An alternative approach to the structural motion analysis of wedge-beam offshore structures supporting a load

For convenience of dynamic analysis, some offshore structures such as fixed-type platforms are often modeled as the wedge beams supporting tip lumped masses. It is well-known that, due to the effect of the surrounding water, the natural frequencies of a beam in air (or dry beam) are different from those of the same beam immersed in water (or wet beam). However, if the natural frequencies and the associated mode shapes of a dry beam are calculated by taking account of the “added mass” for the immersed beam, then the last natural frequencies and mode shapes will be equal to the corresponding ones of the wet beam. Based on the last concept, the closed form solutions for natural frequencies and the associated mode shapes of the dry beam were determined first, then the partial differential equation of motion for the wet beam was transformed into a matrix equation by using the expansion theorem and the foregoing closed form solutions of free vibration responses for the dry beam. Solving the last matrix equation will give the required natural frequencies and the associated mode shapes of the wet beam. The formulation of this paper is available for the fully or partially immersed double tapered beams with either circular, square or rectangular cross-sections. The taper ratio for width and that for depth may be equal or unequal. The numerical results of this paper were compared with the existing results or the finite-element-method results and good agreement was achieved.     

Three‐dimensional simulation of tsunami run‐up around conical island

At the circular Babi Island in the Flores tsunami (1992) and pear shaped island in the Okushiri event (1993), unexpectedly large tsunami run‐up heights in the lee of conic islands were observed. The flume and basin physical model studies were conducted in the Coastal Hydraulic Laboratory, Engineering Research and Development Center, U.S. Army Corps of Engineers to provide a better understanding of the physical phenomena and verify numerical models used in predicting tsunami wave run‐up on beaches, islands, and vertical walls. Reasonably accurate comparison of run‐up height of solitary waves on a circular island has been obtained between laboratory experimental results and two‐dimensional computation model results. In this study we apply three‐dimensional RANS model to simulate wave run‐up on conical island. In the run‐up computation we obtain that 3D calculations are in very good comparison with laboratory and 2D numerical results. A close examination of the three‐dimensional velocity distribution around conical island to compare with depth‐integrated model is performed. It is shown that the velocity distribution along the vertical coordinate is not uniform: and velocity field is weaker in the bottom layer and higher on the sea surface. The maximum difference (about 40%) appears at the time when solitary wave reached the circular island.     

空间数据重复记录的清理方法研究

在空间数据的更新过程中,需要利用多种数据源对现有数据进行更新,这样可能会导致在获得的空间数据中出现重复记录。利用计算机自动对这些重复记录进行检查处理,将会极大地降低数据生产者的工作量。本文根据在数字制图系统研制过程中所遇到的此类问题,提出了对重复空间数据进行检查与处理的方法,并在所研制的数字制图系统中得到了应用。     

