测量了各桩所受的纵向力和横向力,文中讨论了组合桩之间的干扰效应,给出了干扰系数随KC数和桩距的变化。     

Evaluation of the Risk of Marine Slope Instability: A Pseudo-3D Approach for Application to Large Areas

This article presents a methodology developed to evaluate the instability of submarine slopes that extend over a large area. Special attention was paid to (1) the complex geometry (bathymetry) and the expanse of the slope, (2) the heterogeneity of the sediment, and (3) the distribution of the pore pressure. The safety factor was considered as a spatially varying quantity. The General Formulation (GLE, Fredlund and Krahn 1977), which fully satisfies equilibrium conditions, was used for evaluating the stability of the marine slope. The submarine slope failure, which occurred on 16 October 1979 during the construction of the new Nice airport, was studied in order to test the developed model. Geotechnical parameters were taken from experimental tests carried out by IFREMER on 19 cores extracted at different depths (from 27 m to 1300 m) (Cochonat, Bourillet, and Savoye, 1993; Mulder et al., 1994). Many scenarios were proposed in order to explain the cause of the Nice slope failure (Habib, 1994). In this article, two of those scenarios were tested. Simulation results are presented and discussed.     

低围压水平下砂的排水行为(英文)

采用干样沉降法制备样品 ,选用静三轴仪对松砂和密砂样在 10 k Pa至 10 0 k Pa的低围压下的排水行为进行了实验研究 ,并对实验结果作了橡皮膜校正 ,在围压为 10 k Pa的密砂实验中 ,轴向应力的校正值可达到 12 %。实验研究表明低围压下松砂的剪胀性非常明显 ,且存在剪应力极值 ;围压越低 ,松砂和密砂的剪应力极值越小 ,达到最大剪应力所对应的剪应变越小。同时还表明低围压范围内相对密度不同 ,砂的应力应变特性不同 ;此外 ,低围压下砂的内摩擦角高于高围压下的值 ,从而在工程上应重视低围压水平下砂土工程参数的合理选取     

南海罗斯贝变形半径的地理及季节变化

根据南海 1°× 1°网格的标准层季节平均温、盐度资料 ,在未引入Boussinesq近似条件下 ,采用改进的Thompson Haskell算法求解线性化斜压海洋水平大尺度波的垂直结构方程 (重力内波方程 ) ,从而得到了南海各网格点的第一斜压重力波相速度和相应的罗斯贝变形半径 ,并探讨其地理分布和季节变化特征 ,以期有助于南海环流和中尺度涡旋以及有关海洋侧边界效应的研究。     

北极海冰减少的气候效应研究

本文采用了OSU两层大气环流模式对特定的北极海冰进行数值模拟,研究北极海冰减少的气候效应.试验中海温一律取为气候平均值,北极海冰作为外强迫源影响大气,大气响应完全是环流内部调整的结果.本文对北极海冰减少后的大气环流特征进行了分析,特别是与中国的气温和降水之间的关系.     

Numerical simulation of solitary wave scattering by a circular cylinder array

The interaction of a solitary wave with an array of surface-piercing vertical circular cylinders is investigated numerically. The wave motion is modeled by a set of generalized Boussinesq equations. The governing equations are discretized using a finite element method. The numerical model is validated against the experimental data of solitary wave reflection from a vertical wall and solitary wave scattering by a vertical circular cylinder respectively. The predicted wave surface elevation and the wave forces on the cylinder agree well with the experimental data. The numerical model is then employed to study solitary wave scattering by arrays of two circular cylinders and four circular cylinders respectively. The effect of wave direction on the wave forces and the wave runup on the cylinders is quantified.     

Mach Effect of Oblique Nonlinear Irregular Waves Interacting with Vertical Walls

Based on Hong‘s theory, previous random models, and a generalized expression suitable for FIT calculation, the interaction between irregular waves and vertical walls is numerically simulated. The results of simulation demonstrate that the wave energy changes with the incidence angle and the distance from the wall. Particularly, the Mach effect and the combined wave spectrum characteristics are analyzed in detail, which are significant in both theory and practice.     

The buckling of a corrugated carbon fibre cylinder under external hydrostatic pressure

A theoretical and an experimental investigation was carried out, where a carbon fibre corrugated circular cylinder was tested to destuction under external hydrostatic pressure. The theoretical investigation was via the finite element method, where the structure was modelled with several orthotropic axisymmetric thin-walled shell elements. The experimental observations were aided with strategically placed strain gauges. Comparison between theory and experiment showed that the experimentally observed buckling pressure was a little lower than the theoretical prediction. This may have been due to the fact that the model had slight initial geometrical imperfections in the circumferenential direction.     

A new efficient 3D non-hydrostatic free-surface flow model for simulating water wave motions

A new three-dimensional, non-hydrostatic free surface flow model is presented. For simulating water wave motions over uneven bottoms, the model employs an explicit project method on a Cartesian the staggered gird system to solve the complete three-dimensional Navier–Stokes equations. A bi-conjugated gradient method with a pre-conditioning procedure is used to solve the resulting matrix system. The model is capable of resolving non-hydrostatic pressure by incorporating the integral method of the top-layer pressure treatment, and predicting wave propagation and interaction over irregular bottom by including a partial bottom-cell treatment. Four examples of surface wave propagation are used to demonstrate the capability of the model. Using a small of vertical layers (e.g. 2–3 layers), it is shown that the model could effectively and accurately resolve wave shoaling, non-linearity, dispersion, fission, refraction, and diffraction phenomena.     

Wave runup on a concentric twin perforated circular cylinder

The regular wave interaction with a twin concentric porous circular cylinder system consisting of an inner impermeable cylinder and an outer perforated cylinder was studied through physical model and numerical model studies. The experiments were carried out on the twin concentric cylinder model in a wave flume to study the wave runup and rundown at the leading and trailing edges of the perforated cylinder. It was found that the maximum wave runup on the perforated cylinder is almost same as the incident wave height. The experimental results were used to develop the predictive formulae for the wave runup and rundown on the perforated cylinder, which can be easily used for design applications. The wave runup profiles around the perforated cylinder for different values of ka and porosities were studied numerically using Green's Identity Method. The results of the numerical study are presented and compared with the experimental measurements.