Development of grabens and associated fault-drags: An experimental study

Experiments on extensional faulting were performed with semi-brittle talc-sand beds resting on a ductile clay base. The experiments show that the development of graben in the talc-sand beds is controlled by the deformation in the ductile basement. Graben-like structures form only when there is a non-uniform stretching in the basement. Uniform extension at the basement level fails to produce any such structures. Grabens initiate as large synclinal structures (sag). The sag is generated either by a downward flexing of the talc-sand bed on a ductile basement or by non ****-uniform thinning of beds. Listric master faults bounding the grabens intersect the basement at high angles. The master faults that initiate as curved shear planes rotate further with continued extension. At the initial stage, the graben structures are associated with normal drags, and with progressive deformation, drag patterns change from normal to a reverse one.     

Tectono–Magmatic Evolution and Metallogenesis along the Northeast Jiangxi Deep Fault, China

Abstract: From the southernmost part of Jiangsu province to the northeastern part of Jiangxi province, China, the Northeast Jiangxi Deep Fault runs for about 400 km length with a width of 30 to 40 km. This fault marks the suture zone of two ter-ranes of Proterozoic age. At the both sides of the fault, Yanshanian granitic activity is recognized. That is, the Dexing-Wuyuan porphyry belt on the NW side of the fault, and the Damaoshan-Lingshan granite belt on the SE side. The former activity is characterized by the occurrence of small stocks of granodioritic composition, rich in siderophile elements but poor in LIL elements. No distinct Eu anomaly is recognized in the REE pattern, and a low initial ⁸⁷Sr/⁸⁶Sr ratio is reported. Magnetite, sphene and apatite are observed as accessory minerals. On the contrary, granitic activity on the SE side of the fault is characterized by the occurrence of composite batholiths, in general of granitic to monzogranitic composition, rich in LIL and alkali elements but poor in siderophile and alkali earth elements. A strong Eu anamaly is recognized in the REE pattern, and initial ⁸⁷Sr/⁸⁶Sr ratios are as high as 0. 716. Fluorite, zircon and REE minerals are observed as accessory minerals. These two contrasting granitic activities are refered to as syntexis– and transformation–types, respectively, following the classification commonly used in China, and have similar petrochemical characteristics to those defined for the magnetite– and ilmenite–series, and I– and S-type granitoids. Considering that the above igneous activity occurred far from the supposed subduction zone along the East Coast of China, intracontinental A-type (continent to continent) subduction is proposed to have occurred northwestwards along the NE Jiangxi Deep Fault during Yanshanian time due to a strong compressional stress from SE to NW. A-type subduction introduced the continental slab to some depth, and resulted in the production of the paired granitic activity observed on both sides of the fault. Many mineral deposits are associated with both granitic belts. In the Dexing-Wuyuan porphyry belt, the Dexing porphyry Cu and Yinshan polymetallic deposits are representative, whereas in the Damaoshan-Lingshan granite belt, several tens of rare metal deposits are known such as the Geyuan Nb–Ta–W–Sn deposits. Metal assemblages of those deposits reflect the source materials of magmas in both granitic belts.     

航磁ΔT平面归一化总梯度方法及其在内蒙陆西凹陷的应用

本文首次提出将剖面归一化总梯度方法推广到平面加以应用,得到平面归一化总梯度方法,并根据剖面归一化总梯度的计算公式相应地推导了平面归一化总梯度的计算公式,将其应用到内蒙陆西凹陷探测油气田,取得了一定的地质效果。     

流动环境中二维铅垂纯射流的试验研究

对均匀流动环境中的铅直二维射流进行了试验研究,得到了流动转变的条件.采用超声多普勒流速仪(ADV)对射流流场进行了测量,得到了流速矢量图和流线图,发现在射流的迎流面存在流线跌落现象.探讨了流速比对射流背流面涡心和分离点位置的影响.给出低流速比为8的射流流场的实测结果,以供数值模拟对比使用.     