Rare Earth Deposits of North America

Rare earth elements (REE) have been mined in North America since 1885, when placer monazite was produced in the southeast USA. Since the 1960s, however, most North American REE have come from a carbonatite deposit at Mountain Pass, California, and most of the world’s REE came from this source between 1965 and 1995. After 1998, Mountain Pass REE sales declined substantially due to competition from China and to environmental constraints. REE are presently not mined at Mountain Pass, and shipments were made from stockpiles in recent years. Chevron Mining, however, restarted extraction of selected REE at Mountain Pass in 2007. In 1987, Mountain Pass reserves were calculated at 29 Mt of ore with 8.9% rare earth oxide based on a 5% cut‐off grade. Current reserves are in excess of 20 Mt at similar grade. The ore mineral is bastnasite, and the ore has high light REE/heavy REE (LREE/HREE). The carbonatite is a moderately dipping, tabular 1.4‐Ga intrusive body associated with ultrapotassic alkaline plutons of similar age. The chemistry and ultrapotassic alkaline association of the Mountain Pass deposit suggest a different source than that of most other carbonatites. Elsewhere in the western USA, carbonatites have been proposed as possible REE sources. Large but low‐grade LREE resources are in carbonatite in Colorado and Wyoming. Carbonatite complexes in Canada contain only minor REE resources. Other types of hard‐rock REE deposits in the USA include small iron‐REE deposits in Missouri and New York, and vein deposits in Idaho. Phosphorite and fluorite deposits in the USA also contain minor REE resources. The most recently discovered REE deposit in North America is the Hoidas Lake vein deposit, Saskatchewan, a small but incompletely evaluated resource. Neogene North American placer monazite resources, both marine and continental, are small or in environmentally sensitive areas, and thus unlikely to be mined. Paleoplacer deposits also contain minor resources. Possible future uranium mining of Precambrian conglomerates in the Elliott Lake–Blind River district, Canada, could yield by‐product HREE and Y. REE deposits occur in peralkaline syenitic and granitic rocks in several places in North America. These deposits are typically enriched in HREE, Y, and Zr. Some also have associated Be, Nb, and Ta. The largest such deposits are at Thor Lake and Strange Lake in Canada. A eudialyte syenite deposit at Pajarito Mountain in New Mexico is also probably large, but of lower grade. Similar deposits occur at Kipawa Lake and Lackner Lake in Canada. Future uses of some REE commodities are expected to increase, and growth is likely for REE in new technologies. World reserves, however, are probably sufficient to meet international demand for most REE commodities well into the 21st century. Recent experience shows that Chinese producers are capable of large amounts of REE production, keeping prices low. Most refined REE prices are now at approximately 50% of the 1980s price levels, but there has been recent upward price movement for some REE compounds following Chinese restriction of exports. Because of its grade, size, and relatively simple metallurgy, the Mountain Pass deposit remains North America’s best source of LREE. The future of REE production at Mountain Pass is mostly dependent on REE price levels and on domestic REE marketing potential. The development of new REE deposits in North America is unlikely in the near future. Undeveloped deposits with the most potential are probably large, low‐grade deposits in peralkaline igneous rocks. Competition with established Chinese HREE and Y sources and a developing Australian deposit will be a factor.     

Zircon M257 ‐ a Homogeneous Natural Reference Material for the Ion Microprobe U‐Pb Analysis of Zircon

We introduce and propose zircon M257 as a future reference material for the determination of zircon U‐Pb ages by means of secondary ion mass spectrometry. This light brownish, flawless, cut gemstone specimen from Sri Lanka weighed 5.14 g (25.7 carats). Zircon M257 has TIMS‐determined, mean isotopic ratios (2s uncertainties) of 0.09100 ± 0.00003 for ²⁰⁶pb/²³⁸U and 0.7392 ± 0.0003 for ²⁰⁷pb/²³⁵U. Its ²⁰⁶pb/²³⁸U age is 561.3 ± 0.3 Ma (unweighted mean, uncertainty quoted at the 95% confidence level); the U‐Pb system is concordant within uncertainty of decay constants. Zircon M257 contains ～ 840 μg g^?1 U (Th/U ～ 0.27). The material exhibits remarkably low heterogeneity, with a virtual absence of any internal textures even in cathodoluminescence images. The uniform, moderate degree of radiation damage (estimated from the expansion of unit‐cell parameters, broadening of Raman spectral parameters and density) corresponds well, within the “Sri Lankan trends”, with actinide concentrations, U‐Pb age, and the calculated alpha fluence of 1.66 × 10¹⁸ g^?1. This, and a (U+Th)/He age of 419 ± 9 Ma (2s), enables us to exclude any unusual thermal history or heat treatment, which could potentially have affected the retention of radiogenic Pb. The oxygen isotope ratio of this zircon is 13.9%o VSMOW suggesting a metamorphic genesis in a marble or calc‐silicate skarn.     

