Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Risk assessment strategies for the reactivation of earth flows in the Northern Apennines (Italy)

The aim of this paper is to analyze the reactivation mechanism of ancient earth flows, with a view to gleaning information that can subsequently be utilized to formulate a risk-reduction strategy. All considerations made herein are the result of direct experience and observation of actual events which have occurred over the past few decades in the Northern Apennines. Particular attention has been paid to the analysis of the evolution of landslides during actual reactivation, acknowledging a typical, recurring succession of events that precede the failure of the slope. The hazard assessment of these large landslide bodies, which are of slope scale, constitutes a thorny problem, especially in view of the inapplicability of traditional deterministic models such as limit equilibrium stability analysis. Nevertheless, a site-specific assessment of probability of reactivation of these large and ancient earth flows is fundamental to effective land-use planning.     

Influence of Structural Non-Stationarity of Surface Roughness on Morphological Characterization and Mechanical Deformation of Rock Joints

Summary Structural non-stationarity of surface roughness affects accurate morphological characterization as well as mechanical behaviour of rock joints at the laboratory scale using samples with a size below the stationarity threshold. In this paper, the effect of structural non-stationarity of surface roughness is investigated by studying the scale dependence of surface roughness and mechanical behaviour of rock joints. The results show that the structural non-stationarity mainly affects the accurate characterization of the surface roughness of the fracture samples. It also controls the amount and location of the contact areas during shear tests, which in turn affects the mechanical properties and asperity degradation of the samples. It is concluded that for accurate determination of the morphological and mechanical properties of rock joints at laboratory and field scales, samples with size equal to or larger than the stationarity threshold are required. Author’s address: Nader Fardin, Rock Mechanics Group, Department of Mining Engineering, Faculty of Engineering, University of Tehran, P.O. Box: 11365/4563, Tehran, Iran     

Analysis of the 2003 Varunawat Landslide,Uttarkashi, India using Earth Observation data

Mass movements such as landslides in mountainous terrains are natural degradation processes and one of the most important landscape-building factors. Varunawat Parbat overlooking Uttarkashi town witnessed a series of landslides on 23 September 2003 and the debris slides and rock falls continued for 2 weeks. This landslide complex was triggered due to the incessant rainfall prior to the event, and its occurrence led to the blockage of the pilgrim route to Gangotri (source of the Ganges river) and evacuation of thousands of people to safer places. Though there was no loss of lives due to timely evacuation, heavy losses to the property were reported. High-resolution stereoscopic earth observation data were acquired after the incidence to study the landslide in detail with emphasis on the cause of the landslide and mode of failure. Areas along the road and below the Varunawat foothill region are mapped for landslide risk. It was found that the foothill region of the Varunawat Parbat was highly disturbed by man-made activities and houses are dangerously located below steep slopes. The potential zones for landslides along with the existing active and old landslides are mapped. These areas are critical and their treatment with priority is required in order to minimise further landslide occurrences.     

江苏潮滩沉积物激光粒度仪与移液管-筛析分析结果的对比

激光粒度仪的广泛应用带来了与历史数据的对比问题,因此需要建立激光粒度仪与早期分析结果之间的关系。根据江苏海岸潮滩沉积物样品的激光粒度仪和移液管-筛析法分析,对粒度参数、粒度组分等进行了对比,对两种方法的差异进行了分析。结果表明,对于江苏潮滩沉积物粒度参数中平均粒径的激光粒度仪与移液管-筛析分析结果之间有良好的线性关系;筛分法测得的粗颗粒物质较激光法偏少,而移液管法法测得的细颗粒物质较激光法偏多;将样品分类之后再进行两种方法所获粒度参数的回归分析,相关性得以提高,说明不同粒度组成的沉积物对分析结果的对比有不同的影响。两种方法之间的换算关系不仅与研究区域有关,而且与沉积物本身的粒度组成有关。     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。     

基于Mindlin理论Winkler地基参数的Kalman滤波识别

提出了Winkler地基参数的Kalman滤波识别方法。引入Mindlin理论后,推导了Winkler地基上板的控制微分方程。利用Fourier变换,推求了Winkler地基上简支板的Fourier闭式解。推导了Winkler地基参数的Kalman滤波方程,研究了Winkler地基参数的Kalman滤波识别的具体计算步骤。研究表明,运用Kalman滤波理论进行Winkler地基参数的识别,能有效地估计Winkler地基参数;Winkler地基参数的滤波收敛速度和精度受地基参数初始值选取和位移实测资料的影响,且Kalman滤波理论也可用于其他地基模型地基参数的识别。     

地震折射波的虚拟射线理论及其应用

本文提出了一种地震折射液的虚拟射线理论,根据该理论,只要已知地表层的速度,即可直接由折射波信息提取地震参数,从而可实现折射界面的反演。 文中通过实际介质模型的计算机实验结果,验证了该理论的正确性。     

Wave run-up and overtopping on smooth and rough slopes of coastal structures

A series of hydraulic model tests has been carried out in a glass wave flume to investigate the influences of wave height, wave period, wave steepness, surf similarity parameter, roughness, layer thickness and porosity on wave run-up and overtopping of 1:2 sloped impermeable and permeable breakwaters fronted by a 1:10 gentle, smooth beach slope. The analysis of results involves the correlation between the overtopping energy transfer with the relative wall height and the relationship between wave run-up and overtopping rate. Further, measured wave run-up and overtopping rates are compared with the results given in the Shore Protection Manual (1984), Automated Coastal Engineering System (1992)and results of other investigators.     

A note on estimation of the Jacobian elliptic parameter in cnoidal wave theory

A new and simple calculating technique for the Jacobian elliptic parameter is presented in this study. The technique is very useful in generating a train of cnoidal waves in both laboratory and numerical wave tanks. Upon specification of water depth, the wave height and either the wave period or the wavelength, the proposed technique uses the Newton–Raphson method to estimate the Jacobian elliptic parameter directly, without trial and error procedures or look-up in tables. It is shown that the technique provides equally accurate results as the ad hoc methods previously used.