扬子东部冶山和山里陈埃达克质侵入岩年代学与地球化学:岩石成因和动力学意义

冶山和山里陈岩体构造上属于扬子地块东部,毗邻郯庐断裂带东侧,主要岩石类型为石英闪长玢岩。它们的单矿物(角闪石,黑云母)40Ar/39Ar坪年龄分别为131.22±0.77 Ma和130.07±0.48 Ma。冶山和山里陈岩体具有与埃达克岩类似的地球化学特征,如w(SiO2)>56%,高Al2O3[w(Al2O3)=14.95%～17.67%]、Sr[w(Sr)=495×10-6～2086×10-6]、Sr/Y(44～159)和La/Yb(26～68),低重稀土元素,如w(Yb)=0.82×10-6～1.56×10-6),w(Y)=9.14×10-6～20.32×10-6,无明显-正Eu异常(δEu=0.90～1.11)。另外,样品普遍具有较高的MgO[w(MgO)=2.01%～4.98%]、IMg(45～71)和Cr[w(Cr)=19.2×10-6～199×10-6]、Ni[w(Ni)=13.8×10-6～58.8×10-6]。它们的Sr-Nd-Pb同位素特征为:(87 Sr/86 Sr)i=0.7059～0.7062,εNd(t)=-14.75～-12.15,(206 Pb/204 Pb)t=16.082～16.847,(207 Pb/204 Pb)t=15.303～15.461,(208Pb/204Pb)t=35.889～36.919。冶山和山里陈埃达克质侵入岩可能是由于扬子与华北地块在三叠纪的碰撞及扬子地块东部的地壳拆离作用,导致下地壳增厚并发生拆沉熔融,岩浆在上升过程中与地幔橄榄岩发生了反应。郯庐断裂带两侧早白垩世时期的埃达克(质)岩可能形成于断裂带早白垩世时期由左行平移向伸展活动转变的阶段,其源动力很可能是受到滨太平洋板块构造的影响。     

塔里木盆地轮西地区奥陶系潜山油藏:一个海西期充注并降解的稠油油藏成藏实例分析

塔北隆起的轮西地区具有以裂缝、溶蚀裂缝和溶洞为主的下奥陶统潜山储集体,且继承型古隆起一直成为油气运移和聚集的指向区,因此具有较为优选的成藏地质条件。海西晚期是轮西地区稠油藏的主要成藏期,海西末期石炭-二叠系地层遭受强烈剥蚀使海西晚期聚集的奥陶系潜山原油降解,成为重质稠油油藏,并不受印支晚期至喜马拉雅期运动的影响。印支晚期之后Ⅰ级断裂活动停滞,使轮西地区奥陶系潜山以稠油为主的油藏基本上未受晚期油气充注的影响。对轮西奥陶系潜山油藏研究得到的重要启示是:应加强塔里木盆地克拉通地区早期成藏勘探潜力的认识。     

Anthropogenic affects on lake sedimentation process: a case study from Lake Sapanca, NW Turkey

Lake Sapanca in NW Turkey is a fault originated freshwater basin fed by seasonally variable flows of 15 streams. Considerations of lake–river interaction, supported by statistical measures of 47 bottom samples, suggest that sediment transport and deposition within the lake is controlled by two types of human constructed structures in addition to natural factors: (1) the dykes constructed in the front of streams, which feed the lake by strong flows, to prevent the filling of lakebed by coarse-grained sediments; (2) the constructed regulator on the outflowing Çarksuyu stream results in a higher sedimentation rate of clay-sized material on the NE corner of the lake, which is extraordinary in the shelf environment.     

福建戴云山隧道断层性质与稳定性研究

隧道断层（F2）为张性正断层,破坏原岩中较为对称的应力平衡,加之带内岩石破碎,节理裂隙发育,使得断层更加容易坍塌和涌水。建议采用稳定掌子面法和专门支护保证硐室稳定。     

断层垂向封闭性定量研究方法及其在准噶尔盆地白家海凸起东道海子断裂带应用

断层的垂向封闭能力主要取决于断面的紧闭程度和断裂带内填充物的岩性。在定量计算断面正压力和断层两侧地层泥地比的基础上,提出了断层垂向封闭因子(Fvs)的概念,并将其定义为断面正压力与断层两侧地层泥地比的乘积。通过该参数可以定量评价断层的垂向封闭能力。以准噶尔盆地东道海子断裂为例,在建立断层垂向封油、气能力评价标准的基础上,应用断层垂向封闭因子(Fvs)定量评价了该断裂带的成藏期垂向封闭性及现今垂向封闭性,分析了该断裂带对油气成藏的控制作用,得到较好效果。     

复杂应力状态下条形基础的临塑荷载公式

莫尔-库仑强度准则的临塑荷载公式由于没有考虑中主应力在强度上的作用使计算结果偏于保守。利用具有线性形式的双剪应力强度准则替换原有的莫尔-库仑强度准则,将中主应力引入临塑荷载的计算中,推导出平面应变条件下考虑中主应力影响的临塑荷载公式,并通过算例说明了新临塑荷载公式的计算结果比原有公式有较大的偏高。