滑坡治理中格构锚固结构的解析解分析

在分析格构锚固结构受力的基础上 ,将格构梁简化为受集中力作用的弹性地基上的梁 ,提出了格构锚固结构的力学模型 ,利用 Winkler弹性地基上梁的解析解对格构梁进行了内力和变形的分析 ,发现格构梁的受力状况受弹性特征λ、梁格间距 ls以及悬臂长度影响 ;建议梁长 l与λ宜满足 lλ≥ 2π;采用较小间距的格构梁以及小吨位锚索 ,间距宜满足 lsλ<π/ 2 ,悬臂长度取 (0 .3～ 0 .5 ) ls,并将分析结论应用于三峡库区巴东太矶头东滑坡治理工程的设计中     

大别造山带地壳泊松比结构与超高压变质带—来自宽角反射与近垂直反射剖面的启示

综合宽角反射、近垂直反射的探测结果和有关地质资料，对大别造山带地壳结构和超高压变质带研究显示：大别造山带地壳具有层块结构特征。沿安义－庄墓剖面，上地壳有7个弹性块体，中地壳有5个，下地壳有4个。扬子与华北地块的主缝合带是超高压变质带，扬子地块与大别造山带的现今分界线是与郯庐断裂相交的太湖－马庙断裂，磨子潭－晓天断裂是大别造山带的北界，北淮阳构造带呈楔状向下插入，它与华北地块的分界是肥中断裂。郯庐断裂在中、上地壳近于直立，下地壳向西倾斜。超高压变质带的厚度为5－7km，产状向北插入到北大别块体之下，折返过程是构造就位，不是大别山的均匀抬升，折返的主运动面是水吼－五河高温剪切带。     

Numerical evaluation of the damping‐solvent extraction method in the frequency domain

The damping‐solvent extraction method for the analysis of unbounded visco‐elastic media is evaluated numerically in the frequency domain in order to investigate the influence of the computational parameters—domain size, amount of artificial damping, and mesh density—on the accuracy of results. An analytical estimate of this influence is presented, and specific questions regarding the influence of the parameters on the results are answered using the analytical estimate and numerical results for two classical problems: the rigid strip and rigid disc footings on a visco‐elastic half‐space with constant hysteretic material damping. As the domain size is increased, the results become more accurate only at lower frequencies, but are essentially unaffected at higher frequencies. Choosing the domain size to ensure that the static stiffness is computed accurately leads to an unnecessarily large domain for analysis at higher frequencies. The results improve by increasing artificial damping but at a slower rate as the total (material plus artificial) damping ratio ζ_t gets closer to 0.866. However, the results do not deteriorate significantly for the larger amounts of artificial damping, suggesting that ζ_t≈0.6 is appropriate; a larger value is not likely to influence the accuracy of results. Presented results do not support the earlier suggestion that similar accuracy can be achieved by a large bounded domain with small damping or by a small domain with larger damping. Copyright © 2002 John Wiley & Sons, Ltd.     

Damaging properties of ground motions and prediction of maximum response of structures based on momentary energy response

Dynamic damaging potential of ground motions must be evaluated by the response behaviour of structures, and it is necessary to indicate what properties of ground motions are most appropriate for evaluation. For that purpose, the behaviour of energy input process and hysteretic energy dissipation are investigated in this study. It is found that the momentary input energy that is an index for the intensity of input energy is related to the characteristics of earthquakes such as cyclic or impulsive, and to the response displacement of structures immediately. On the basis of these results, a procedure is proposed to predict inelastic response displacement of structures by corresponding earthquake input energy to structural dissipated damping and hysteretic energy. In this procedure the earthquake response of structures is recognized as an input and dissipation process of energy, and therefore structural properties and damaging properties of ground motions can be taken into account more generally. Lastly, the studies of the pseudodynamic loading test of reinforced concrete structure specimens subjected to ground motions with different time duration are shown. The purpose of this test is to estimate the damaging properties of ground motions and the accuracy of the proposed prediction procedure. Copyright © 2002 John Wiley & Sons, Ltd.     