Passage time, viability, and germination of seeds ingested by foxes

Seed passage through the gut of vertebrates is critical for endozoochorus seed dispersal because it may influence seed viability and germination capacity. Foxes are important fruit-eaters and presumed seed dispersers in the Chaco ecoregion. We experimentally assessed the seed passage time (SPT) and its effect on seed viability and germination in two fox species (Pseudalopex gymnocercus and Cerdocyon thous) that occur in the Chaco. Passage time was measured using both artificial seeds of three sizes and wild seeds of four native fleshy-fruit species commonly consumed by foxes (Ziziphus mistol, Acacia aroma, Celtis tala, and Syagrus romanzoffiana). The average SPT was 6.8 h for the Pampa fox and 7.7 h for the crab-eating fox. Passage time did not differ either among seeds of different sizes or between fox species. Passage through digestive tract of both fox species did not affect seed survival, whereas germination rate was slightly improved. Our data suggest that both fox species are legitimate seed dispersers of the four species studied, having a positive effect on both germination rate and dispersal distance from the parent plant.     

Unequal Competition Among Chains of Supercenters: Kmart,Target, and Wal‐Mart

The three largest discount chains, Kmart, Target, and Wal‐Mart, have adopted the supercenter format for expansion. This article examines the locations of and the competition among these supercenters. Wal‐Mart has the greatest number of supercenters and is driving the expansion of the supercenter format. Both Kmart and Target have clustered their supercenters in a small number of metropolitan markets. In contrast to Wal‐Mart and Kmart, Target has focused on a middle‐class rather than a blue‐collar clientele. Now Kmart is struggling following a declaration of bankruptcy. Wal‐Mart has largely defeated its supercenter competitors and now is confronting the major grocery chains for grocery sales.     

Construction techniques for the Taklamakan Desert Highway: research on the construction materials and the results of field tests

After conducting many laboratory and field experiments, several key technical issues related to the construction of China’s Taklamakan Desert Highway have been satisfactorily resolved. In particular, considerable progress has been made on the dry compaction of a sand sub-base, road design parameters, the creation of a structure that combines a sub-grade and asphalt pavement, analysis of the stability of a sand sub-base strengthened with geotextiles, and on the development of a complete set of construction techniques. The achievements of this research were successfully applied for the first time in the Taklamakan Desert, where the environmental conditions are extremely harsh. The results suggest that the construction of this highway was economical and that the simple construction methods produced a reliable highway. The resulting highway is believed to be the world’s first long-distance graded highway running through a huge desert with migrating dunes.     

Application of membrane technology for water treatment： Ultrasound-associated cleaning of fouled microfiltration membranes

The use of membranes is a widely employed, versatile, and effective separation process. One of the limiting aspects in applying microfiltration （MF） for wastewater treatment is that of problems with membrane fouling and consequent flux reduction. Membrane fouling occurs by the irreversible deposition of retained particles, colloids, macromolecules, salts, etc. at the membrane surface and/or inside the membrane. The predominant fouling mechanisms observed with MF membranes are classified as three categories： the build-up of a cake layer on the membrane surface, blocking of membrane pores, and adsorption of fouling material on the membrane surface or in the pore walls. Although many techniques have been developed to overcome fouling, studies on membrane cleaning still seem to be insufficient for practical membrane filtration systems. Current membrane cleaning technologies include hydraulic, chemical, and mechanical methods. Ultrasound （US） has been widely used as a method of cleaning materials because of the cavitation phenomenon. In this study, US cleaning technique was applied to removing the fouling of polyvinglidenefluoride （PVDF） MF membrane, which was used to treat yeast cell and isolated soybean protein （ISP） solution, respectively. The US employed 40 kHz frequency and the output power of 1.43-2.85 W/cm^2. The evolution of the cleaning effect is followed by the measurements of the flux recovery rate （FRstat） and the cleaning time cycle. Results showed that the membrane property, which was fouled by yeast cell solution, could be recovered by water cleaning with US irradiation. And the cleaning time with the same FRstat decreased with the increase of US intensity.