大亚湾水域两种拟菱形藻的形态学鉴定及毒素分析

对2005年分离自广东大亚湾的两种潜在产毒拟菱形藻进行了形态学观察和毒性分析.通过透射电子显微镜(TEM)观察确认藻种为细弱拟菱形藻(Pseudo-nitzschia cuspidata)和多纹拟菱形藻(P.multistriata).采用高效液相色谱法(HPLC)对这两种藻的常规培养样进行软骨藻酸毒素检测,结果均未检测到软骨藻酸.鉴于以上两种拟菱形藻存在着潜在产毒特性,不同培养条件的诱导实验尚需继续.     

Use of an optical oxygen sensor to measure dissolved oxygen in seawater

The use of an optical oxygen sensor to measure dissolved oxygen in seawater was investigated. The sensor is based on the dynamic quenching of an oxygen-sensitive fluorochrome embedded in the tip. Dissolved oxygen in seawater samples collected from eight stations at depths ranging from 3000 to 6000 m was analyzed both with the optical sensor and by the Winkler titration method. The two sets of data did not differ significantly. The stability and simplicity of the method and the good agreement of the results with those of the titration method indicate that the sensor would be useful for fieldwork.     

陀螺经纬仪的读数方法比较研究

介绍了陀螺定向测量中三种不同的数据采集方法，分析了各种方法的优缺点。作者认为传感器采集数据自动化程度高，精度高，特别是运用位置敏感探测器（PSD）采样数据量大，具有一定的抗干扰能力，但在运用传感器采样时必须注意克服非线性误差。     

Are invasive species most successful in habitats of low native species richness across European brackish water seas?

European brackish water seas (Baltic Sea, Black Sea and Sea of Azov, Caspian Sea) are subject to intense invasion of non-indigenous species (NIS). In these seas, salinity is the most important range limiting factor and native species seem to reach a minimum species richness at intermediate salinities. This trend, revealed by Remane in 1934 and later on confirmed by many other scientists, was compared to the salinity range of already established NIS in the European brackish water seas. It turned out that most NIS are well adapted to the salinities holding lowest native species richness, already in their native area, and that NIS richness maximum in brackish water seas occurs in the salinity intervals of native species richness minimum. A predictable pattern in the salinity range of NIS can be used as a tool in initial risk assessment of future invasions in brackish water seas, especially when mapping highly potential donor and recipient areas. A product of empty niches, suitable environmental conditions, and availability of proper vectors might be the most effective predictor for the invasibility of brackish water areas.     

添加纳米TiO2的氯醚树脂的XPS分析

在紫外线老化前后,利用光电子能谱(XPS)研究了分别添加金红石型和锐钛型纳米TiO2的氯醚树脂。研究发现,氯醚树脂中氯、氧元素具有表面富积现象——趋肤效应,而钛和碳元素在内层聚集;添加颜料粒子越小,在表面含量越大;金红石型纳米二氧化钛紫外屏蔽性好,减缓树脂老化;而锐钛型纳米二氧化钛具有显著的光催化活性,加速树脂老化。因此,金红石型纳米二氧化钛将是一种有前途的紫外线吸收剂。     

渤海区域地质信息管理系统数据库设计方案

数据库是GIS的基础。以渤海区域地质信息管理系统数据库为例，阐述了基于GIS的海洋地学管理信息系统中数据库的组织方法，及所包括空间数据库与属性数据库数据分类、分层方案，命名及编码规则，以及二者之间的联接。     

南海陆坡天然气水合物成藏的构造环境

南海是西太平洋最大的边缘海之一，其复杂的构造演化，形成了构造特征迥异的南海陆缘，有利于天然气水合物的发育，南海地区在中中新统以上发育了上中新统，上新统和第四系3套地层，3套地层所对应的地质时期的沉降速率在纵横向上的差别均较为悬殊，总体而言，南海第四纪整体沉降速率较大，为天然气水合物压力场环境的形成提供了有利条件，南海复杂的构造背景形成了丰富多彩的构造地质体，特定的构造地质体与水合物形成关系密切，这里讨论了滑塌体、泥底辟、增生楔等构造地质体在南海的分布情况，分析了上述构造体与气体水合物地震标志BSR之间的关系，以及特殊构造带在南海的展布规律，提出了特殊的造带中天然气水合物的成藏模式。     

Recorder-Dependent Temperature Error of Expendable Bathythermograph

The accuracy of temperature measurement by the expendable bathythermograph (XBT) is examined for five types of recorders by comparison with co-located CTD measurements and statistical analysis of temperature profiles including an isothermal layer. A positive temperature error increasing downward is occasionally detected for two types of Japanese recorder which have been commonly used among Japanese oceanographic institutions and marine observatories. This error resembles to that reported by Bailey et al. (1989) and Wright (1991) for a different type of recorders, although its cause is not clearly understood. The irregular occurrence of the error suggests that the problem is not solely due to the recorders but rather by some inconsistency of the whole measuring system including them, an XBT probe and sea water. The error is estimated to increase at a rate of O (0.1°C/100 m), and it could be close to 1°C at the deepest part of the profiles (760 m for Tsurumi T-7). This revised version was published online in July 2006 with corrections to the Cover Date.     

Second-Order Wave Diffraction Around 3-D Bodies by A Time-Domain Method

A time-domain method is applied to simulate nonlinear wave diffraction around a surface piercing 3-D arbitrary body. The method involves the application of Taylor series expansions and the use of perturbation procedure to establish the corresponding boundary value problems with respect to a time-independent fluid domain. A boundary element method based on B-spline expansion is used to calculate the wave field at each time step, and the free surface boundary condition is satisfied to the second order of wave steepness by a numerical integration in time. An artificial damping layer is adopted on the free surface for the removal of wave reflection from the outer boundary. As an illustration, the method is used to compute the second-order wave forces and run-up on a surface-piercing circular cylinder. The present method is found to be accurate, computationally efficient, and numerically stable.