裂隙型单斜介质中弹性系数的计算及波的传播特性研究

根据Hudson等关于裂隙介质弹性系数计算的扰动理论及Bond变换矩阵原理，给出了各向同性介质中含多组垂直裂隙时等效弹性系数的计算方法。计算了含两组斜交的垂直裂隙形成的单斜各向异性介质中的等效弹性系数，并根据Christoffel方程推导、得出水平面内平面波传播的相速度和群速度随方位变化的特性。     

H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。     

A non-linear stress-stiffness model for geomaterials at small to intermediate strains

A double exponential fitting model (DEFM) capable of expressing the non-linear stress-stiffness relationship of geomaterials has been proposed by Shibuya et al. (1997). The model comprises two material constants; the elastic stiffness at very small strains and the strength, together with other free parameters to determine the complete stress-stiffness relationship. In this paper, the capability of the original function used for DEFM in simulating the tangent stiffness-stress relationship of geomaterials is first discussed. Second, the methods for determining the free model parameters, as well as its conversion to obtain a stress-strain relationship are proposed. The applicability of DEFM to predicting non-linear stress-stiffness relationship is examined in detail in a total of forty-nine fitting cases of compression test data on sedimentary rock, artificial soft rock and soft clay. It is found that the DEFM is effective in expressing the non-linear stress-stiffness relationship of various kinds of geomaterials at small to intermediate strains, say less than 0.5%. The superiority of this model compared to other fitting models currently in use is also demonstrated in some of the fitting cases.     

Groundwater-flow modeling in the Yucatan karstic aquifer, Mexico

The current conceptual model of the unconfined karstic aquifer in the Yucatan Peninsula, Mexico, is that a fresh-water lens floats above denser saline water that penetrates more than 40 km inland. The transmissivity of the aquifer is very high so the hydraulic gradient is very low, ranging from 7–10 mm/km through most of the northern part of the peninsula. The computer modeling program AQUIFER was used to investigate the regional groundwater flow in the aquifer. The karstified zone was modeled using the assumption that it acts hydraulically similar to a granular, porous medium. As part of the calibration, the following hypotheses were tested: (1) karstic features play an important role in the groundwater-flow system; (2) a ring or belt of sinkholes in the area is a manifestation of a zone of high transmissivity that facilitates the channeling of groundwater toward the Gulf of Mexico; and (3) the geologic features in the southern part of Yucatan influence the groundwater-flow system. The model shows that the Sierrita de Ticul fault, in the southwestern part of the study area, acts as a flow barrier and head values decline toward the northeast. The modeling also shows that the regional flow-system dynamics have not been altered despite the large number of pumping wells because the volume of water pumped is small compared with the volume of recharge, and the well-developed karst system of the region has a very high hydraulic conductivity. Electronic Publication     

An automated strategy for calculation of phase diagram sections and retrieval of rock properties as a function of physical conditions

We formulate an algorithm for the calculation of stable phase relations of a system with constrained bulk composition as a function of its environmental variables. The basis of this algorithm is the approximate representation of the free energy composition surfaces of solution phases by inscribed polyhedra. This representation leads to discretization of high variance phase fields into a continuous mesh of smaller polygonal fields within which the composition and physical properties of the phases are uniquely determined. The resulting phase diagram sections are useful for understanding the phase relations of complex metamorphic systems and for applications in which it is necessary to establish the variations in rock properties such as density, seismic velocities and volatile‐content through a metamorphic cycle. The algorithm has been implemented within a computer program that is general with respect to both the choice of variables and the number of components and phases possible in a system, and is independent of the structure of the equations of state used to describe the phases of the system.     

A scanning electron microscope study of the effects of dynamic recrystallization on lattice preferred orientation in olivine

Effects of dynamic recrystallization on lattice preferred orientation (LPO) in olivine were investigated through the combination of two SEM-based techniques, electron backscattered diffraction (EBSD) technique for crystallographic orientation measurement and backscattered electron imaging (BEI) for dislocation observation. Samples are experimentally deformed olivine aggregates in simple shear geometry. In the sample deformed at T=1473 K and high stresses (480 MPa), only incipient dynamic recrystallization is observed along grain-boundaries. Orientations of these small recrystallized grains are more random than that of relict grains, suggesting an important role of grain-boundary sliding at this stage of recrystallization. In the sample deformed at T=1573 K and low stress (160 MPa), dynamic recrystallization is nearly complete and the LPO is characterized by two [100] peaks. One peak is located at the orientation subparallel to the shear direction and is dominated by grains with high Schmid factor. The other occurs at high angles to the shear direction and is due to the contribution from grains with low Schmid factor. Grains with high Schmid factor tend to have higher dislocation densities than those with low Schmid factor. Based on these observations, we identify two mechanisms by which dynamic recrystallization affects LPO: (1) enhancement of grain-boundary sliding due to grain-size reduction, leading to the modification of LPO caused by the relaxation of constraint for deformation; (2) grain-boundary migration by which grains with lower dislocation densities grow at the expense of grains with higher dislocation densities. Based on the deformation mechanism maps and stress versus recrystallized grain-size relation, we suggest that the first mechanism always plays an important role whereas the second mechanism has an important effect only under limited conditions.